- 您現在的位置：買賣IC網 > PDF目錄5894 > LT6600IS8-10#TR (Linear Technology)IC AMP DIFF FILTER 2.5MHZ 8SOIC PDF資料下載
參數資料
| 型號： | LT6600IS8-10#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 2/16頁 |
| 文件大小： | 0K |
| 描述： | IC AMP DIFF FILTER 2.5MHZ 8SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 差分 |
| 電路數： | 1 |
| 輸出類型： | 差分 |
| 電流 - 輸入偏壓： | 40µA |
| 電壓 - 輸入偏移： | 8000µV |
| 電流 - 電源： | 36mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 11 V，±1.5 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
LT6600-10
10
66001fe
APPLICATIONS INFORMATION
Figure 5, present the output of the LT6600-10 with a 1600Ω
differential load, or the equivalent of 800Ω to ground at
each output. The impedance seen by the network analyzer
input is still 50Ω, reducing reections in the cabling be-
tween the transformer and analyzer input.
voltage of VMID. While the internal 11k resistors are well
matched, their absolute value can vary by ±20%. This
should be taken into consideration when connecting an
external resistor network to alter the voltage of VMID.
Figure 5. (S8 Pin Numbers)
–
+
0.1μF
2.5V
–2.5V
–
+
LT6600-10
3
4
1
7
2
8
5
6
6600 F05
402Ω
NETWORK
ANALYZER
INPUT
50Ω
COILCRAFT
TTWB-16A
4:1
NETWORK
ANALYZER
SOURCE
COILCRAFT
TTWB-1010
1:1
50Ω
53.6Ω
388Ω
Figure 6
1MHz INPUT LEVEL (VP-P)
0
20
0
–20
–40
–60
–80
–100
–120
35
6600 F06
12
46
OUTPUT
LEVEL
(dBV)
3RD HARMONIC
85°C
1dB PASSBAND GAIN
COMPRESSION POINTS
1MHz 25°C
1MHz 85°C
3RD HARMONIC
25°C
2ND HARMONIC
25°C
2ND HARMONIC
85°C
Differential and Common Mode Voltage Ranges
The differential ampliers inside the LT6600-10 contain
circuitry to limit the maximum peak-to-peak differential
voltage through the lter. This limiting function prevents
excessive power dissipation in the internal circuitry
and provides output short-circuit protection. The limiting
function begins to take effect at output signal levels above
2VP-P and it becomes noticeable above 3.5VP-P. This is
illustrated in Figure 6; the LTC6600-10 was congured with
unity passband gain and the input of the lter was driven
with a 1MHz signal. Because this voltage limiting takes
place well before the output stage of the lter reaches the
supply rails, the input/output behavior of the IC shown
in Figure 6 is relatively independent of the power supply
voltage.
The two ampliers inside the LT6600-10 have independent
control of their output common mode voltage (see the
Block Diagram section). The following guidelines will
optimize the performance of the lter for single-supply
operation.
VMID must be bypassed to an AC ground with a 0.01μF or
higher capacitor. VMID can be driven from a low impedance
source, provided it remains at least 1.5V above V– and at
least 1.5V below V+. An internal resistor divider sets the
VOCM can be shorted to VMID for simplicity. If a different
common mode output voltage is required, connect VOCM
to a voltage source or resistor network. For 3V and 3.3V
supplies the voltage at VOCM must be less than or equal to
the mid-supply level. For example, voltage (VOCM) ≤1.65V
on a single 3.3V supply. For power supply voltages higher
than 3.3V the voltage at VOCM can be set above mid-supply.
The voltage on VOCM should not be more than 1V below
the voltage on VMID. The voltage on VOCM should not be
more than 2V above the voltage on VMID. VOCM is a high
impedance input.
The LT6600-10 was designed to process a variety of input
signals including signals centered around the mid-supply
voltage and signals that swing between ground and a
positive voltage in a single-supply system (Figure 1).
The range of allowable input common mode voltage (the
average of VIN+ and VIN– in Figure 1) is determined by
the power supply level and gain setting (see the Electrical
Characteristics section).
Common Mode DC Currents
In applications like Figure 1 and Figure 3 where the
LT6600-10 not only provides lowpass ltering but also level
shifts the common mode voltage of the input signal, DC
相關PDF資料 |
PDF描述 |
|---|---|
| 77313-101-16LF | BERGSTIK |
| TMM-147-01-T-D-SM | CONN HEADER 94POS DUAL 2MM SMD |
| RL0805FR-070R3L | RES .30 OHM 1/8W 1% 0805 SMD |
| TMM-138-01-G-S-SM | CONN HEADER 38POS SNGL 2MM SMD |
| 77311-118R03LF | HDR STR SR.100 GDP RET-2 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6600IS8-15 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Very Low Noise, Differential Amplifi er and 15MHz Lowpass Filter |
| LT6600IS8-15#PBF | 功能描述:IC AMP DIFF LP FLTR 15MHZ 8-SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
| LT6600IS8-15#TRPBF | 功能描述:IC AMP DIFF LP FLTR 15MHZ 8-SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:73 系列:Over-The-Top® 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.07 V/µs 增益帶寬積:200kHz -3db帶寬:- 電流 - 輸入偏壓:1nA 電壓 - 輸入偏移:285µV 電流 - 電源:50µA 電流 - 輸出 / 通道:25mA 電壓 - 電源，單路/雙路(±):2 V ~ 44 V，±1 V ~ 22 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-WFDFN 裸露焊盤 供應商設備封裝:16-DFN-EP（5x3） 包裝:管件 |
| LT6600IS8-15-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Very Low Noise, Differential Amplifi er and 15MHz Lowpass Filter |
| LT6600IS8-15-TR | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Very Low Noise, Differential Amplifi er and 15MHz Lowpass Filter |
發布緊急采購，3分鐘左右您將得到回復。