RF = 1k, RG
參數資料
型號: LT1227CS8#PBF
廠商: Linear Technology
文件頁數: 11/12頁
文件大?。?/td> 0K
描述: IC VIDEO CURRNT FEEDBK AMP 8SOIC
標準包裝: 100
應用: 電流反饋
電路數: 1
-3db帶寬: 140MHz
轉換速率: 1100 V/µs
電流 - 電源: 10mA
電流 - 輸出 / 通道: 60mA
電壓 - 電源,單路/雙路(±): 4 V ~ 30 V,±2 V ~ 15 V
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SOIC
包裝: 管件
產品目錄頁面: 1318 (CN2011-ZH PDF)
8
LT1227
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
RF = 1k, RG= 1k, RL = 100
VOUT
Small-Signal Rise Time, AV = +2
and inverting input bias current will change. The offset
voltage changes about 500
V per volt of supply mis-
match. The inverting bias current can change as much as
5.0
A per volt of supply mismatch, though typically the
change is less than 0.5
A per volt.
Slew Rate
The slew rate of a current feedback amplifier is not
independent of the amplifier gain configuration the way
slew rate is in a traditional op amp. This is because both the
input stage and the output stage have slew rate limitations.
In the inverting mode, and for higher gains in the
noninverting mode, the signal amplitude between the
input pins is small and the overall slew rate is that of the
output stage. For gains less than ten in the noninverting
mode, the overall slew rate is limited by the input stage.
The input stage slew rate of the LT1227 is approximately
125V/
s and is set by internal currents and capacitances.
The output slew rate is set by the value of the feedback
resistors and the internal capacitances. At a gain of ten
with a 1k feedback resistor and
±15V supplies, the output
slew rate is typically 1100V/
s. Larger feedback resistors
will reduce the slew rate as will lower supply voltages,
similar to the way the bandwidth is reduced.
The graph of Maximum Undistorted Output vs Frequency
relates the slew rate limitations to sinusoidal inputs for
various gain configurations.
AI01
VOUT
RF = 910, RG= 100, RL = 400
Large-Signal Transient Response, AV = +10
AI02
Capacitance on the Inverting Input
Current feedback amplifiers require resistive feedback
from the output to the inverting input for stable operation.
Take care to minimize the stray capacitance between the
output and the inverting input. Capacitance on the invert-
ing input to ground will cause peaking in the frequency
response (and overshoot in the transient response), but it
does not degrade the stability of the amplifier.
Capacitive Loads
The LT1227 can drive capacitive loads directly when the
proper value of feedback resistor is used. The graph of
Maximum Capacitive Load vs Feedback Resistor should
be used to select the appropriate value. The value shown
is for 5dB peaking when driving a 1k load at a gain of 2. This
is a worst case condition, the amplifier is more stable at
higher gains and driving heavier loads. Alternatively, a
small resistor (10
to 20) can be put in series with the
output to isolate the capacitive load from the amplifier
output. This has the advantage that the amplifier band-
width is only reduced when the capacitive load is present
and the disadvantage that the gain is a function of the load
resistance.
Power Supplies
The LT1227 will operate from single or split supplies from
±2V (4V total) to ±15V (30V total). It is not necessary to
use equal value split supplies, however the offset voltage
相關PDF資料
PDF描述
VE-B63-MU CONVERTER MOD DC/DC 24V 200W
AD813ARZ-14 IC TRPL VIDEO AMP SNGL LP 14SOIC
VI-21J-IV-F1 CONVERTER MOD DC/DC 36V 150W
VE-B62-MU CONVERTER MOD DC/DC 15V 200W
VE-23R-IV-F2 CONVERTER MOD DC/DC 7.5V 150W
相關代理商/技術參數
參數描述
LT1227M 制造商:LINER 制造商全稱:Linear Technology 功能描述:140MHz Video Current Feedback Amplifier
LT1227MJ8 制造商:Linear Technology 功能描述:OP Amp Single Current Fdbk 15V 8-Pin CDIP
LT1228 制造商:LINER 制造商全稱:Linear Technology 功能描述:100MHz Current Feedback Amplifier with DC Gain Control
LT1228_07 制造商:LINER 制造商全稱:Linear Technology 功能描述:100MHz Current Feedback Amplifier with DC Gain Control
LT1228_12 制造商:LINER 制造商全稱:Linear Technology 功能描述:100MHz Current Feedback