參數資料
型號: FT232R
廠商: Electronic Theatre Controls, Inc.
英文描述: Incorporating Clock Generator Output and FTDIChip-ID Security Dongle
中文描述: 納入時鐘發生器輸出和FTDIChip標識安全適配器
文件頁數: 5/29頁
文件大小: 471K
代理商: FT232R
FT232R USB UART I.C. Datasheet Version 1.04
Future Technology Devices International Ltd. 2005
Page 5
3. Block Diagram
3.1 Block Diagram (Simplified)
Figure 1 - FT232R Block Diagram
3.2 Functional Block Descriptions
3.3V LDO Regulator -
The 3.3V LDO Regulator generates the 3.3V reference voltage for driving the USB transceiver
cell output buffers. It requires an external decoupling capacitor to be attached to the 3V3OUT regulator output pin. It
also provides 3.3V power to the 1.5kΩ internal pull up resistor on USBDP. The main function of this block is to power
the USB Transceiver and the Reset Generator Cells rather than to power external logic. However, external circuitry
requiring a 3.3V nominal supply at a current of around than 50mA could also draw its power from the 3V3OUT pin, if
required.
USB Transceiver -
The USB Transceiver Cell provides the USB 1.1 / USB 2.0 full-speed physical interface to the USB
cable. The output drivers provide 3.3V level slew rate control signalling, whilst a differential receiver and two single
ended receivers provide USB data in, SEO and USB Reset condition detection. This Cell also incorporates internal
USB series resistors on the USB data lines, and a 1.5kΩ pull up resistor on USBDP.
USB DPLL -
The USB DPLL cell locks on to the incoming NRZI USB data and provides separate recovered clock and
data signals to the SIE block.
Internal 12MHz Oscillator -
The Internal 12MHz Oscillator cell generates a 12MHz reference clock input to the x4
Clock multiplier. The 12MHz Oscillator is also used as the reference clock for the SIE, USB Protocol Engine and
UART FIFO controller blocks
Clock Multiplier / Divider -
The Clock Multiplier / Divider takes the 12MHz input from the Oscillator Cell and
generates the 48MHz, 24MHz, 12MHz, and 6MHz reference clock signals. The 48Mz clock reference is used for the
USB DPLL and the Baud Rate Generator blocks.
Clock
Multiplier /
Divider
UART
FIFO Controller
Serial Interface
Engine
( SIE )
USB
Protocol Engine
Baud Rate
Generator
UART Controller
with
Programmable
Signal Inversion
and High Drive
3.3 Volt
LDO
Regulator
USB
Transceiver
with
Integrated
Series
Resistors
and 1.5K
Pull-up
USB DPLL
Internal
12MHz
Oscillator
48MHz
48MHz
OCSI
(optional)
OSCO
(optional)
USBDP
USBDM
3V3OUT
VCC
TXD
RXD
RTS#
CTS#
DTR#
DSR#
DCD#
RI#
CBUS0
CBUS1
CBUS2
CBUS3
CBUS4
RESET#
TEST
GND
RESET
GENERATOR
3V3OUT
FIFO TX Buffer
128 bytes
FIFO RX Buffer
256 bytes
Internal
EEPROM
To USB Transceiver Cell
24 MHz
12 MHz
6 MHz
To USB
Transceiver
Cell
VCCIO
相關PDF資料
PDF描述
FT232RL Incorporating Clock Generator Output and FTDIChip-ID Security Dongle
FT232RQ Incorporating Clock Generator Output and FTDIChip-ID Security Dongle
FT500AH-80 Phase Control SCR 320 Amperes Avg 3000-4000 Volts
FT500AN-60 PHASE CONTROL SCR
FT500AH-60 Phase Control SCR 320 Amperes Avg 3000-4000 Volts
相關代理商/技術參數
參數描述
FT232R_10 制造商:FTDI 制造商全稱:FTDI 功能描述:USB UART IC - Single chip USB to asynchronous serial data transfer interface
FT232RL 制造商:Future Technology Devices International 功能描述:USB UART IC 28-Pin SSOP T/R 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB TO UART SMD SSOP28 232 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO UART, SMD, 28SSOP 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB UART INTERFACE, SSOP-28; USB Version:1.1, 2.0; Supply Voltage Min:1.8V; Supply Voltage Max:5.25V; Digital IC Case Style:SSOP; No. of Pins:28; Data Rate:3Mbps; Operating Temperature Min:-40C; Operating Temperature Max:85C ;RoHS Compliant: Yes
FT232RL R 制造商:Future Technology Devices International Ltd 功能描述:UART, 28 Pin, Plastic, SSOP
FT232RL-2000 制造商:FTDI 制造商全稱:FTDI 功能描述:USB UART IC - Single chip USB to asynchronous serial data transfer interface
FT232RL-BO 功能描述:界面開發工具 FT232RL USB to UART Breakout Board RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V