
LC749460W
No.A1187-2/20
Continued from preceding page.
(5) Resolution Conversion
Resolution conversion (to WXGA)
PIP/POP.
(6) Picture quality improvement
Noise reduction (3D NR)
Cross color/Cross luminance canceller
Horizontal edge correction (LTI/CTI), Sharpness (horizontal/vertical), Shadow adjuster
White/black stretch. Flesh tone improvement.
Hue/Color gain adjustment/Color exciter (6 phase RGBYMC Independent saturation correction).
Brightness/Contrast adjustment. White balance/Black balance adjustment.
γ correction (RGB independent, LUT system programmable). Dithering (10-bit/8-bit). Clamp control.
Clock generator (PLL)/various of Built-in interface (SDRAM IF, I2C bus, 3 wire-bus)
YUV to RGB conversion/YCbCr to RGB conversion/YPbPr to RGB conversion/RGB to YCbCr conversion
LSI Specifications
Supply voltage Core: 1.2V, I/O block: 3.3V
Maximum operating frequency: 85MHz
Package: LQFP256
Principal Applications
LCD TVs, monitors, and projectors, PDP TVs, progressive scan TVs, and projection TVs
1. Input
1-1 Input signal format (Digital input)
Digital data port supports the following signal input formats.
24bit (4:4:4) YCbCr/RGB: NTSC/PAL (480i/576i), 480p, 576p, HD (1080i/720p)
16bit (4:2:2) YCbCr: NTSC/PAL (480i/576i), 480p, 576p, HD (1080i/720p)
8bit Based on ITU-R BT656system (H/V sync input is needed): NTSC/PAL (480i/576i)
Digital 2 system input such as 16bit (4:2:2) YCbCr + 8bit (ITU-R BT656), 8bit (ITU-R BT656) +
8bit (ITU-R BT656) are possible
1-2 Input signal format (Analog input)
Analog port can be connected to all of the following input.
CVBS
× 2ch: Composite input 2CH
S-Video: S video input 1CH
YPbPr input (Supports 480i/576i, 480p/576p, 1080i, 720p input): Component input 2 system
2. Digital Video Decoder Block
This LSI carries video decoder which converts the video signal of NTSC, PAL and SECAM or Component
video signal into digital picture signal.
It decodes Digital picture data by inputting the video signals of NTSC, PAL and SECAM which are converted
from Analog to Digital. It supports composite video signal, S video signal and component signal (480i).
3. De-interlacing Block
When inputting NTSC (480i) and PAL (576i), it can implement motion adaptive De-interlacing, cinema mode
de-interlace, 3D noise reduction and cross color/cross luminance canceller. At 480p, 576p, 1080i, 720p, this block is
set to the through state.
3-1. Motion adaptive De-interlacing
At De-interlacing block, it operates the movement detection to every pixel that inputted. As a result, it does
interpolation between front and back field to the pixel that judged as static, and does interpolation inside field
to the pixel that judged as move. So de-interlacing can be done. In that case, as for interpolation in between
field of move part, it is possible to produce less notched (less-jaggy) and smooth image because of interpolation
that considers the correlation of oblique direction.