- 您現在的位置：買賣IC網 > PDF目錄362693 > EM94015 (ELAN Microelctronics Corp .) Dual Channel Cordless Phone Controllers with Handset LCD Display(雙通道無繩電話控制器（帶手機LCD顯示）) PDF資料下載
參數資料
| 型號： | EM94015 |
| 廠商： | ELAN Microelctronics Corp . |
| 英文描述： | Dual Channel Cordless Phone Controllers with Handset LCD Display(雙通道無繩電話控制器（帶手機LCD顯示）) |
| 中文描述： | 雙通道控制器無繩電話與手機液晶顯示器（雙通道無繩電話控制器（帶手機液晶顯示）） |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 135K |
| 代理商： | EM94015 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
* This specification are subject to be changed without notice.
4
1.30.1997
EM94014/EM94015
DUAL CHANNEL CORDLESS PHONE CONTROLLERS
WITH HANDSET LCD DISPLAY
Symbol
/INUSE
I/O Active
O
(O.D.)
O
(O.D.)
Function
Low output to indicates in-use, ringing or low battery.
High output for standby and off mode. It can sink one LED directly.
Generate ringing, paging, warning, key tones, etc.
L
/BEEP
L
BASE UNIT(EM94015)
Symbol
XIN,XOUT
/RESET
I/O Active
I,O
I
(O.D.)
Function
-
L
4MHz crystal connection. Recommend two 10pF capacitors connected to V
SS
.
System reset input.
Low input to this pin resets the controller. The system reset can be done when
the first time power up or putting the handset on the charge cradle. To reset the
controller, a minimum of 10ms low pulse is required. If the handset battery is to
be changed, a low signal should be detected at /POWDN pin that forces the
controller to enter sleep mode. But the /RESET pin should be kept high with
power back up circuit in order to maintain the controller memory. /RESET pin
should be pulled high whereas in-use or standby mode to conserve power.
DC power +/- connection pin. Recommend a 0.1uF decouple capacitor connected.
Operating voltage ranges from 2.4V - 5.5V.
This pin is reserved for IC fabrication test purpose. It must be connected to V
SS
.
Low input for power down mode and high input for normal operation.
Low input indicates Paging/Intercom key is pressed. Normal in high state.
Flash Time Selection Input
Low input for 100ms flash time and high input for 600ms flash time.
Carrier detect input.
This pin senses the RF carrier of the air-link. It functions when the /TXEN=low
which implies that air-link ready between handset and base unit. If it detects no RF
carrier (CDI input low) for more than 32 seconds, the base unit returns to standby
automatically.
Ringing signal envelope input.
It detects the envelope of incoming ring whether a ring is present or not.
Low input for ringing and high input for no ring.
Tone Pulse Selection Input
Low input for tone dialing and high input for pulse dialing.
Make / Break Ratio Selection Input
Low input for 2:3 M/B ratio and high input for 1:2 M/B ratio.
Pulse Per Second Selection Input
Low input for 10 PPS pulse rate dialing and high input for 20 PPS pulse rate dialing.
To change the channels of air-linkage.
CH=low indicates CH=2 and CH=high indicates CH=1.
At the first time of power up or the handset is left from the charged cradle, CH=1.
(default channel)
High output for tone/pulse dialing mute.
V
DD
,V
SS
-
-
TEST
/POWDN
PAG/INT
FTS
I
I
I
I
-
L
L
-
CDI
I
H
/RSD
I
L
T/P
I
-
M/B
I
-
PPS
I
-
CH
O
-
(O.D.)
TPMUT
O
H
(O.D.)
O
(P.P.)
O
(O.D.)
PULSE
-
Line connection pin and pulse dialing output pin.
/TXEN
L
RF transmitter power control output.
The RF transmitter power can be controlled by this pin. It outputs high signal to
RF transmitter in stand-by mode and sends low signal in in-use mode.
