- 您現在的位置：買賣IC網 > PDF目錄358828 > LM2706 (National Semiconductor Corporation) Miniature, Variable, Step-Down DC-DC Converter with Bypass for RF Power Amplifiers PDF資料下載
參數資料
| 型號： | LM2706 |
| 廠商： | National Semiconductor Corporation |
| 元件分類： | DC/DC變換器 |
| 英文描述： | Miniature, Variable, Step-Down DC-DC Converter with Bypass for RF Power Amplifiers |
| 中文描述： | 微型，變，降壓型DC - DC與RF功率放大器繞道轉換器 |
| 文件頁數： | 10/15頁 |
| 文件大?。?/td> | 451K |
| 代理商： | LM2706 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁
Circuit Operation
(Continued)
PWM Operation
While in PWM (Pulse Width Modulation) mode, the output
voltage is regulated by switching at a constant frequency
and then modulating the energy per cycle to control power to
the load. Energy per cycle is set by modulating the PFET
switch on-time pulse-width to control the peak inductor cur-
rent. This is done by comparing the signal from the current-
sense amplifier with a slope compensated error signal from
the voltage-feedback error amplifier. At the beginning of
each cycle, the clock turns on the PFET switch, causing the
inductor current to ramp up. When the current sense signal
ramps past the error amplifier signal, the PWM comparator
turns off the PFET switch and turns on the NFET synchro-
nous rectifier, ending the first part of the cycle. If an increase
in load pulls the output down, the error amplifier output
increases, which allows the inductor current to ramp higher
before the comparator turns off the PFET. This increases the
average current sent to the output and adjusts for the in-
crease in the load.
Before going to the PWM comparator, the error signal is
summed with a slope compensation ramp from the oscillator
for stability of the current feedback loop. During the second
part of the cycle, a zero crossing detector turns off the NFET
synchronous rectifier if the inductor current ramps to zero.
The minimum on time of PFET in PWM mode is 200 ns.
Bypass Operation
The LM2706 contains an internal PFET switch for bypassing
the PWM DC-DC converter during Forced and Automatic
Bypass modes. In Forced Bypass mode, this switch is turned
on to power the PA directly from the battery for maximum RF
output power. Automatic Bypass mode turns on the bypass
switch when the input voltage approaches the programmed
output voltage so that the RF PA can continue to operate
with good linearity at high power levels when the battery
voltage is low. When the part operates in the Forced or
20040905
FIGURE 2. Simplified Functional Diagram
200409A7
FIGURE 3. Typical Circuit Waveforms in PWM Mode
L
www.national.com
10
相關PDF資料 |
PDF描述 |
|---|---|
| LM2706TL | Miniature, Variable, Step-Down DC-DC Converter with Bypass for RF Power Amplifiers |
| LM2706TLX | Miniature, Variable, Step-Down DC-DC Converter with Bypass for RF Power Amplifiers |
| LM2710MT-ADJ | CAP 1000PF 200V 200V X7R RAD.20 .20X.20 BULK S-MIL-PRF-39014 STANDOFF |
| LM2710MTX-ADJ | Step-up PWM DC/DC Converter Integrated with 5 Buffers |
| LM2710 | Step-up PWM DC/DC Converter Integrated with 5 Buffers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2706DW E WAF | 制造商:Texas Instruments 功能描述: |
| LM2706TL | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Miniature, Variable, Step-Down DC-DC Converter with Bypass for RF Power Amplifiers |
| LM2706TLX | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Miniature, Variable, Step-Down DC-DC Converter with Bypass for RF Power Amplifiers |
| LM2706TLX/NOPB | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| LM2707 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Inductive-Boost Series LED Driver with Programmable Oscillator Frequency |
發布緊急采購，3分鐘左右您將得到回復。