- 您現在的位置：買賣IC網 > PDF目錄367585 > LPC2292 (NXP Semiconductors N.V.) 16/32-bit ARM microcontrollers 256 kB ISP/IAP Flash with CAN, 10-bit ADC and external memory interface PDF資料下載
參數資料
| 型號： | LPC2292 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | 16/32-bit ARM microcontrollers 256 kB ISP/IAP Flash with CAN, 10-bit ADC and external memory interface |
| 中文描述： | 16/32位ARM微控制器的256 KB的供應商/聯合會與CAN，10閃光位模數轉換器和外部存儲器接口 |
| 文件頁數： | 20/40頁 |
| 文件大?。?/td> | 188K |
| 代理商： | LPC2292 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
Philips Semiconductors
LPC2292/LPC2294
16/32-bit ARM microcontrollers with external memory interface
Preliminary data
Rev. 01 — 05 February 2004
20 of 40
9397 750 12748
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
6.10 External memory controller
The external Static Memory Controller is a module which provides an interface
between the system bus and external (off-chip) memory devices. It provides support
for up to four independently configurable memory banks (16 MBytes each with byte
lane enable control) simultaneously. Each memory banks is capable of supporting
SRAM, ROM, Flash EPROM, Burst ROM memory, or some external I/O devices.
Each memory bank may be 8, 16, or 32 bits wide.
6.11 General purpose parallel I/O
Device pins that are not connected to a specific peripheral function are controlled by
the GPIO registers. Pins may be dynamically configured as inputs or outputs.
Separate registers allow setting or clearing any number of outputs simultaneously.
The value of the output register may be read back, as well as the current state of the
port pins.
6.11.1
Features
Direction control of individual bits.
Separate control of output set and clear.
All I/O default to inputs after reset.
6.12 10-bit A/D converter
The LPC2292/LPC2294 each contain single 10-bit successive approximation analog
to digital converter with eight multiplexed channels.
6.12.1
Features
Measurement range of 0 V to 3 V.
Capable of performing more than 400,000 10-bit samples per second.
Burst conversion mode for single or multiple inputs.
Optional conversion on transition on input pin or Timer Match signal.
6.13 CAN controllers and acceptance filter
The LPC2292/LPC2294 each contain two/four CAN controllers. The Controller Area
network (CAN) is a serial communications protocol which efficiently supports
distributed real-time control with a very high level of security. Its domain of application
ranges from high speed networks to low cost multiplex wiring.
6.13.1
Features
Data rates up to 1 Mbit/s on each bus.
32-bit register and RAM access.
Compatible with CAN specification 2.0B, ISO 11898-1.
Global Acceptance Filter recognizes 11 and 29-bit Rx identifiers for all CAN buses.
Acceptance Filter can provide FullCAN-style automatic reception for selected
Standard identifiers.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2294JBD144 | 16/32-bit ARM microcontrollers 256 kB ISP/IAP Flash with CAN, 10-bit ADC and external memory interface |
| LPC2294 | 16/32-bit ARM microcontrollers 256 kB ISP/IAP Flash with CAN, 10-bit ADC and external memory interface |
| LPC2470 | Flashless 16-bit/32-bit micro; Ethernet, CAN, LCD, USB 2.0 device/host/OTG, external memory interface |
| LPD200P70 | PACKAGED HIGH DYNAMIC RANGE PHEMT |
| LPD200 | HIGH PERFORMANCE PHEMT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2292_07 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 256 kB ISP/IAP flash with CAN, 10-bit ADC and external memory interface |
| LPC2292FBD144 | 制造商:NXP Semiconductors 功能描述:16/32BIT ARM7 MCU 256K FLASH 144LQFP 制造商:NXP Semiconductors 功能描述:16/32BIT ARM7 MCU, 256K FLASH, 144LQFP 制造商:NXP Semiconductors 功能描述:Microcontroller,LPC2292FBD144 60 MHz |
| LPC2292FBD144,551 | 功能描述:ARM微控制器 - MCU PREF PART LPC2292FBD144/01-S RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2292FBD144/00 | 制造商:NXP Semiconductors 功能描述:16/32BIT ARM7 MCU 256K FLASH SMD |
| LPC2292FBD144/01 | 制造商:NXP Semiconductors 功能描述:16/32BIT ARM7 MCU 256K FLASH LQFP144 制造商:NXP Semiconductors 功能描述:16/32BIT ARM7 MCU, 256K FLASH, LQFP144 |
發布緊急采購，3分鐘左右您將得到回復。