- 您現在的位置：買賣IC網 > PDF目錄11692 > LPC1317FBD64,551 (NXP Semiconductors)IC MCU 32BIT 64KB FLASH 64LQFP PDF資料下載
參數資料
| 型號： | LPC1317FBD64,551 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 29/77頁 |
| 文件大小： | 0K |
| 描述： | IC MCU 32BIT 64KB FLASH 64LQFP |
| 標準包裝： | 160 |
| 系列： | LPC13xx |
| 核心處理器： | ARM? Cortex?-M3 |
| 芯體尺寸： | 32-位 |
| 速度： | 72MHz |
| 連通性： | I²C，Microwire，SPI，SSI，SSP，UART/USART |
| 外圍設備： | 欠壓檢測/復位，POR，WDT |
| 輸入/輸出數： | 51 |
| 程序存儲器容量： | 64KB（64K x 8） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 4K x 8 |
| RAM 容量： | 10K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2 V ~ 3.6 V |
| 數據轉換器： | A/D 8x12b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 64-LQFP |
| 包裝： | 托盤 |
| 其它名稱： | 568-9596 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁
LPC1315_16_17_45_46_47
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 3 — 20 September 2012
35 of 77
NXP Semiconductors
LPC1315/16/17/45/46/47
32-bit ARM Cortex-M3 microcontroller
7.18.5.4
Power-down mode
In Power-down mode, the LPC1315/16/17/45/46/47 is in Sleep-mode and all peripheral
clocks and all clock sources are off with the exception of watchdog oscillator if selected. In
addition all analog blocks and the flash are shut down. In Power-down mode, the user has
the option to keep the BOD circuit running for BOD protection.
The LPC1315/16/17/45/46/47 can wake up from Power-down mode via reset, selected
GPIO pins, a watchdog timer interrupt, or an interrupt generating USB port activity.
Power-down mode reduces power consumption compared to Deep-sleep mode at the
expense of longer wake-up times.
7.18.5.5
Deep power-down mode
In Deep power-down mode, power is shut off to the entire chip with the exception of the
WAKEUP pin. The LPC1315/16/17/45/46/47 can wake up from Deep power-down mode
via the WAKEUP pin.
The LPC1315/16/17/45/46/47 can be prevented from entering Deep power-down mode by
setting a lock bit in the PMU block. Locking out Deep power-down mode enables the user
to always keep the watchdog timer or the BOD running.
When entering Deep power-down mode, an external pull-up resistor is required on the
WAKEUP pin to hold it HIGH. The RESET pin must also be held HIGH to prevent it from
floating while in Deep power-down mode.
7.18.6 System control
7.18.6.1
Reset
Reset has four sources on the LPC1315/16/17/45/46/47: the RESET pin, the Watchdog
reset, power-on reset (POR), and the BrownOut Detection (BOD) circuit. The RESET pin
is a Schmitt trigger input pin. Assertion of chip reset by any source, once the operating
voltage attains a usable level, starts the IRC and initializes the flash controller.
A LOW-going pulse as short as 50 ns resets the part.
When the internal Reset is removed, the processor begins executing at address 0, which
is initially the Reset vector mapped from the boot block. At that point, all of the processor
and peripheral registers have been initialized to predetermined values.
An external pull-up resistor is required on the RESET pin if Deep power-down mode is
used.
7.18.6.2
Brownout detection
The LPC1315/16/17/45/46/47 includes up to four levels for monitoring the voltage on the
VDD pin. If this voltage falls below one of selected levels, the BOD asserts an interrupt
signal to the NVIC. This signal can be enabled for interrupt in the Interrupt Enable
Register in the NVIC in order to cause a CPU interrupt; if not, software can monitor the
signal by reading a dedicated status register. Four threshold levels can be selected to
cause a forced reset of the chip.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B0H-IX-F4 | CONVERTER MOD DC/DC 52V 75W |
| LPC1345FBD48,151 | IC MCU 32BIT 32KB FLASH 48LQFP |
| MS27474E16B55S | CONN RCPT 55POS JAM NUT W/SCKT |
| VI-B10-IW-F2 | CONVERTER MOD DC/DC 5V 100W |
| D38999/26FE6PA | CONN PLUG 6POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC1317FHN33 | 制造商:NXP Semiconductors 功能描述:MCU 32BIT ARM CORTEX-M3 32HVQFN 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM CORTEX-M3, 32HVQFN 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM CORTEX-M3, 32HVQFN, Controller Family/Series:LPC13xx, Core Size:32bit, No. of I/O's:28, Supply Voltage Min:2V, Supply Voltage Max:3.6V, Digital IC Case Style:HVQFN, No. of Pins:33, Program Memory Size:64KB, EEPROM , RoHS Compliant: Yes |
| LPC1317FHN33,551 | 功能描述:ARM微控制器 - MCU 32bit ARM Cortex-M3 64KB Flash 10KB SRAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC132CTP | 功能描述:LED 光導管 Round Lightpipe 1.32" Clear RoHS:否 制造商:Bivar 產品:Light Pipes 顏色:Clear LED 大小: 主體形狀:Cylindrical 主體長度:0.125 in 材料:Polycarbonate |
| LPC132CTP-PK10 | 制造商:Visual Communications Company (VCC) 功能描述:Light Pipes |
| LPC1342 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M3 microcontroller; up to 32 kB flash and 8 kB SRAM; USB device |
發布緊急采購，3分鐘左右您將得到回復。