- 您現在的位置：買賣IC網 > PDF目錄3435 > LT1970CFE#TRPBF (Linear Technology)IC OPAMP ADJ CURR LIMIT 20-TSSOP PDF資料下載
參數資料
| 型號： | LT1970CFE#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/26頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP ADJ CURR LIMIT 20-TSSOP |
| 標準包裝： | 2,500 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 轉換速率： | 1.6 V/µs |
| 增益帶寬積： | 3.6MHz |
| 電流 - 輸入偏壓： | 160nA |
| 電壓 - 輸入偏移： | 200µV |
| 電流 - 電源： | 7mA |
| 電流 - 輸出 / 通道： | 800mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 36 V，±2.5 V ~ 18 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬）裸露焊盤 |
| 供應商設備封裝： | 20-TSSOP-EP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
LT1970
12
1970fc
APPLICATIONS INFORMATION
ENABLE Control
The ENABLE input pin puts the LT1970 into a low sup-
ply current, high impedance output state. The ENABLE
pin responds to TTL threshold levels with respect to the
COMMON pin. Pulling the ENABLE pin low is the best
way to force zero current at the output. Setting VCSNK =
VCSRC = 0V allows the output current to remain as high
as ± 4mV/RSENSE.
In applications such as circuit testers (ATE), it may be
preferable to apply a predetermined test voltage with a
preset current limit to a test node simultaneously. The
ENABLE pin can be used to provide this gating action as
shown in Figure 2. While the LT1970 is disabled, the load
is essentially oating and the input voltage and current
limit control voltages can be set to produce the load test
levels. Enabling the LT1970 then drives the load. The
LT1970 enables and disables in just a few microseconds.
The actual enable and disable times at the load are a
function of the load reactance.
Operating Status Flags
The LT1970 has three digital output indicators; TSD, ISRC
and ISNK. These outputs are open collector drivers referred
to the COMMON pin. The outputs have 36V capabilities
and can sink in excess of 10mA. ISRC and ISNK indicate
activation of the associated current limit amplier. The TSD
output indicates excessive die temperature has caused the
circuit to enter thermal shutdown. The three digital outputs
may be wire “OR’d” together, monitored individually or left
open. These outputs do not affect circuit operation, but
provide an indication of the present operational status of
the chip.
For slow varying output signals, the assertion of a low level
at the current limit output ags occurs when the current
limit threshold is reached. For fast moving signals where
the LT1970 output is moving at the slew limit, typically
1.6V/μs, the ag assertion can be somewhat premature
at typically 75% of the actual current limit value.
The operating status ags are designed to drive LEDs to
provide a visual indication of current limit and thermal
conditions. As such, the transition edges to and from
the active low state are not particularly sharp and may
exhibit some uncertainty. Adding some positive feedback
to the current limit control inputs helps to sharpen these
transitions.
With the values shown in Figure 3, the current limit thresh-
old is reduced by approximately 0.5% when either current
limit status ag goes low. With sharp logic transitions, the
status outputs can be used in a system control loop to
Figure 2. Using the ENABLE pin
VCSRC
COMMON
VEE
VCSNK
V–
FILTER
V+
12V
EN
VCC
ISNK
ISRC
SENSE–
SENSE+
TSD
OUT
+IN
5V
0V
5V
ENABLE
DISABLE
VIN
LT1970
–12V
–IN
RS
1Ω
RL
10Ω
1970 F02
RG
10k
RF
10k
EN
10V/DIV
0V
VOUT
1V/DIV
5μs/DIV
0V
VIN = 0.5V
VIN = –0.5V
相關PDF資料 |
PDF描述 |
|---|---|
| 2036-9-B2FLF | GAS DISCHARGE TUBE |
| 1-644876-6 | CONN HEADER 16POS VERT .100 TIN |
| LT1970CFE#TR | IC OPAMP ADJ CURR LIMIT 20-TSSOP |
| 1-644876-2 | CONN HEADER 12POS VERT .100 TIN |
| 2036-7-C2FLF | GAS DISCHARGE TUBE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1970IFE | 功能描述:IC OP AMP 500MA ADJ 20-TSSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT1970IFE#PBF | 功能描述:IC OP AMP 500MA ADJ 20-TSSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT1970IFE#PBF | 制造商:Linear Technology 功能描述:OP-AMP PRECISION 3.6MHZ 1.6 制造商:Linear Technology 功能描述:OP-AMP, PRECISION, 3.6MHZ, 1.6V/uS, TSSO |
| LT1970IFE#TR | 功能描述:IC OPAMP ADJ PREC 500MA 20TSSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT1970IFE#TRPBF | 功能描述:IC OP AMP 500MA ADJ 20-TSSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。