相關PDF資料 |
PDF描述 |
|---|---|
| EM94014 | Dual Channel Cordless Phone Controllers with Handset LCD Display(雙通道無繩電話控制器（帶手機LCD顯示）) |
| EM95110 | 16-Digital LCD Phone Controller with Calculator(帶計算器功能的16位液晶顯示電話控制器) |
| EM95120(中文) | 16-Digital LCD Phone Controller with Calculator(帶商用8位計算器功能的16位液晶顯示電話控制器) |
| EM95120 | 16-Digital LCD Phone Controller with Calculator(帶商用8位計算器功能的16位液晶顯示電話控制器) |
| EMBEDDED INTEL486 SX | Embedded INTEL486 SX Processor(嵌入式INTEL486 SX處理器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EM9445 | 制造商:SOBERTON 制造商全稱:SOBERTON 功能描述:Omnidirectional Electret Condenser Microphone |
| EM9445P | 制造商:SOBERTON 制造商全稱:SOBERTON 功能描述:Omnidirectional Electret Condenser Microphone |
| EM9465-442 | 功能描述:MICROPHONE OMNI DIRECT 9.4X6.5MM RoHS:否 類別:音頻產品 >> 麥克風 系列:- 產品目錄繪圖:SPM04xxHx(5,xH)-xB SP Series_FTPRNT-5 標準包裝:1 系列:SiSonic™ 類型:MEMS（硅） 輸出類型:模擬 方向:全向 頻率范圍:100Hz ~ 10kHz 靈敏度:-42dB ±3dB 信噪比:59dB 阻抗:100 歐姆 電壓 - 額定:1.5 ~ 3.6V 電流 - 電源:250µA 端口位置:頂部 密封等級:無 端子:表面貼裝型 尺寸/尺寸:4.72mm L x 3.76mm W 高度（最大）:1.35mm 形狀:矩形 包裝:Digi-Reel® 產品目錄頁面:2669 (CN2011-ZH PDF) 其它名稱:423-1131-6 |
| EM9465-442-G | 功能描述:MICROPHONE OMNI DIRECT 9.4X6.5MM RoHS:是 類別:音頻產品 >> 麥克風 系列:- 產品目錄繪圖:SPM04xxHx(5,xH)-xB SP Series_FTPRNT-5 標準包裝:1 系列:SiSonic™ 類型:MEMS（硅） 輸出類型:模擬 方向:全向 頻率范圍:100Hz ~ 10kHz 靈敏度:-42dB ±3dB 信噪比:59dB 阻抗:100 歐姆 電壓 - 額定:1.5 ~ 3.6V 電流 - 電源:250µA 端口位置:頂部 密封等級:無 端子:表面貼裝型 尺寸/尺寸:4.72mm L x 3.76mm W 高度（最大）:1.35mm 形狀:矩形 包裝:Digi-Reel® 產品目錄頁面:2669 (CN2011-ZH PDF) 其它名稱:423-1131-6 |
| EM9465P-442 | 功能描述:MICROPHONE OMNI DIRECT 9.4X6.5MM RoHS:否 類別:音頻產品 >> 麥克風 系列:- 產品目錄繪圖:SPM04xxHx(5,xH)-xB SP Series_FTPRNT-5 標準包裝:1 系列:SiSonic™ 類型:MEMS（硅） 輸出類型:模擬 方向:全向 頻率范圍:100Hz ~ 10kHz 靈敏度:-42dB ±3dB 信噪比:59dB 阻抗:100 歐姆 電壓 - 額定:1.5 ~ 3.6V 電流 - 電源:250µA 端口位置:頂部 密封等級:無 端子:表面貼裝型 尺寸/尺寸:4.72mm L x 3.76mm W 高度（最大）:1.35mm 形狀:矩形 包裝:Digi-Reel® 產品目錄頁面:2669 (CN2011-ZH PDF) 其它名稱:423-1131-6 |
發布緊急采購，3分鐘左右您將得到回復。