- 您現在的位置：買賣IC網 > PDF目錄358713 > ICS308RT SERIAL PROGRAMMABLE QUAD PLL VERSACLOCK SYNTHESIZER PDF資料下載
參數資料
| 型號： | ICS308RT |
| 英文描述： | SERIAL PROGRAMMABLE QUAD PLL VERSACLOCK SYNTHESIZER |
| 中文描述： | 串行可編程四鎖相環VERSACLOCK合成器 |
| 文件頁數： | 4/8頁 |
| 文件大小： | 134K |
| 代理商： | ICS308RT |
S
ERIAL
P
ROGRAMMABLE
Q
UAD
PLL V
ERSA
C
LOCK
S
YNTHESIZER
MDS 308 F
4
Revision 090704
Integrated Circuit Systems
●
525 Race Street, San Jose, CA 95126
●
tel (408) 297-1201
●
www.icst.com
ICS308
External Components
Series Termination Resistor
Clock output traces over one inch should use series
termination. To series terminate a 50
trace (a
commonly used trace impedance), place a 33
resistor
in series with the clock line, as close to the clock output
pin as possible. The nominal impedance of the clock
output is 20
.
STROBE Pull-up Resistor
In order for the device to start up in the default state, a
250 kOhm pull-up resistor is required.
Decoupling Capacitors
As with any high-performance mixed-signal IC, the
ICS308 must be isolated from system power supply
noise to perform optimally.
Decoupling capacitors of 0.01μF must be connected
between each VDD and the PCB ground plane.
Crystal Load Capacitors
The device crystal connections should include pads for
small capacitors from X1 to ground and from X2 to
ground. These capacitors are used to adjust the stray
capacitance of the board to match the nominally
required crystal load capacitance. Because load
capacitance can only be increased in this trimming
process, it is important to keep stray capacitance to a
minimum by using very short PCB traces (and no vias)
been the crystal and device. Crystal capacitors must be
connected from each of the pins X1 and X2 to ground.
The value (in pF) of these crystal caps should equal
(C
L
-6 pF)*2. In this equation, C
L
= crystal load
capacitance in pF. Example: For a crystal with a 16 pF
load capacitance, each crystal capacitor would be 20
pF [(16-6) x 2] = 20.
PCB Layout Recommendations
For optimum device performance and lowest output
phase noise, the following guidelines should be
observed.
1) Each 0.01μF decoupling capacitor should be
mounted on the component side of the board as close
to the VDD pin as possible. No vias should be used
between decoupling capacitor and VDD pin. The PCB
trace to VDD pin should be kept as short as possible,
as should the PCB trace to the ground via.
2) The external crystal should be mounted just next to
the device with short traces. The X1 and X2 traces
should not be routed next to each other with minimum
spaces, instead they should be separated and away
from other traces.
3) To minimize EMI, the 33
series termination resistor
(if needed) should be placed close to each clock
output.
4) An optimum layout is one with all components on the
same side of the board, minimizing vias through other
signal layers.
ICS308 Configuration Capabilities
The architecture of the ICS308 allows the user to easily
configure the device to a wide range of output
frequencies, for a given input reference frequency.
The frequency multiplier PLL provides a high degree of
precision. The M/N values (the multiplier/divide values
available to generate the target VCO frequency) can be
set within the range of M = 1 to 2048 and N = 1 to 1024.
The ICS308 also provides separate output divide
values, from 2 through 20, to allow the two output clock
banks to support widely differing frequency values from
the same PLL.
Each output frequency can be represented as:
Output Freq. = (Ref. Freq)*(M/N)/Output Divide
相關PDF資料 |
PDF描述 |
|---|---|
| ICS308RI | SERIAL PROGRAMMABLE QUAD PLL VERSACLOCK SYNTHESIZER |
| ICS508MIT | PECL to CMOS Converter |
| ICS508-DPK | PECL to CMOS Converter |
| ICS508MI | PECL to CMOS Converter |
| ICS508MT | PECL to CMOS Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS-308-SGG | 制造商:Samtec Inc 功能描述:Conn DIP Socket SKT 8 POS 2.54mm Solder ST Thru-Hole Tube 制造商:Samtec Inc 功能描述:CONN DIP SCKT SKT 8 POS 2.54MM SLDR ST TH - Bulk |
| ICS-308-SGG-L | 制造商:Samtec Inc 功能描述:CONN DIP SCKT SKT 8 POS 2.54MM SLDR ST TH - Bulk |
| ICS-308-SGT | 制造商:Samtec Inc 功能描述:CONN DIP SCKT SKT 8 POS 2.54MM SLDR ST TH - Bulk |
| ICS-308-SGT-L | 制造商:Samtec Inc 功能描述:CONN DIP SCKT SKT 8 POS 2.54MM SLDR ST TH - Bulk |
| ICS-308-SST | 制造商:Samtec Inc 功能描述:CONN DIP SCKT SKT 8 POS 2.54MM SLDR ST TH - Bulk |
發布緊急采購，3分鐘左右您將得到回復。