- 您現在的位置：買賣IC網 > PDF目錄8614 > LT6350HMS8#PBF (Linear Technology)IC DIFF CONVERT/ADC DRIVER 8MSOP PDF資料下載
參數資料
| 型號： | LT6350HMS8#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 24/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DIFF CONVERT/ADC DRIVER 8MSOP |
| 標準包裝： | 50 |
| 類型： | ADC 驅動器 |
| 應用： | 數據采集 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 管件 |
| 配用： | DC1783A-H-ND - BOARD SAR ADC LTC2376-18 DC1783A-G-ND - BOARD SAR ADC LTC2377-18 DC1783A-F-ND - BOARD SAR ADC LTC2378-18 DC1783A-E-ND - BOARD SAR ADC LTC2379-18 DC1783A-D-ND - BOARD SAR ADC LTC2376-16 DC1783A-C-ND - BOARD SAR ADC LTC2377-16 DC1783A-B-ND - BOARD SAR ADC LTC2378-16 DC1783A-A-ND - BOARD SAR ADC LTC2380-16 DC1500A-C-ND - BOARD SAR ADC LTC2391-16 DC1500A-B-ND - BOARD SAR ADC LTC2392-16 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁
LT6350
5
6350fc
For more information www.linear.com/LT6350
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Inputs are protected by diodes to each supply. Additionallly,
op amp inputs +IN1, –IN1 and +IN2 are protected by back-to-back diodes
across the op amp inputs. If inputs are taken beyond the supplies or if
either op amp’s differential input voltage exceeds 0.7V, the input current
must be limited to less than 20mA.
Note 3: A heat sink may be required to keep the junction temperature
below the absolute maximum rating when the output is shorted indefinitely.
Note 4: The LT6350C/LT6350I are guaranteed functional over the
temperature range of –40°C to 85°C. The LT6350H is guaranteed
functional over the temperature range of –40°C to 125°C.
Note 5: The LT6350C is guaranteed to meet specified performance from
0°C to 70°C. The LT6350C is designed, characterized and expected to
meet specified performance from –40°C to 85°C, but is not tested or
QA sampled at these temperatures. The LT6350I is guaranteed to meet
specified performance from –40°C to 85°C. The LT6350H is guaranteed to
meet specified performance from –40°C to 125°C.
Note 6: VOS2 is measured as the total output common mode voltage offset
(error between output common mode and voltage at V2). VOS2 includes
the combined effects of op amp 2’s voltage offset, IB, IOS and mismatch
between on-chip resistors and the 499Ω external resistor, R1 (See Figure 1).
Note 7: Supply voltage range is guaranteed by the power supply rejection
ratio test.
Note 8: Output balance is calculated from gain error and gain as:
BAL
GAIN
GAINERR
=
Note 9: DC linearity is measured by measuring the differential output for
each input in the set V+IN1 = 0.5V, 2.5V, 4.5V, and calculating the maximum
deviation from the least squares best fit straight line generated from the
three data points.
Note 10: Output voltage swings are measured between the output and
power supply rails.
Note 11: Full- power bandwidth is calculated from the slew rate.
FPBW = SR/2VP.
elecTrical characTerisTics The
l
denotes specifications that apply over the full specified temperature range,
otherwise specifications are at TA = 25°C. Unless noted otherwise, V+ = 5V, V– = 0V, V+IN1 = V2 = Mid-Supply, VSHDN = V+, RL = OPEN, RF =
SHORT, RG = OPEN. VS is defined as (V+ – V–). VOUTCM is defined as (VOUT1 + VOUT2)/2. VOUTDIFF is defined as (VOUT1 – VOUT2). See Figure 1.
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
FPBW
Full-Power Bandwidth (Note 11)
VOUTDIFF = 8VP-P
1.6
MHz
CL
Capacitive Load Drive, 20% Overshoot
No Series Output Resistors
56
pF
SR
Differential Slew Rate
OUT1 Rising (OUT2 Falling)
OUT1 Falling (OUT2 Rising)
48
41
V/s
HD2
HD3
10kHz Distortion
VS = 5V, VOUTDIFF = 4VP-P, RL = 2kΩ
2nd Harmonic
3rd Harmonic
–115
dBc
HD2
HD3
100kHz Distortion
VS = 5V, VOUTDIFF = 4VP-P, RL = 2kΩ
2nd Harmonic
3rd Harmonic
–102
–97
dBc
HD2
HD3
1MHz Distortion
VS = 5V, VOUTDIFF = 4VP-P, RL = 2kΩ
2nd Harmonic
3rd Harmonic
–86
–75
dBc
tS
Settling Time to a 4V Input Step
0.1%
0.01%
0.0015% (±1LSB, 16-Bit, Falling Edge)
200
240
350
ns
tOVDR
Overdrive Recovery Time
+IN1 to V– and V+
200
ns
tON
Turn-On Time
VSHDN = 0V to 5V
400
ns
tOFF
Turn-Off Time
VSHDN = 5V to 0V
400
ns
相關PDF資料 |
PDF描述 |
|---|---|
| LT6350HDD#PBF | IC DIFF CONVERT/ADC DRIVER 8-DFN |
| VI-2TN-IV-F3 | CONVERTER MOD DC/DC 18.5V 150W |
| VI-2TM-MW-B1 | CONVERTER MOD DC/DC 10V 100W |
| VI-2TN-IV-F2 | CONVERTER MOD DC/DC 18.5V 150W |
| VI-2TL-IV-F4 | CONVERTER MOD DC/DC 28V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6350HMS8TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Low Noise Single-Ended to Differential Converter/ADC Driver |
| LT6350IDD#PBF | 功能描述:IC DIFF CONVERT/ADC DRIVER 8-DFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LT6350IDD#TRPBF | 功能描述:IC DIFF CONVERT/ADC DRIVER 8-DFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LT6350IDDPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Low Noise Single-Ended to Differential Converter/ADC Driver |
| LT6350IDDTRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Low Noise Single-Ended to Differential Converter/ADC Driver |
發布緊急采購，3分鐘左右您將得到回復。