- 您現在的位置：買賣IC網 > PDF目錄8972 > ICS8432DYI-101LFT (IDT, Integrated Device Technology Inc)IC SYNTHESIZER 700MHZ 32-LQFP PDF資料下載
參數資料
| 型號： | ICS8432DYI-101LFT |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 12/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SYNTHESIZER 700MHZ 32-LQFP |
| 標準包裝： | 1,000 |
| 系列： | HiPerClockS™ |
| 類型： | 頻率合成器 |
| PLL： | 帶旁路 |
| 輸入： | HCSL，LVDS，LVHSTL，LVPECL，SSTL |
| 輸出： | LVPECL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:2 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 700MHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-LQFP |
| 供應商設備封裝： | 32-TQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | 8432DYI-101LFT |
IDT / ICS 700MHZ, 3.3V LVPECL FREQUENCY SYNTHESIZER
2
ICS8432DYI-101 REV. C APRIL 10, 2007
ICS8432I-101
700MHZ, DIFFERENTIAL-TO-3.3V LVPECL FREQUENCY SYNTHESIZER
event occurs. As a result, the M and N bits can be hardwired to
set the M divider and N output divider to a specific default state
that will automatically occur during power-up. The TEST output
is LOW when operating in the parallel input mode. The relation-
ship between the VCO frequency, the input frequency and the M
divider is defined as follows:
The M value and the required values of M0 through M8 are
shown in Table 3B, Programmable VCO Frequency Function
Table. Valid M values for which the PLL will achieve lock for a
25MHz reference are defined as 8
≤ M ≤ 28. The frequency out
is defined as follows:
Serial operation occurs when nP_LOAD is HIGH and S_LOAD is
LOW. The shift register is loaded by sampling the S_DATA
bits with the rising edge of S_CLOCK. The contents of the shift
register are loaded into the M divider and N output divider when
S_LOAD transitions from LOW-to-HIGH. The M divide and N output
divide values are latched on the HIGH-to-LOW transition of
S_LOAD. If S_LOAD is held HIGH, data at the S_DATA input is
passed directly to the M divider and N output divider on each rising
edge of S_CLOCK. The serial mode can be used to program the
M and N bits and test bits T1 and T0. The internal registers T0
and T1 determine the state of the TEST output as follows:
Time
SERIAL LOADING
PARALLEL LOADING
t
S
t
H
t
S
t
H
t
S
M, N
FUNCTIONAL DESCRIPTION
NOTE: The functional description that follows describes opera-
tion using a 25MHz clock input. Valid PLL loop divider values
for different input frequencies are defined in the Input Frequency
Characteristics, Table 5, NOTE 1.
The ICS8432I-101 features a fully integrated PLL and there-
fore requires no external components for setting the loop band-
width. A differential clock input is used as the input to the
ICS8432I-101. This input is fed into the phase detector. A 25MHz
clock input provides a 25MHz phase detector reference fre-
quency. The VCO of the PLL operates over a range of 250MHz
to 700MHz. The output of the M divider is also applied to the
phase detector.
The phase detector and the M divider force the VCO output
frequency to be M times the reference frequency by adjusting
the VCO control voltage. Note, that for some values of M (ei-
ther too high or too low), the PLL will not achieve lock. The
output of the VCO is scaled by a divider prior to being sent to
each of the LVPECL output buffers. The divider provides a
50% output duty cycle.
The programmable features of the ICS8432I-101 support two
input modes to program the PLL M divider and N output divider.
The two input operational modes are parallel and serial. Figure1
shows the timing diagram for each mode. In parallel mode, the
nP_LOAD input is initially LOW. The data on inputs M0 through
M8 and N0 and N1 is passed directly to the M divider and
N output divider. On the LOW-to-HIGH transition of the
nP_LOAD input, the data is latched and the M divider remains
loaded until the next LOW transition on nP_LOAD or until a serial
fVCO = f
IN
x M
T1
T0
TEST Output
00
LOW
0
1
S_Data, Shift Register Input
1
0
Output of M divider
1
CMOS Fout
FIGURE 1. PARALLEL & SERIAL LOAD OPERATIONS
*NOTE: The NULL timing slot must be observed.
T1
T0
*NULL N1
N0
M8
M7M6
M5M4
M3M2
M1M0
S_CLOCK
S_DATA
S_LOAD
nP_LOAD
M0:M8, N0:N1
nP_LOAD
S_LOAD
fOUT = fVCO = f
IN
x M
NN
相關PDF資料 |
PDF描述 |
|---|---|
| ICS84320AY-01LNT | IC SYNTHESIZER 780MHZ 32-LQFP |
| VI-J02-MZ-F4 | CONVERTER MOD DC/DC 15V 25W |
| VI-BTZ-MY-F1 | CONVERTER MOD DC/DC 2V 20W |
| VI-BTZ-MX-F4 | CONVERTER MOD DC/DC 2V 30W |
| SN74AVCH4T245DGVR | IC BUS TRANSCVR 4BIT 16TVSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS8432DYI-101T | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, DIFFERENTIAL-TO-3.3V LVPECL FREQUENCY SYNTHESIZER |
| ICS8432I-101 | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, DIFFERENTIAL-TO-3.3V LVPECL FREQUENCY SYNTHESIZER |
| ICS8432I-51 | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:700MHZ, CYRSTAL-TO-3.3V DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER |
| ICS84330 | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, LOW JITTER, CRYSTAL-TO-3.3V DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER |
| ICS84330-01 | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, LOW JITTER, CRYSTAL-TO-3.3V DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER |
發布緊急采購，3分鐘左右您將得到回復。