- 您現在的位置：買賣IC網 > PDF目錄5801 > LT1113ACN8 (Linear Technology)IC PREC OP-AMP JFET DUAL 8-DIP PDF資料下載
參數資料
| 型號： | LT1113ACN8 |
| 廠商： | Linear Technology |
| 文件頁數： | 16/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PREC OP-AMP JFET DUAL 8-DIP |
| 標準包裝： | 50 |
| 放大器類型： | J-FET |
| 電路數： | 2 |
| 轉換速率： | 3.9 V/µs |
| 增益帶寬積： | 5.6MHz |
| 電流 - 輸入偏壓： | 300pA |
| 電壓 - 輸入偏移： | 400µV |
| 電流 - 電源： | 5.3mA |
| 電壓 - 電源，單路/雙路(±)： | ±4.5 V ~ 20 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁
9
LT1113
1113fb
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
This means the LT1113 will beat out any dual JFET op amp,
only the lowest noise bipolar op amps have the edge
(at low source resistances). As the source resistance
increases from 5k to 50k, the LT1113 will match the best
bipolar op amps for noise performance, since the thermal
noise of the transducer (4kTR) begins to dominate the
total noise. A further increase in source resistance, above
50k, is where the op amp’s current noise component (2qIB
RTRANS) will eventually dominate the total noise. At these
high source resistances, the LT1113 will out perform
the lowest noise bipolar op amp due to the inherently low
current noise of FET input op amps. Clearly, the LT1113
will extend the range of high impedance transducers
that can be used for high signal to noise ratios. This
makes the LT1113 the best choice for high impedance,
capacitive transducers.
The high input impedance JFET front end makes the
LT1113 suitable in applications where very high charge
sensitivity is required. Figure 2 illustrates the LT1113 in its
inverting and noninverting modes of operation. A charge
amplifier is shown in the inverting mode example; here the
gain depends on the principal of charge conservation at
the input of the LT1113. The charge across the transducer
capacitance, CS, is transferred to the feedback capacitor
CF, resulting in a change in voltage, dV, equal to dQ/CF.
Figure 1. Comparison of LT1113 and LT1124 Total Output 1kHz Voltage Noise Versus Source Resistance
SOURCE RESISTANCE (
)
100
1
10
1k
100M
1113 F01
100k
100
10M
10k
1M
RESISTOR NOISE ONLY
INPUT
NOISE
VOLTAGE
(nV/
√
Hz)
Vn = AV √Vn
2
(OP AMP) + 4kTR + 2q IB R
2
+
–
CS
RS
VO
CS
RS
LT1124
LT1113
LT1124*
LT1113*
SOURCE RESISTANCE = 2RS = R
* PLUS RESISTOR
PLUS RESISTOR 1000pF CAPACITOR
LT1113
LT1124
The LT1113 dual in the plastic and ceramic DIP packages
are pin compatible with and directly replace such JFET op
amps as the OPA2111 and OPA2604 with improved noise
performance. Being the lowest noise dual JFET op amp
available to date, the LT1113 can replace many bipolar op
amps that are used in amplifying low level signals from
high impedance transducers. The best bipolar op amps
will eventually loose out to the LT1113 when transducer
impedance increases due to higher current noise. The low
voltage noise of the LT1113 allows it to surpass every dual
and most single JFET op amps available. For the best
performance versus area available anywhere, the LT1113
is offered in the narrow SO-8 surface mount package with
standard pinout and no degradation in performance.
The low voltage and current noise offered by the LT1113
makes it useful in a wide range of applications, especially
where high impedance, capacitive transducers are used
such as hydrophones, precision accelerometers and photo
diodes. The total output noise in such a system is the gain
times the RMS sum of the op amp input referred voltage
noise, the thermal noise of the transducer, and the op amp
bias current noise times the transducer impedance.
Figure 1 shows total input voltage noise versus source
resistance. In a low source resistance (<5k) application
the op amp voltage noise will dominate the total noise.
相關PDF資料 |
PDF描述 |
|---|---|
| 68764-436 | BERGSTIK II SR RIGHT ANGLE |
| 0001.2515 | FUSE 12.5A 250V 5X20 T-LAG CERM |
| 327043 | CONN SPADE 16-22 AWG #6 RED P-G |
| 1206SFH150F/24-2 | FUSE 15A 24V FAST SMD 1206 |
| 52951-1 | CONN SPAD SPRNG 16-22 AWG #10 PG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1113ACN8#PBF | 功能描述:IC PREC OP-AMP JFET DUAL 8-DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:13 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:65pA 電壓 - 輸入偏移:3000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT1113AM | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Low Noise, Precision, JFET Input Op Amps |
| LT1113AMJ8 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Low Noise, Precision, JFET Input Op Amps |
| LT1113C | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Low Noise, Precision, JFET Input Op Amps |
| LT1113CN8 | 功能描述:IC PREC OP-AMP JFET DUAL 8-DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:350 V/µs 增益帶寬積:180MHz -3db帶寬:320MHz 電流 - 輸入偏壓:12.5µA 電壓 - 輸入偏移:800µV 電流 - 電源:15mA 電流 - 輸出 / 通道:85mA 電壓 - 電源，單路/雙路(±):2.5 V ~ 12.6 V，±1.25 V ~ 6.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。