- 您現在的位置：買賣IC網 > PDF目錄5730 > LT1102ACN8 (Linear Technology)IC PREC INSTRMNT-AMP JFET 8-DIP PDF資料下載
參數資料
| 型號： | LT1102ACN8 |
| 廠商： | Linear Technology |
| 文件頁數： | 11/12頁 |
| 文件大小： | 0K |
| 描述： | IC PREC INSTRMNT-AMP JFET 8-DIP |
| 標準包裝： | 50 |
| 放大器類型： | 儀表 |
| 電路數： | 1 |
| 轉換速率： | 30 V/µs |
| 增益帶寬積： | 3.5MHz |
| 電流 - 輸入偏壓： | 3pA |
| 電壓 - 輸入偏移： | 180µV |
| 電流 - 電源： | 3.3mA |
| 電壓 - 電源，單路/雙路(±)： | ±9 V ~ 18 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
LT1102
8
1102fb
In the two op amp instrumentation amplifier configura-
tion, the first amplifier is basically in unity gain, and the
second amplifier provides all the voltage gain. In the
LT1102, the second amplifier is decompensated for gain
of 10 stability, therefore high slew rate and bandwidth are
achieved. Common mode rejection versus frequency
is also optimized in the G = 10 mode, because the
bandwidths of the two op amps are similar. When G = 100,
this statement is no longer true; however, by connecting
an 18pF capacitor between pins 1 and 2, a common mode
AC gain is created to cancel the inherent roll-off. From
200Hz to 30kHz, CMRR versus frequency is improved by
an order of magnitude.
Input Protection
Instrumentation amplifiers are often used in harsh
environments where overload conditions can occur.
The LT1102 employs FET input transistors, consequently
the differential input voltage can be
±30V (with ±15V
supplies,
±36V with ±18V supplies). Some competitive
instrumentation amplifiers have NPN inputs which are
protected by back-to-back diodes. When the differential
input Voltage exceeds
±13Vonthesecompetitivedevices,
input current increases to milliampere level; more than
±10V differential voltage can cause permanent damage.
When the LT1102 inputs are pulled below the negative
supply or above the positive supply, the inputs will clamp
a diode voltage below or above the supplies. No damage
will occur if the input current is limited to 20mA.
Common Mode Rejection Ratio
vs Frequency
Gains Between 10 and 100
Gains between 10 and 100 can be achieved by connecting
two equal resistors (= RX) between pins 1 and 2 and pins
7 and 8.
The nominal value of R is 1.84k
Ω. The usefulness of this
method is limited by the fact that R is not controlled to
better than
±10% absolute accuracy in production.
However, on any specific unit, 90R can be measured
between Pins 1 and 2.
APPLICATIO S I FOR ATIO
WU
UU
Gain = 10 +
RX
R + RX/90
FREQUENCY (Hz)
1
0
COMMON
MODE
REJECTION
RATIO
(dB)
20
40
60
80
120
10
100
1k
10k
100k
1M
100
LT1102 AI01
VS = ±15V
TA = 25°C
G = 100
18pF PIN 1
TO PIN 2
G = 10
G = 100
相關PDF資料 |
PDF描述 |
|---|---|
| LT1167AIS8-1#PBF | IC INSTRUMENT AMP PROG 8SOIC |
| LT1210CS#PBF | IC CURRNT FEEDBK AMP 1.1A 16SOIC |
| RNCF1206DTE174R | RES 174 OHM 1/8W 0.5% 1206 |
| LT1499HS#PBF | IC OPAMP GP RR 10MHZ QUAD 14SOIC |
| LT1469ACDF-2#TRPBF | IC OPAMP 16BIT DUAL 200MHZ 12DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1102ACN8#PBF | 功能描述:IC PREC INSTRMNT-AMP JFET 8-DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LT1102AM | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Speed, Precision, JFET Input Instrumentation Amplifier(Fixed Gain=10 or 100) |
| LT1102AMH | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Speed, Precision, JFET Input Instrumentation Amplifier(Fixed Gain=10 or 100) |
| LT1102C | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Speed, Precision, JFET Input Instrumentation Amplifier(Fixed Gain=10 or 100) |
| LT1102CH | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Speed, Precision, JFET Input Instrumentation Amplifier (Fixed Gain = 10 or 100) |
發布緊急采購，3分鐘左右您將得到回復。