- 您現在的位置：買賣IC網 > PDF目錄385497 > LPC2919FBD144 (NXP Semiconductors N.V.) ARM9 microcontroller with CAN and LIN PDF資料下載
參數資料
| 型號： | LPC2919FBD144 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 數學處理器 |
| 英文描述： | ARM9 microcontroller with CAN and LIN |
| 封裝： | LPC2917FBD144/01<SOT486-1 (LQFP144)|<<http://www.nxp.com/packages/SOT486-1.html<1<Always Pb-free,;LPC2919FBD144/01<SOT486-1 (LQFP144)|<<http://www.nxp.com/packages/SOT486 |
| 文件頁數： | 50/86頁 |
| 文件大?。?/td> | 554K |
| 代理商： | LPC2919FBD144 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
LPC2917_19_01_3
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 03 — 9 December 2009
50 of 86
NXP Semiconductors
LPC2917/01; LPC2919/01
ARM9 microcontroller with CAN and LIN
generator. The RDET register keeps track of which clocks are active and inactive, and the
appropriate ‘CLK_SEL’ values are masked and unmasked accordingly. Each clock
detector can also generate interrupts at clock activation and deactivation so that the
system can be notified of a change in internal clock status.
Clock detection is done using a counter running at the
BASE_PCR_CLK
frequency. If no
positive clock edge occurs before the counter has 32 cycles of BASE_PCR_CLK the clock
is assumed to be inactive. As
BASE_PCR_CLK
is slower than any of the clocks to be
detected, normally only one BASE_PCR_CLK cycle is needed to detect activity. After
reset all clocks are assumed to be ‘non-present’, so the RDET status register will be
correct only after 32
BASE_PCR_CLK
cycles.
Note that this mechanism cannot protect against a currently-selected clock going from
active to inactive state. Therefore an inactive clock may still be sent to the system under
special circumstances, although an interrupt can still be generated to notify the system.
Glitch-Free Switching:
Provisions are included in the CGU to allow clocks to be
switched glitch-free, both at the output generator stage and also at secondary source
generators.
In the case of the PLL the clock will be stopped and held low for long enough to allow the
PLL to stabilize and lock before being re-enabled. For all non-PLL Generators the switch
will occur as quickly as possible, although there will always be a period when the clock is
held low due to synchronization requirements.
If the current clock is high and does not go low within 32
cycles of BASE_PCR_CLK
it is
assumed to be inactive and is asynchronously forced low. This prevents deadlocks on the
interface.
6.15.2.2
PLL functional description
A block diagram of the PLL is shown in
Figure 14
. The input clock is fed directly to the
analog section. This block compares the phase and frequency of the inputs and generates
the main clock
2
. These clocks are either divided by 2
×
P by the programmable post
divider to create the output clock, or sent directly to the output. The main output clock is
then divided by M by the programmable feedback divider to generate the feedback clock.
The output signal of the analog section is also monitored by the lock detector to signal
when the PLL has locked onto the input clock.
2.
Generation of the main clock is restricted by the frequency range of the PLL clock input. See
Table 35
, Dynamic characteristics.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2921FBD100 | ARM9 microcontroller with CAN, LIN, and USB |
| LPC2923FBD100 | ARM9 microcontroller with CAN, LIN, and USB |
| LPC2925FBD100 | ARM9 microcontroller with CAN, LIN, and USB |
| LPC2926FBD144 | ARM9 microcontroller with CAN, LIN, and USB |
| LPC2927FBD144 | ARM9 microcontroller with CAN, LIN, and USB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2919FBD144,551 | 功能描述:ARM微控制器 - MCU ARM968 768K FL/48K RAM LIN 2.0 RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2919FBD144/01 | 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM968E-S, 125MHZ, LQFP-144 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM968E-S, 125MHZ, LQFP-144, Controller Family/Series:LPC2900, Core Size:32bit, No. of I/O's:108, Supply Voltage Min:1.71V, Supply Voltage Max:1.89V, Digital IC Case Style:LQFP, No. of Pins:144, Program Memory Size:768KB, |
| LPC2919FBD144/01/ | 制造商:NXP Semiconductors 功能描述:MCU ARM9 144LQFP |
| LPC2919FBD144/01/, | 功能描述:ARM微控制器 - MCU ARM968 768K FL/48K RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2919FBD144/01-S | 功能描述:ARM微控制器 - MCU ARM968 768K FL/48K RAM LIN 2.0 RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。