參數資料
型號: JANTXV2N918
英文描述: TRANSISTOR | BJT | NPN | 15V V(BR)CEO | 50MA I(C) | TO-72
中文描述: 晶體管|晶體管|叩| 15V的五(巴西)總裁| 50mA的一(c)|至72
文件頁數: 4/21頁
文件大?。?/td> 137K
代理商: JANTXV2N918
MIL-PRF-19500/368F
12
* 4.4.4 Group E inspection. Group E inspection shall be conducted in accordance with the conditions specified for
subgroup testing in appendix E, table IX of MIL-PRF-19500 and as specified in table III herein. Electrical
measurements (end-points) shall be in accordance with table I, group A, subgroup 2 herein. Delta measurements
shall be in accordance with the steps of 4.5.3.
4.5 Method of inspection. Methods of inspection shall be as specified in the appropriate tables and as follows.
4.5.1 Pulse measurements. Conditions for pulse measurement shall be as specified in section 4 of
MIL-STD-750.
4.5.2 Thermal resistance. Thermal resistance measurements shall be conducted in accordance with method 3131
of MIL-STD-750. The following conditions shall apply:
a.
Collector current magnitude during power application shall be 150 mA dc for RθJC.
b.
Collector emitter voltage magnitude shall be 10 V dc.
c.
Reference temperature measuring point shall be the case.
d.
Reference temperature measuring point shall be +25
°C ≤ T
R ≤ +35°C. The chosen reference
temperature shall be recorded before the test is started.
e.
Mounting arrangement shall be with heat sink to case for RθJC.
Maximum limit shall be RθJC = 35°C/W.
* 4.5.3 Delta requirements. Delta requirements shall be as specified below:
Step
Inspection
MIL-STD-750
Symbol
Unit
Method
Conditions
1
Collector-base cutoff
current
3036
Bias condition D,
VCB = 360 V dc for 2N3439, 2N3439L,
2N3439UA
VCB = 250 V dc for 2N3440, 2N3440L,
2N3440UA
ICB01
(1)
100 percent of initial
value or 200 nA dc,
whichever is greater.
2
Forward current
transfer ratio
3076
VCE = 10 V dc;
IC = 20 mA dc;
pulsed see 4.5.1
hFE1
(1)
±15 percent change
from initial reading.
(1) Devices which exceed the table I, group A limits for this test shall not be accepted.
相關PDF資料
PDF描述
JCLFCMEN-15.000MHZ Voltage-Controlled Oscillator
JCLFCMEN-155.520MHZ Voltage-Controlled Oscillator
JCLFCMEN-170.000MHZ Voltage-Controlled Oscillator
JCLFCMEN-77.760MHZ Voltage-Controlled Oscillator
JCLFCMEN-82.944MHZ Voltage-Controlled Oscillator
相關代理商/技術參數
參數描述
JANTXV2N918UB 制造商:Semicoa Semiconductors 功能描述:Trans GP BJT NPN 15V 0.05A 3-Pin UB 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR (NPN) - Waffle Pack
JANTXV2N930 制造商:Microsemi Corporation 功能描述:Trans GP BJT NPN 45V 0.03A 3-Pin TO-18 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR (NPN) - Bulk 制造商:Microsemi Corporation 功能描述:NPN LOW POWER SILICON TRANSISTOR
JANTXV2N930UB 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR (NPN) - Waffle Pack
JANTXV4N22 功能描述:Optoisolator Transistor with Base Output 1000VDC 1 Channel TO-78-6 制造商:tt electronics/optek technology 系列:- 包裝:散裝 零件狀態:有效 通道數:1 電壓 - 隔離:1000VDC 電流傳輸比(最小值):25% @ 10mA 電流傳輸比(最大值):- 打開 / 關閉時間(典型值):- 上升/下降時間(典型值):20μs,20μs(最大) 輸入類型:DC 輸出類型:有基極的晶體管 電壓 - 輸出(最大值):40V 電流 - 輸出/通道:50mA 電壓 - 正向(Vf)(典型值):1.5V(最大) 電流 - DC 正向(If):40mA Vce 飽和值(最大值):300mV 工作溫度:-55°C ~ 125°C 安裝類型:通孔 封裝/外殼:TO-78-6 金屬罐 供應商器件封裝:TO-78-6 標準包裝:1
JANTXV4N22A 功能描述:Optoisolator Transistor with Base Output 1000VDC 1 Channel TO-78-6 制造商:tt electronics/optek technology 系列:- 包裝:散裝 零件狀態:有效 通道數:1 電壓 - 隔離:1000VDC 電流傳輸比(最小值):25% @ 10mA 電流傳輸比(最大值):- 打開 / 關閉時間(典型值):- 上升/下降時間(典型值):20μs,20μs(最大) 輸入類型:DC 輸出類型:有基極的晶體管 電壓 - 輸出(最大值):40V 電流 - 輸出/通道:50mA 電壓 - 正向(Vf)(典型值):1.5V(最大) 電流 - DC 正向(If):40mA Vce 飽和值(最大值):300mV 工作溫度:-55°C ~ 125°C 安裝類型:通孔 封裝/外殼:TO-78-6 金屬罐 供應商器件封裝:TO-78-6 標準包裝:1