- 您現在的位置：買賣IC網 > PDF目錄9375 > ISL12082IUZ-T (Intersil)IC RTC I2C LO-POWER 10-MSOP PDF資料下載
參數資料
| 型號： | ISL12082IUZ-T |
| 廠商： | Intersil |
| 文件頁數： | 8/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RTC I2C LO-POWER 10-MSOP |
| 標準包裝： | 2,500 |
| 類型： | 時鐘/日歷 |
| 特點： | 警報器，閏年，監視計時器 |
| 時間格式： | HH:MM:SS:hh（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | I²C，2 線串口 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 電壓 - 電源，電池： | 1.8 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
16
FN6731.3
November 24, 2008
Sub-Timer Initial Register (TSDAT, address 14h) is set to “0”,
the number of counts changes to the default value. The
maximum register value for the TSDAT register is 127 which
means the maximum limit for the internal Sub-Timer Counter
Register is also 127. See Table 10 for Timer/Watchdog clock
frequency selection and the default counts for the Sub-Timer
Counter Register.
The Timer Counter and Sub-Timer Counter Registers
advance the counter value based on the frequency or time
setting by the TCLK<1:0> bits.
The following are examples of Timer clock frequency
selection bits on Timer Counter and Sub-Timer Counter
Registers.
Example 1 - TCLK1 is set to “1”, TCLK0 is set to “0”, and
Sub-Timer Initial Register is set to “0”. The internal
Sub-Timer Counter will increment every 1s. When the
internal Sub-Timer Counter reaches to 60, the default value,
the Timer Counter will increment by one which means the
Timer Counter will increment every one minute.
Example 2- TCLK1 is set to “1”, TCLK0 is set to “0”, and
Sub-Timer Initial Register is set to “10d”. The internal
Sub-Timer Counter will increment every 1s. When the
internal Sub-Timer Counter reaches to 10, the Timer
Counter will increment by one which means the Timer
Counter will increment every ten seconds.
Example 3- TCLK1 is set to “0”, TCLK0 is set to “1”, and
Sub-Timer Initial Register is set to “0”. The internal
Sub-Timer Counter will increment every 1ms (100Hz). When
the internal Sub-Timer Counter reaches to 100, the default
value2, the Timer Counter will increment by one which
means the Timer Counter will increment every one second.
TIMER FUNCTION SELECTION BITS (TMOD <1:0>)
The Timer interrupt has four different functions:
1. Count Down Timer
2. Secondary Alarm Timer
3. Watchdog Timer
4. Power Fail Count-up Timer
Please see Table 11 for Timer counting functions selection.
TIMER ENABLE BIT (TMRE)
This bit enables/disables the timer function. When the TMRE
bit is set to “1”, the timer is enabled. To display timer interrupt
on the IRQ2 pin, the IRQ2E has to be set to “1”. When the
TMRE bit is cleared to “0”, the timer function is disabled. The
TMRE bit is set to “0” on power-up.
TIMER PULSE/EVENT INTERRUPT BIT (TIM)
This bit enables/disables the interrupt mode of the timer
function. When the TIM bit is set to “1”, the timer will operate
in the interrupt mode. An active low pulse width of 210ms will
appear at the IRQ2 pin when the RTC is triggered by the
timer as defined by the timer registers (12h to 15h). When
the TIM bit is cleared to “0”, the timer will operate in standard
mode, where the IRQ2 pin will be held low until TMR status
bit is cleared to “0”. The TIM bit is set to “0” on power-up.
Timer Registers
Addresses [12h to 15h]
Timer Initial Register (TDAT) [Address 12h]
The Timer Initial Register is located in the memory map at
address 12h. This is a volatile register that stores the timer
limit for the timer counter register.
TABLE 10. TIMER CLOCK FREQUENCY SELECTION AND
DEFAULT VALUE FOR TSDAT REGISTER
TCLK1 TCLK0 FUNCTION
COMMENT
0
100Hz/4kHz 100Hz for TCNT, 4kHz for TSCNT
Default Value for TSDAT = 41
(41 TSCNT counts = 1ms)
(Not available for Watchdog Timer)
0
1
1sec/100Hz 1sec for TCNT, 100Hz for TSCNT
Default Value for TSDAT = 100
(100 TSCNT counts = 1s)
1
0
1min/1sec
1min for TCNT, 1sec for TSCNT
Default Value for TSDAT = 60
(60 TSCNT counts = 1min)
(RTC must be enabled)
1
1hr/1min
1hour for TCNT, 1min for TSCNT
Default Value for TSDAT = 60
(60 TSCNT counts = 1hr)
(RTC must be enabled)
TABLE 11. TIMER COUNTING FUNCTION SELECTION
TMOD1 TMOD0
FUNCTION
COMMENT
0
Count Down
Timer
Basic count down timer
(TCNT register decrement)
0
1
Secondary
Alarm Timer
Basic count down timer activated by
ALARM IRQ (ALM bit)
(TCNT register decrement)
1
0
Watchdog
Timer
Count up timer with periodic
interrupt
(TCNT register increment)
11
Power Fail
Count-up
Timer
Count up after device entered into
battery mode
(TCNT register increment)
TIM BIT
TIMER PULSE/EVENT INTERRUPT FUNCTION
0
Single Time Event Set By Timer
1
Repetitive/Recurring Time Event Set By Timer
TABLE 12. TIMER INITIAL REGISTER (TDAT)
ADDR
76543210
12h
TDAT7 TDAT6 TDAT5 TDAT4 TDAT3 TDAT2 TDAT1 TDAT0
Default
00000000
ISL12082
相關PDF資料 |
PDF描述 |
|---|---|
| VI-BN2-MV | CONVERTER MOD DC/DC 15V 150W |
| MS3102A36-8S | CONN RCPT 47POS BOX MNT W/SCKT |
| MS27466T21F11P | CONN RCPT 11POS WALL MT W/PINS |
| ISL23418TFUZ-T7A | IC DGTL POT 1CH 100K 10MSOP |
| D38999/26WH21PA | CONN PLUG 21POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL1208EVAL | 功能描述:電源管理IC開發工具 EVALRD FOR ISL1208 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| ISL1208IB8 | 功能描述:IC RTC/CALENDAR I2C 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 實時時鐘 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:時鐘/日歷 特點:警報器，閏年，SRAM 存儲容量:- 時間格式:HH:MM:SS（12/24 小時） 數據格式:YY-MM-DD-dd 接口:SPI 電源電壓:2 V ~ 5.5 V 電壓 - 電源，電池:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN EP 包裝:管件 |
| ISL1208IB8-TK | 功能描述:IC RTC/CALENDAR I2C 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 實時時鐘 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:時鐘/日歷 特點:警報器，閏年，SRAM 存儲容量:- 時間格式:HH:MM:SS（12/24 小時） 數據格式:YY-MM-DD-dd 接口:SPI 電源電壓:2 V ~ 5.5 V 電壓 - 電源，電池:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN EP 包裝:管件 |
| ISL1208IB8Z | 功能描述:實時時鐘 I2C REAL TIME CLOCK/ CALENDAR 8LD RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL1208IB8ZR5291 | 功能描述:實時時鐘 I2CAL TIME CLK/CLNDR ALL BATRY MODE TESTS RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。