- 您現在的位置：買賣IC網 > PDF目錄383145 > ISL6308IRZ-T (INTERSIL CORP) Three-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers PDF資料下載
參數資料
| 型號： | ISL6308IRZ-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Three-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers |
| 中文描述： | SWITCHING CONTROLLER, 1500 kHz SWITCHING FREQ-MAX, PQCC40 |
| 封裝： | 6 X 6 MM, ROHS COMPLIANT, PLASTIC, MO-220VJJD-1, QFN-40 |
| 文件頁數： | 16/27頁 |
| 文件大?。?/td> | 765K |
| 代理商： | ISL6308IRZ-T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
16
FN9208.2
October 19, 2005
Fault Monitoring and Protection
The ISL6308 actively monitors output voltage and current to
detect fault conditions. Fault monitors trigger protective
measures to prevent damage to the load.
One common power good indicator is provided for linking to
external system monitors. The schematic in Figure 13
outlines the interaction between the fault monitors and the
power good signal
Power Good Signal
The power good pin (PGOOD) is an open-drain logic output
that transitions high when the converter is operating after
soft-start. PGOOD pulls low during shutdown and releases
high after a successful soft-start. PGOOD transitions low
when an undervoltage, overvoltage, or overcurrent condition
is detected or when the controller is disabled by a reset from
ENLL or POR. If after an undervoltage or overvoltage event
occurs the output returns to within under and overvoltage
limits, PGOOD will return high.
Undervoltage Detection
The undervoltage threshold is set at 82% of the REF
voltage. When the output voltage (VSEN-RGND) is below
the undervoltage threshold, PGOOD gets pulled low. No
other action is taken by the controller. PGOOD will return
high if the output voltage rises above 85% of the REF
voltage.
Overvoltage Protection
The ISL6308 constantly monitors the difference between the
VSEN and RGND voltages to detect if an overvoltage event
occurs. During soft-start, while the DAC/REF is ramping up,
the overvoltage trip level is the higher of REF plus 150mV or
a fixed voltage, V
OVP
. The fixed voltage, V
OVP
, is 1.67V.
Upon successful soft-start, the overvoltage trip level is only
REF plus 150mV. OVP releases 50mV below its trip point if it
was “REF plus 150mV” that tripped it, and releases 100mV
below its trip point if it was the fixed voltage, V
OVP
, that
tripped it. Actions are taken by the ISL6308 to protect the
load when an overvoltage condition occurs, until the output
voltage falls back within set limits.
At the inception of an overvoltage event, all LGATE signals
are commanded high, and the PGOOD signal is driven low.
This causes the controller to turn on the lower MOSFETs
and pull the output voltage below a level that might cause
damage to the load. The LGATE outputs remain high until
VDIFF falls to within the overvoltage limits explained above.
The ISL6308 will continue to protect the load in this fashion
as long as the overvoltage condition recurs.
Once an overvoltage condition ends the ISL6308 continues
normal operation and PGOOD returns high.
Pre-POR Overvoltage Protection
Prior to PVCC and VCC exceeding their POR levels, the
ISL6308 is designed to protect the load from any overvoltage
events that may occur. This is accomplished by means of an
internal 10k
resistor tied from PHASE to LGATE, which
turns on the lower MOSFET to control the output voltage
until the overvoltage event ceases or the input power supply
cuts off. For complete protection, the low side MOSFET
FIGURE 12. SOFT-START WAVEFORMS FOR ISL6308-BASED
MULTI-PHASE CONVERTER
ENLL (5V/DIV)
V
OUT
(0.5V/DIV)
GND>
T1
GND>
T2
T3
OUTPUT PRECHARGED
BELOW DAC LEVEL
OUTPUT PRECHARGED
ABOVE DAC LEVEL
FIGURE 13. POWER GOOD AND PROTECTION CIRCUITRY
-
+
DAC + 150mV
VSEN
-
+
0.82 x DAC
OV
UV
PGOOD
SOFT-START, FAULT
AND CONTROL LOGIC
-
+
OC
-
+
ISEN
IREF
ISUM
ICOMP
OCSET
R
OCSET
+
-
V
DROOP
V
OCSET
+
-
V
OVP
100μA
ISL6308 INTERNAL CIRCUITRY
-
+
RGND
x1
-
+
+1V
VDIFF
DROOP*
* Connect DROOP to IREF
to disable the Droop feature.
ISL6308
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6315 | Two-Phase Multiphase Buck PWM Controller with Integrated MOSFET Drivers(帶集成MOSFET驅動器的雙相降壓PWM控制器) |
| ISL6316 | Quadruple 2-Input Exclusive-OR Gates 14-SOIC -40 to 85 |
| ISL6316IRZ | MINIATURE TOGGLE SWITCH |
| ISL6316CRZ | Enhanced 4-Phase PWM Controller with 6-Bit VID Code Capable of Precision RDS(ON) or DCR Differential Current Sensing for VR10 Application |
| ISL6316CRZ-T | Quadruple 2-Input Exclusive-OR Gates 14-PDIP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6308IRZ-TR5453 | 制造商:Intersil Corporation 功能描述:STD. ISL6308IRZ-T WITH GOLD BOND WIRE ONLY - Tape and Reel |
| ISL6310CRZ | 功能描述:電壓模式 PWM 控制器 W/ANNEAL 2-PH PWM CNTRLR W/2-DRVRS RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| ISL6310CRZ-T | 功能描述:電壓模式 PWM 控制器 W/ANNEAL 2-PH PWM CNTRLR W/2-DRVRS RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| ISL6310EVAL1Z | 功能描述:EVALUATION BOARD FOR ISL6310 RoHS:是 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓撲結構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
| ISL6310IRZ | 功能描述:電壓模式 PWM 控制器 W/ANNEAL 2-PH PWM CNTROL W/2-DRVRS RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。