- 您現在的位置：買賣IC網 > PDF目錄10682 > LTC1416CG (Linear Technology)IC A/D CONV 14BIT SAMPLNG 28SSOP PDF資料下載
參數資料
| 型號： | LTC1416CG |
| 廠商： | Linear Technology |
| 文件頁數： | 3/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC A/D CONV 14BIT SAMPLNG 28SSOP |
| 標準包裝： | 47 |
| 位數： | 14 |
| 采樣率（每秒）： | 400k |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 100mW |
| 電壓電源： | 雙 ± |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
11
LTC1416
APPLICATIONS INFORMATION
WU
U
Input Filtering
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC1416 noise and distortion. The small-signal band-
width of the sample-and-hold circuit is 15MHz. Any noise
or distortion products that are present at the analog inputs
will be summed over this entire bandwidth. Noisy input
circuitry should be filtered prior to the analog inputs to
minimize noise. A simple 1-pole RC filter is sufficient for
many applications. For example, Figure 7 shows a 1000pF
capacitor from AIN+ to ground and a 200 source resistor
to limit the input bandwidth to 800kHz. The 1000pF
capacitor also acts as a charge reservoir for the input
sample-and-hold and isolates the ADC input from sam-
pling glitch sensitive circuitry. High quality capacitors and
resistors should be used since these components can add
distortion. NPO and silver mica type dielectric capacitors
have excellent linearity. Carbon surface mount resistors
can also generate distortion from self-heating and from
damage that may occur during soldering. Metal film
surface mount resistors are much less susceptible to both
problems.
accommodate other input ranges often with little or no
additional circuitry. The following sections describe the
reference and input circuitry and how they affect the input
range.
Internal Reference
The LTC1416 has an on-chip, temperature compensated,
curvature corrected, bandgap reference that is factory
trimmed to 2.500V. It is connected internally to a reference
amplifier and is available at VREF (Pin 3). See Figure 8a. A
4k resistor is in series with the output so that it can be
easily overdriven by an external reference or other cir-
cuitry (see Figure 8b). The reference amplifier gains the
voltage at the VREF pin by 1.625 to create the required
internal reference voltage. This provides buffering be-
tween the VREF pin and the high speed capacitive DAC. The
VREF
REFCOMP
AGND
2.5V
4.0625V
3
4
5
22
F
1416 F08a
R1
4k
R2
80k
BANDGAP
REFERENCE
LTC1416
REF
AMP
R3
128k
Figure 8a. LTC1416 Reference Circuit
1
2
3
22
F
ANALOG
INPUT
1416 F08b
AIN
+
AIN
–
VREF
LTC1416
REFCOMP
AGND
4
5
5V
LT1019A-2.5
VOUT
VIN
Figure 8b. Using the LT1019-2.5 as an External Reference
1
2
3
1000pF
200
22
F
ANALOG
INPUT
1416 F07
AIN
+
AIN
–
VREF
LTC1416
REFCOMP
AGND
4
5
Figure 7. RC Input Filter
Input Range
The
±2.5V input range of the LTC1416 is optimized for low
noise and low distortion. Most op amps also perform best
over this same range, allowing direct coupling to the
analog inputs and eliminating the need for special transla-
tion circuitry.
Some applications may require other input ranges. The
LTC1416 differential inputs and reference circuitry can
相關PDF資料 |
PDF描述 |
|---|---|
| VE-BNY-MW-B1 | CONVERTER MOD DC/DC 3.3V 66W |
| VE-JWB-MY-F2 | CONVERTER MOD DC/DC 95V 50W |
| VE-BNM-MY-B1 | CONVERTER MOD DC/DC 10V 50W |
| VI-21Y-IV-B1 | CONVERTER MOD DC/DC 3.3V 99W |
| VI-20V-IX-B1 | CONVERTER MOD DC/DC 5.8V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1416CG#PBF | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC1416CG#TR | 功能描述:IC ADC 14BIT 400KSPS SMPL 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1416CG#TRPBF | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1416CGPBF | 制造商:Linear Technology 功能描述:ADC,LTC1416 14bit 400kSPS SSOP |
| LTC1416IG | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發布緊急采購，3分鐘左右您將得到回復。