3
FN2963.3
May 30, 2008
Absolute Maximum Ratings
Thermal Information
Voltage Between +V and -V Terminals . . . . . . . . . . . . . . . . . . . .40V
V1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7V
VREF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6V
Logic Input Voltage . . . . . . . . . . . . . . . . . . . GND -0.3V to V1 +0.3V
Output Short Circuit Duration. . . . . . . . . . . . . . . . . . . . . . . . (Note
3)
Output Overvoltage Protection. . . . . . . . . . . . . . . . . . . . . . . (Note
4)
Operating Conditions
Operating Voltage
+V . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +15V ±10%
-V . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -15V ±10%
V1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5V ±5%
VREF (For ARINC 429) . . . . . . . . . . . . . . . . . . . . . . . . . . 5V ±5%
Operating Temperature Range
HS-3182-9+ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-40°C to +85°C
HS-3182-8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-55°C to +125°C
Thermal Resistance (Typical)
θ
JA (°C/W)
θ
JC (°C/W)
SBDIP Package . . . . . . . . . . . . . . . . . .
68
12
CLCC Package . . . . . . . . . . . . . . . . . .
54
10
Storage Temperature Range . . . . . . . . . . . . . . . . . . -65°C to +150°C
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +175°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
Die Characteristics
Number of Transistors or Gates . . . . . . . . . . . . . . . . . . . . . . . . . 133
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTES:
1.
θ
JA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
2.
θJC, the “case temp” location is the center of the package underside.
3. Heat sink may be required for 100k bits/s at +125°C and output short circuit at +125°C.
4. The fuses used for output overvoltage protection may be blown by a fault at each output of greater than ±6.5V relative to GND.
DC Electrical Specifications
Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified.
Temperature limits established by characterization and are not production tested.
DC PARAMETER
SYMBOL
CONDITIONS
MIN
MAX
UNITS
Supply Current +V (Operating)
ICCOP (+V)
No Load (0k to 100k bits/s)
-
16
mA
Supply Current -V (Operating)
ICCOP (-V)
No Load (0k to 100k bits/s)
-16
-
mA
Supply Current V1 (Operating)
ICCOP (V1)
No Load (0k to 100k bits/s)
-
975
A
Supply Current VREF (Operating)
ICCOP (VREF)
No Load (0k to 100k bits/s)
-1.0
-
mA
Logic “1” Input Voltage
VIH
2.0
-
V
Logic “0” Input Voltage
VIL
-0.5
V
Output Voltage High (Output to GND)
VOH
No Load (0k to 100k bits/s)
VREF
(-250mV)
VREF
(+250mV)
Output Voltage Low (Output to GND)
VOL
No Load (0k to 100k bits/s)
-VREF
(-250mV)
-VREF
(+250mV)
Output Voltage Null
VNULL
No Load (0k to 100k bits/s)
-250
+250
mV
Input Current (Input Low)
IIL
-20
-
mA
Input Current (Input High)
IIH
-10
mA
Output Short Circuit Current
(Output High)
IOHSC
Short to GND
-
-80
mA
Output Short Circuit Current
(Output Low)
IOLSC
Short to GND
80
-
mA
Output Impedance
ZO
TA = +25°C
60
90
Ω
NOTES:
5. +V = +15V ±10%, -V = -15V ±10%, V1 = VREF = 5V ±5%, unless otherwise specified TA = -40°C to +85°C for HS-3182-9+ and
TA = -55°C to +125°C for HS-3182-8.
HS-3182