參數資料
型號： HFBR-5105T
英文描述： 1300nm 500 m，F(xiàn)DDI, 100 Mbps ATM, and Fast Ethernet Transceivers in Low Cost 1x9 Package Style(1300nm 500 m，F(xiàn)DDI, 100 Mbps ATM, 快速以太網收發器（低價格 1x9 封裝類型）)
中文描述： 1300nm 500米，光纖分布式數據介面，100 Mbps的ATM和快速以太網收發器的低成本1x9封裝形式（1300nm 500米，光纖分布式數據介面，100 Mbps的自動取款機，快速以太網收發器（低價格1x9封裝類型））
文件頁數： 5/24頁
文件大?。?/td> 351K
代理商： HFBR-5105T
5
LEDs will experience less than
1 dB of aging over normal com-
mercial equipment mission life
periods. Contact your Hewlett-
Packard sales representative for
additional details.
Figure 4 was generated with an
Agilent fiber optic link model
containing the current industry
conventions for fiber cable
specifications and the FDDI PMD
and LCF-PMD optical parameters.
These parameters are reflected in
the guaranteed performance of
the transceiver specifications in
this data sheet. This same model
has been used extensively in the
ANSI and IEEE committees,
including the ANSI X3T9.5
committee, to establish the
optical performance requirements
for various fiber optic interface
standards. The cable parameters
used come from the ISO/IEC
JTC1/SC 25/WG3 Generic
Cabling for Customer Premises
per DIS 11801 document and the
EIA/TIA-568-A Commercial
Building Telecommunications
Cabling Standard per SP-2840.
mounted passive circuit elements
are attached.
The package includes internal
shields for the electrical and
optical subassemblies to ensure
low EMI emissions and high
immunity to external EMI fields.
The outer housing including the
duplex SC connector receptacle
or the duplex ST ports is molded
of filled non-conductive plastic to
provide mechanical strength and
electrical isolation. The solder
posts of the Agilent design are
isolated from the circuit design of
the transceiver and do not require
connection to a ground plane on
the circuit board.
The transceiver is attached to a
printed circuit board with the
nine signal pins and the two
solder posts which exit the
bottom of the housing. The two
solder posts provide the primary
mechanical strength to withstand
the loads imposed on the trans-
ceiver by mating with duplex or
simplex SC or ST connectored
fiber cables.
Application Information
The Applications Engineering
group in the Agilent Optical
Communication Division is
available to assist you with the
technical understanding and
design trade-offs associated with
these transceivers. You can
contact them through your
Agilent sales representative.
The following information is
provided to answer some of the
most common questions about
the use of these parts.
Transceiver Optical Power
Budget versus Link Length
Optical Power Budget (OPB) is
the available optical power for a
fiber optic link to accommodate
fiber cable losses plus losses due
to in-line connectors, splices,
optical switches, and to provide
margin for link aging and
unplanned losses due to cable
plant reconfiguration or repair.
Figure 4 illustrates the predicted
OPB associated with the three
transceiver series specified in this
data sheet at the Beginning of
Life (BOL). These curves
represent the attenuation and
chromatic plus modal dispersion
losses associated with the 62.5/
125
μ
m and 50/125
μ
m fiber
cables only. The area under the
curves represents the remaining
OPB at any link length, which is
available for overcoming non-
fiber cable related losses.
Agilent LED technology has
produced 800 nm LED and 1300
nm LED devices with lower aging
characteristics than normally
associated with these
technologies in the industry. The
industry convention is 3 dB aging
for 800 nm and 1.5 dB aging for
1300 nm LEDs. The HP 1300 nm
Figure 4. Optical Power Budget at BOL versus
Fiber Optic Cable Length.
O
4.0
14
0
FIBER OPTIC CABLE LENGTH (km)
0.5
1.5
2.0
2.5
12
10
8
6
4
3.5
2
1.0
3.0
0.15
HFBR-5103, 62.5/125 μm
HFBR-5103,
50/125 μm
HFBR-5105,
62.5/125 μm
HFBR-5104,
62.5/125 μm
HFBR-5105,
50/125 μm
HFBR-5104,
50/125 μm
相關PDF資料
PDF描述
HFBR-5104 800 nm 500 m，F(xiàn)DDI, 100 Mbps ATM, and Fast Ethernet Transceivers in Low Cost 1x9 Package Style(800 nm 500 m，F(xiàn)DDI, 100 Mbps ATM, 快速以太網收發器（低價格 1x9 封裝類型）)
HFBR-5107T 820 nm，100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style(820 nm，100VG-AnyLAN 多模式光收發器（低價格 1x9封裝類型）)
HFBR-5107 820 nm，100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style(820 nm，100VG-AnyLAN 多模式光收發器（低價格 1x9封裝類型）)
HFBR5106T 1300 nm，100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style(1300 nm，100VG-AnyLAN 多模式光收發器（低價格 1x9封裝類型）)
HFBR-5111 Low Cost, Industry Standard FDDI MIC Transceivers(2x11)(低價格，工業標準 FDDI MIC收發器(2x11))
相關代理商/技術參數
參數描述
HFBR-5106 制造商:HP 制造商全稱:Agilent(Hewlett-Packard) 功能描述:100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style
HFBR-5106T 制造商:HP 制造商全稱:Agilent(Hewlett-Packard) 功能描述:100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style
HFBR-5107 制造商:HP 制造商全稱:Agilent(Hewlett-Packard) 功能描述:100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style
HFBR-5107T 制造商:HP 制造商全稱:Agilent(Hewlett-Packard) 功能描述:100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style
HFBR-5111 制造商:Avago Technologies 功能描述:TRANSCEIVER FDDI MIC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*