- 您現在的位置：買賣IC網 > PDF目錄295878 > EL7642AILTZ-T13 (INTERSIL CORP) TFT-LCD DC/DC with Integrated Amplifiers PDF資料下載
參數資料
| 型號： | EL7642AILTZ-T13 |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | TFT-LCD DC/DC with Integrated Amplifiers |
| 中文描述： | 0.15 A SWITCHING REGULATOR, 1350 kHz SWITCHING FREQ-MAX, QCC32 |
| 封裝： | 5 X 5 MM, ROHS COMPLIANT, MO-220, QFN-32 |
| 文件頁數： | 4/19頁 |
| 文件大?。?/td> | 458K |
| 代理商： | EL7642AILTZ-T13 |
12
FN6270.0
May 15, 2006
The following table gives typical values (margins are
considered 10%, 3%, 20%, 10% and 15% on VIN, VO, L, fS
and ILMT:
Input Capacitor
The input capacitor is used to supply the current to the
converter. It is recommended that CIN be larger than 10F.
The reflected ripple voltage will be smaller with larger CIN.
The voltage rating of input capacitor should be larger than
maximum input voltage.
Boost Inductor
The boost inductor is a critical part which influences the
output voltage ripple, transient response, and efficiency.
Value of 3.3
H to 10H inductor is recommended in
applications to fit the internal slope compensation. The
inductor must be able to handle the following average and
peak current:
Rectifier Diode
A high-speed diode is desired due to the high switching
frequency. Schottky diodes are recommended because of
their fast recovery time and low forward voltage. The rectifier
diode must meet the output current and peak inductor
current requirements.
Output Capacitor
The output capacitor supplies the load directly and reduces
the ripple voltage at the output. Output ripple voltage
consists of two components: the voltage drop due to the
inductor ripple current flowing through the ESR of output
capacitor, and the charging and discharging of the output
capacitor.
For low ESR ceramic capacitors, the output ripple is
dominated by the charging and discharging of the output
capacitor. The voltage rating of the output capacitor should
be greater than the maximum output voltage.
NOTE: Capacitors have a voltage coefficient that makes their
effective capacitance drop as the voltage across them increases.
COUT in the equation above assumes the effective value of the
capacitor at a particular voltage and not the manufacturer’s stated
value, measured at zero volts.
Compensation
The EL7640A, EL7641A, EL7642A can operate in either P
mode or PI mode. Connecting COMP pin directly to VIN will
enable P mode; For better load regulation, use PI mode with
a 2.2nF capacitor and a 180
resistor in series between
COMP pin and ground. To improve the transient response,
either the resistor value can be increased or the capacitor
value can be reduced, but too high resistor value or too low
capacitor value will reduce loop stability.
Boost Feedback Resistors
As the boost output voltage, VBOOST, is reduced below 12V
the effective voltage feedback in the IC increases the ratio of
voltage to current feedback at the summing comparator
because R2 decreases relative to R1. To maintain stable
operation over the complete current range of the IC, the
voltage feedback to the FBB pin should be reduced
proportionally, as VBOOST is reduced, by means of a series
resistor-capacitor network (R7 and C7) in parallel with R1,
with a pole frequency (fp) set to approximately 10kHz. for C2
effective = 10F and 4kHz for C2 (effective) = 30F.
R7 = ((1/0.1 x R2) – 1/R1)^-1
C7 = 1/(2 x 3.142 x fp x R7)
Linear-Regulator Controllers (VON and VOFF)
The EL7640A, EL7641A, EL7642A include 2 independent
linear-regulator controllers, in which there is one positive
output voltage (VON), and one negative voltage (VOFF). The
VON and VOFF linear-regulator controller function diagram,
application circuit and waveforms are shown in Figure 19
and Figure 20 respectively.
TABLE 2.
VIN (V)
VO (V)
L (H)
fS (MHz)
IOMAX (mA)
3.3
9
6.8
1.2
898
3.3
12
6.8
1.2
622
3.3
15
6.8
1.2
458
5
9
6.8
1.2
1360
512
6.8
1.2
944
515
6.8
1.2
694
ILAVG
IO
1D
–
-------------
=
ILPK
ILAVG
IL
2
--------
+
=
VRIPPLE
ILPK ESR
VO VIN
–
VO
------------------------
IO
COUT
----------------
1
fS
-----
×
+
×
=
EL7640A, EL7641A, EL7642A
相關PDF資料 |
PDF描述 |
|---|---|
| EL7642AILTZ-T7 | TFT-LCD DC/DC with Integrated Amplifiers |
| EL7900ILCZ-T7 | Ambient Light Photo Detect IC |
| EL8170IS | microPower, Single-Supply, CMOS Instrumentation Amplifier |
| ELEKE222JA | 1 ELEMENT, 2200 uH, GENERAL PURPOSE INDUCTOR |
| ELEKN183KA | 1 ELEMENT, 18000 uH, GENERAL PURPOSE INDUCTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL7642AILTZ-T7 | 功能描述:LCD 驅動器 EL7642AILTZ TFT-LCD DC-DC W/INTEGRTD AMP RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| EL7642ILTZ | 功能描述:直流/直流開關調節器 EL7642ILZ TFT-LCD DC -DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| EL7642ILTZ-T13 | 功能描述:直流/直流開關調節器 EL7642ILTZ TFT-LCD D C-DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| EL7642ILTZ-T7 | 功能描述:直流/直流開關調節器 EL7642ILTZ TFT-LCD D C-DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| EL7661CN | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IC-100V FULL BRIDGE DRIVER |
發布緊急采購，3分鐘左右您將得到回復。