- 您現在的位置：買賣IC網 > PDF目錄10146 > LTC1411CG#TR (Linear Technology)IC A/D CONV 14BIT 2.5MSPS 36SSOP PDF資料下載
參數資料
| 型號： | LTC1411CG#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 15/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC A/D CONV 14BIT 2.5MSPS 36SSOP |
| 標準包裝： | 2,000 |
| 位數： | 14 |
| 采樣率（每秒）： | 2.5M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 325mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 36-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 36-SSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
| 其它名稱： | LTC1411CGTR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁
8
LTC1411
1411f
TEST CIRCUITS
Load Circuits for Access Timing
Load Circuits for Output Float Delay
1k
(A) Hi-Z TO VOH AND VOL TO VOH
CL
1k
5V
DN
(B) Hi-Z TO VOL AND VOH TO VOL
CL
1411 TC01
1k
(A) VOH TO Hi-Z
CL
1k
5V
DN
(B) VOL TO Hi-Z
CL
1411 TC02
APPLICATIO S I FOR ATIO
WU
UU
CONVERSION DETAILS
The LTC1411 uses a successive approximation algorithm
and an internal sample-and-hold circuit to convert an
analog signal to a 14-bit parallel output. The ADC is
complete with a precision reference, internal clock and a
programmable input range. The device is easy to interface
with microprocessors and DSPs. (Please refer to the
Digital Interface section for the data format.)
Conversions are started by a falling edge on the CONVST
input. Once a conversion cycle has begun, it cannot be
restarted. Between conversions, the ADC acquires the
analog input in preparation for the next conversion. In the
acquire phase, a minimum time of 100ns will provide
enough time for the sample-and-hold capacitors to ac-
quire the analog signal.
During the conversion, the internal differential 14-bit
capacitive DAC output is sequenced by the SAR from the
most significant bit (MSB) to the least significant bit
(LSB). The input is successively compared with the binary
weighted charges supplied by the differential capacitive
DAC. Bit decisions are made by a high speed comparator.
At the end of a conversion, the DAC output balances the
analog input (AIN+ – AIN–). The SAR contents (a 14-bit
data word) which represents the difference of AIN+ and
AIN– are loaded into the 14-bit output latches.
DYNAMIC PERFORMANCE
The LTC1411 has excellent high speed sampling capabil-
ity. FFT (Fast Fourier Transform) test techniques are used
to test the ADC’s frequency response, distortion and noise
at the rated throughput. By applying a low distortion sine
wave and analyzing the digital output using an FFT algo-
rithm, the ADC’s spectral content can be examined for
frequencies outside the fundamental. Figure 2a shows a
typical LTC1411 FFT plot.
Signal-to-Noise
The signal-to-(noise + distortion) ratio [S/N + D)] is the
ratio between the RMS amplitude of the fundamental input
frequency to the RMS amplitude of all other frequency
components at the A/D output. The output is band limited
to frequencies from the above DC and below half the
sampling frequency. Figure 2a shows a typical spectral
content with a 2.5MHz sampling rate and a 100kHz input.
The dynamic performance holds well to higher input
frequencies (see Figure 2b).
Figure 1. Simplified Block Diagram
OTR
D13
OGND
DVP
OVDD
CONTROL LOGIC
INTERNAL
CLOCK
14-BIT
ADC
OUTPUT
DRIVERS
14
+
–
PGA0
PGA1
CONVST
DGND
1411 F01
AIN
+
AIN
–
NAP
SLP
2
1
32
33
34
35
36
31
26
BUSY
27
D0
25
12
28
29
30
AVP
10
相關PDF資料 |
PDF描述 |
|---|---|
| AD1674ARZ-REEL | IC ADC SINGLE 12BIT 28SOIC |
| LTC2859IDD#TRPBF | IC TXRX RS485 20MBPS 10-DFN |
| IDT7201LA50J8 | IC MEM FIFO 512X9 50NS 32-PLCC |
| AD8394ACPZ-R7 | IC OPAMP ADSL/ADSL2 DL 24LFCSP |
| IDT7200L25JI8 | IC MEM FIFO 256X9 25NS 32-PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1411IG | 功能描述:IC A/D CONV 14BIT 2.5MSPS 36SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1411IG#PBF | 功能描述:IC A/D CONV 14BIT 2.5MSPS 36SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC1411IG#TR | 功能描述:IC A/D CONV 14BIT 2.5MSPS 36SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1411IG#TRPBF | 功能描述:IC A/D CONV 14BIT 2.5MSPS 36SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC1412CG | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。