- 您現在的位置：買賣IC網 > PDF目錄1933 > LTC1090ACN (Linear Technology)IC DATA ACQUIS SYS 10BIT 20-DIP PDF資料下載
參數資料
| 型號： | LTC1090ACN |
| 廠商： | Linear Technology |
| 文件頁數： | 14/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DATA ACQUIS SYS 10BIT 20-DIP |
| 標準包裝： | 18 |
| 類型： | 數據采集系統（DAS），ADC |
| 分辨率（位）： | 10 b |
| 采樣率（每秒）： | 30k |
| 數據接口： | 串行 |
| 電壓電源： | 單/雙電源 |
| 電源電壓： | ±5V，5V，10V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 20-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 20-PDIP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
21
LTC1090
1090fc
MUX address bit is shifted in and continues during the
remainder of the data transfer. On the falling edge of the
final SCLK, the S&H goes into hold mode and the conver-
sion begins. The voltage will be held on either the 8th,
10th, 12th or 16th falling edge of the SCLK depending on
the word length selected.
Differential Inputs
With differential inputs or when the COM pin is not tied to
ground, the A/D no longer converts just a single voltage
but rather the difference between two voltages. In these
cases, the voltage on the selected “+” input is still sampled
and held and therefore may be rapidly time varying just as
in single ended mode. However, the voltage on the se-
lected “–” input must remain constant and be free of noise
and ripple throughout the conversion time. Otherwise, the
differencing operation may not be performed accurately.
The conversion time is 44 ACLK cycles. Therefore, a
change in the “–” input voltage during this interval can
“–” input this error would be:
VERROR (MAX) = VPEAK x 2 x π x f(“–”) x 44/fACLK
Where f(“–”) is the frequency of the “–” input voltage,
VPEAK is its peak amplitude and fACLK is the frequency of
the ACLK. In most cases VERROR will not be significant. For
a 60Hz signal on the “–” input to generate a 1/4LSB error
(1.25mV) with the converter running at ACLK = 2MHz, its
peak value would have to be 150mV.
5. Reference Inputs
The voltage between the reference inputs of the LTC1090
defines the voltage span of the A/D converter. The refer-
ence inputs look primarily like a 10k resistor but will
have transient capacitive switching currents due to the
switched capacitor conversion technique (see Figure 14).
During each bit test of the conversion (every 4 ACLK
cycles), a capacitive current spike will be generated on the
reference pins by the A/D. These current spikes settle
quickly and do not cause a problem. However, if slow
settling circuitry is used to drive the reference inputs, care
must be taken to insure that transients caused by these
current spikes settle completely during each bit test of the
conversion.
When driving the reference inputs, three things should be
kept in mind:
1. The source resistance (ROUT) driving the reference
inputs should be low (less than 1) to prevent DC
drops caused by the 1mA maximum reference current
(IREF).
2. Transients on the reference inputs caused by the
capacitive switching currents must settle completely
during each bit test (each 4 ACLK cycles). Figures 15
and 16 show examples of both adequate and poor
settling. Using a slower ACLK will allow more time for
the reference to settle. However, even at the maximum
ACLK rate of 2MHz most references and op amps can
be made to settle within the 2s bit time.
3. It is recommended that the REF– input be tied directly
to the analog ground plane. If REF– is biased at a voltage
other than ground, the voltage must not change during
a conversion cycle. This voltage must also be free of
noise and ripple with respect to analog ground.
Figure 14. Reference Input Equivalent Circuit
Figure 15. Adequate Reference Settling
HORIZONTAL: 1s/DIV
VERTICAL:
0.5mV/DIV
APPLICATIO S I FOR ATIO
WU
UU
LTC1090 AI19
ROUT
REF +
REF –
VREF
EVERY 4 ACLK CYCLES
10k
TYP
RON
5pF – 30pF
LTC1090
14
13
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1092CN8 | IC DAS SERIAL I/O 1CH 10BIT 8DIP |
| LTC1164-5CSW#TRPBF | IC FILTR 8TH ORDR LOWPASS 16SOIC |
| LTC1164-6CSW#TRPBF | IC FILTR 8TH ORDR LOWPASS 16SOIC |
| LTC1164-7CSW#TRPBF | IC FILTR 8TH ORDR LOWPASS 16SOIC |
| LTC1164ACSW#TRPBF | IC FILTER BUILDING BLOCK 24-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1090ACN#PBF | 功能描述:IC DATA ACQUIS SYS 10BIT 20-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| LTC1090AM | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single Chip 10-Bit Data Acquisition System |
| LTC1090AMJ | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single Chip 10-Bit Data Acquisition System |
| LTC1090C | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single Chip 10-Bit Data Acquisition System |
| LTC1090CJ | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single Chip 10-Bit Data Acquisition System |
發布緊急采購，3分鐘左右您將得到回復。