- 您現在的位置：買賣IC網 > PDF目錄377732 > LTC1142HV-ADJ (Linear Technology Corporation) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LTC1142HV-ADJ |
| 廠商： | Linear Technology Corporation |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 抗輻射高效，5安培開關穩壓器 |
| 文件頁數： | 16/20頁 |
| 文件大?。?/td> | 401K |
| 代理商： | LTC1142HV-ADJ |
16
LTC1142/LTC1142L/LTC1142HV
APPLICATIU
between Pins 1 (15) and 28 (14) should be as close as
possible to the LTC1142.
4. Does the (+) plate of C
IN
connect to the source of the
P-channel MOSFET as closely as possible This ca-
pacitor provides the AC current to the P-channel
MOSFET.
5. Is the input decoupling capacitor (1
μ
F/0.22
μ
F) con-
nected closely between Pin 24 (10) and power ground
[Pin 4 (18) for the LTC1142, Pin 5 (19) for the LTC1142-
ADJ] This capacitor carries the MOSFET driver peak
currents.
6. Are the shutdown Pins 2 and 16 for the LTC1142 (Pins
3 and 17 for the LTC1142-ADJ) actively pulled to
ground during normal operation Both Shutdown pins
are high impedance and must not be allowed to float.
Both pins can be driven by the same external signal if
needed.
7. For the LTC1142-ADJ adjustable applications, the re-
sistive divider R1, R2 must be connected between the
(+) plate of C
OUT
and signal ground.
W
U
U
Output Crowbar
An added feature to using an N-channel MOSFET as the
synchronous switch is the ability to crowbar the output
with the same MOSFET. Pulling the C
T
, Pin 25 (11) above
1.5V when the output voltage is greater than the desired
regulated value will turn “on” the N-channel MOSFET for
that regulator section.
A fault condition which causes the output voltage to go
above a maximum allowable value can be detected by
external circuitry. Turning on the N-channel MOSFET
when this fault is detected will cause large currents to flow
and blow the system fuse.
The N-channel MOSFET needs to be sized so it will safely
handle this overcurrent condition. The typical delay from
pulling the C
T
pin high and the NDrive Pin 6 (20) going high
is 250ns. Note: Under shutdown conditions, the N-chan-
nel is held OFF and pulling the C
T
pin high will not cause
the N-channel MOSFET to crowbar the output.
A simple N-channel FET can be used as an interface
between the overvoltage detect circuitry and the LTC1142
as shown in Figure 8.
LTC1142
INT V
CC
C
T
VN2222LL
PIN 26(12)
PIN 25(11)
FROM CROWBAR
DETECT CIRCUIT
(ACTIVE WHEN V
GATE
= V
IN
OFF WHEN V
GATE
= GND)
1142 F08
Figure 8. Output Crowbar Interface
Troubleshooting Hints
Since efficiency is critical to LTC1142 applications, it is
very important to verify that the circuit is functioning
correctly in both continuous and Burst Mode
operation.
The waveform to monitor is the voltage on the C
T
, Pins 25
and 11.
In continuous mode (I
LOAD
> I
BURST
) the voltage on the C
T
pin should be a sawtooth with a 0.9V
P-P
swing. This
voltage should never dip below 2V as shown in Figure 9a.
When load currents are low (I
LOAD
< I
BURST
) Burst Mode
operation occurs. The voltage on the C
T
pin now falls to
ground for periods of time as shown in Figure 9b.
3.3V
0V
(a) CONTINUOUS MODE OPERATION
3.3V
0V
(b) Burst Mode
OPERATION
1142 F09
Figure 9. C
T
Waveforms
Inductor current should also be monitored. Look to verify
that the peak-to-peak ripple current in continuous mode
operation is approximately the same as in Burst Mode
operation.
If Pin 25 or Pin 11 is observed falling to ground at high
output currents, it indicates poor decoupling or improper
grounding. Refer to the Board Layout Checklist.
Auxiliary Windings––Suppressing Burst Mode
Operation
The LTC1142 synchronous switch removes the normal
limitation that power must be drawn from the inductor
primary winding in order to extract power from auxiliary
windings. With synchronous switching, auxiliary outputs
may be loaded without regard to the primary output load,
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1142HVCG | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1142HVCG-ADJ | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1143CS | Enclosures; Leaded Process Compatible:Yes; Peak Reflow Compatible (260 C):Yes RoHS Compliant: Yes |
| LTC1143L-ADJ | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1143LCS-ADJ | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1142HVCG | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1142HVCG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1142HVCG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1142HVCG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1142HVCG-ADJ | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。