參數資料
型號: EP2AGX45CU17C5
廠商: Altera
文件頁數: 35/90頁
文件大小: 0K
描述: IC ARRIA II GX FPGA 45K 358UBGA
產品培訓模塊: Three Reasons to Use FPGA's in Industrial Designs
標準包裝: 6
系列: Arria II GX
LAB/CLB數: 1805
邏輯元件/單元數: 42959
RAM 位總計: 3517440
輸入/輸出數: 156
電源電壓: 0.87 V ~ 0.93 V
安裝類型: 表面貼裝
工作溫度: 0°C ~ 85°C
封裝/外殼: 358-UBGA
供應商設備封裝: 358-UBGA
1–32
Chapter 1: Device Datasheet for Arria II Devices
Switching Characteristics
December 2013
Altera Corporation
-3 dB Bandwidth
PCIe Gen1
2.5 - 3.5
MHz
PCIe Gen2
6 - 8
MHz
(OIF) CEI PHY at
4.976 Gbps
7 - 11
MHz
(OIF) CEI PHY at
6.375 Gbps
5 - 10
MHz
XAUI
2 - 4
MHz
SRIO 1.25 Gbps
3 - 5.5
MHz
SRIO 2.5 Gbps
3 - 5.5
MHz
SRIO 3.125 Gbps
2 - 4
MHz
GIGE
2.5 - 4.5
MHz
SONET OC12
1.5 - 2.5
MHz
SONET OC48
3.5 - 6
MHz
Transceiver-FPGA Fabric Interface
Interface speed
25
325
25
250
MHz
Digital reset pulse width
Minimum is two parallel clock cycles
Notes to Table 1–35:
(1) The 3x speed grade is the fastest speed grade offered in the following Arria II GZ devices: EP2AGZ225, EP2AGZ300, and EP2AGZ350.
(2) The rise and fall time transition is specified from 20% to 80%.
(3) To calculate the REFCLK rms phase jitter requirement at reference clock frequencies other than 100 MHz, use the following formula:
REFCLK rms phase jitter at f (MHz) = REFCLK rms phase jitter at 100 MHz * 100/f.
(4) The minimum reconfig_clk frequency is 2.5 MHz if the transceiver channel is configured in Transmitter only mode. The minimum
reconfig_clk
frequency is 37.5 MHz if the transceiver channel is configured in Receiver only or Receiver and Transmitter mode.
(5) If your design uses more than one dynamic reconfiguration controller (altgx_reconfig) instances to control the transceiver (altgx)
channels physically located on the same side of the device AND if you use different reconfig_clk sources for these altgx_reconfig
instances, the delta time between any two of these reconfig_clk sources becoming stable must not exceed the maximum specification listed.
(6) The device cannot tolerate prolonged operation at this absolute maximum.
(7) You must use the 1.1-V RX VICM setting if the input serial data standard is LVDS.
(8) The differential eye opening specification at the receiver input pins assumes that Receiver Equalization is disabled. If you enable Receiver
Equalization, the receiver circuitry can tolerate a lower minimum eye opening, depending on the equalization level. Use H-Spice simulation to
derive the minimum eye opening requirement with Receiver Equalization enabled.
(9) The rate matcher supports only up to
± 300 ppm.
(10) Time taken to rx_pll_locked goes high from rx_analogreset de-assertion. Refer to Figure 1–1 on page 1–33.
(11) Time for which the CDR must be kept in lock-to-reference mode after rx_pll_locked goes high and before rx_locktodata is asserted in
manual mode. Refer to Figure 1–1 on page 1–33.
(12) Time taken to recover valid data after the rx_locktodata signal is asserted in manual mode. Refer to Figure 1–1 on page 1–33.
(13) Time taken to recover valid data after the rx_freqlocked signal goes high in automatic mode. Refer to Figure 1–2 on page 1–33.
(14) A GPLL may be required to meet the PMA-FPGA fabric interface timing above certain data rates. For more information, refer to the Transceiver
(15) The Quartus II software automatically selects the appropriate slew rate depending on the configured data rate or functional mode.
(16) To support data rates lower than the minimum specification through oversampling, use the CDR in LTR mode only.
Table 1–35. Transceiver Specifications for Arria II GZ Devices (Part 5 of 5)
Symbol/
Description
Conditions
–C3 and –I3 (1)
–C4 and –I4
Unit
Min
Typ
Max
Min
Typ
Max
相關PDF資料
PDF描述
RSC60DRYI CONN EDGECARD 120PS DIP .100 SLD
IDT7130LA20JG IC SRAM 8KBIT 20NS 52PLCC
AX1000-1FGG896I IC FPGA AXCELERATOR 1M 896-FBGA
M1AFS1500-FGG484I IC FPGA 8MB FLASH 1.5M 484-FBGA
AFS1500-FGG484I IC FPGA 8MB FLASH 1.5M 484-FBGA
相關代理商/技術參數
參數描述
EP2AGX45CU17C5N 功能描述:FPGA - 現場可編程門陣列 FPGA - Arria II GX 1805 LABs 156 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
EP2AGX45CU17C6 功能描述:FPGA - 現場可編程門陣列 FPGA - Arria II GX 1805 LABs 156 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
EP2AGX45CU17C6N 功能描述:FPGA - 現場可編程門陣列 FPGA - Arria II GX 1805 LABs 156 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
EP2AGX45CU17I3N 功能描述:FPGA - 現場可編程門陣列 FPGA - Arria II GX 1805 LABs 156 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
EP2AGX45CU17I5 功能描述:FPGA - 現場可編程門陣列 FPGA - Arria II GX 1805 LABs 156 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256