- 您現在的位置：買賣IC網 > PDF目錄10151 > LTC1749CFW#TR (Linear Technology)IC ADC 12BIT 80MSPS SMPL 48TSSOP PDF資料下載
參數資料
| 型號： | LTC1749CFW#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 7/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 80MSPS SMPL 48TSSOP |
| 標準包裝： | 1,800 |
| 位數： | 12 |
| 采樣率（每秒）： | 80M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 1.69W |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-TFSOP（0.240"，6.10mm 寬） |
| 供應商設備封裝： | 48-TSSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
15
LTC1749
1749f
Input Range
The LTC1749 performance may be optimized by adjusting
the ADC’s input range to meet the requirements of the
application. For lower input frequency applications
(<40MHz), the highest input range of
±1.125V(2.25V)will
provide the best SNR while maintaining excellent SFDR.
For higher input frequencies (>80MHz), a lower input
range will provide better SFDR performance with a reduc-
tion in SNR.
The input range of the ADC is determined as
±VREF/APGA,
where VREF is the reference voltage (described in the
Reference Operation section) and APGA is the effective
APPLICATIO S I FOR ATIO
WU
UU
PGA gain. Table 1 shows the input range of the ADC versus
the state of the two pins, PGA and SENSE.
Driving the Encode Inputs
The noise performance of the LTC1749 can depend on the
encode signal quality as much as on the analog input. The
ENC/ENC inputs are intended to be driven differentially,
primarily for immunity from common mode noise sources.
Each input is biased through a 6k resistor to a 2V bias. The
bias resistors set the DC operating point for transformer
coupled drive circuits and can set the logic threshold for
single-ended drive circuits.
Any noise present on the encode signal will result in
additional aperture jitter that will be RMS summed with the
inherent ADC aperture jitter.
In applications where jitter is critical (high input frequen-
cies) take the following into consideration:
1. Differential drive should be used.
2. Use as large an amplitude as possible; if transformer
coupled use a higher turns ratio to increase the
amplitude.
3. If the ADC is clocked with a sinusoidal signal, filter the
encode signal to reduce wideband noise.
4. Balance the capacitance and series resistance at both
encode inputs so that any coupled noise will appear at
both inputs as common mode noise.
The encode inputs have a common mode range of 1.8V to
VDD. Each input may be driven from ground to VDD for
single-ended drive.
VCM
SENSE
2V
1V
4.7
F
10k
1
F
10k
1749 F06a
LTC1749
VCM
SENSE
2V
5V
2.5k
6
4
1, 2
4.7
F
1
F
1
F
10k
0.1
F
1749 F06b
LTC1749
LT1790-1.25
Figure 6a. 2V Range ADC
Figure 6b. 2V Range ADC with External Reference
Table 1
PGA
VSENSE
INPUT RANGE
COMMENTS
0= VDD
2.25VP-P Differential
Best Noise, SNR = 71.8dB. Good SFDR, >80dB Up to 100MHz
1= VDD
1.35VP-P Differential
Improved High Frequency Distortion. SNR = 70.5dB. SFDR > 80dB Up to 250MHz
0
= GND
1.4VP-P Differential
Reduced Internal Reference Mode with PGA = 0. Provides Similar Input Range as
VSENSE = VDD and PGA = 0 But with Worse Noise. SNR = 70.3dB
1
= GND
0.84VP-P Differential
Smallest Possible Input Span. Useful for Improved Distortion at Very High
Frequencies, But with Reduced Noise Performance. SNR = 69dB
0
0.7V < VSENSE < 1.125V
2
× VSENSE Differential
Adjustable Input Range with Better Noise Performance. SNR = 71.8dB with
VSENSE = 1.125V, SNR = 70.3dB with VSENSE = 0.7V
1
0.7V < VSENSE < 1.125V
1.2
× VSENSE Differential
Adjustable Input Range with Better High Frequency Distortion. SNR = 70.5dB with
VSENSE = 1.125V, SNR = 69dB with VSENSE = 0.7V
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1747CFW#TR | IC ADC SMPL 12BIT 80MSPS 48TSSOP |
| SN74ACT7807-20PAG | IC SYNC FIFO MEM 2048X9 64-TQFP |
| CXC3106A2821P | CONN PLUG 37POS STRGHT PIN |
| AD7892BRZ-1REEL | IC ADC 12BIT LP 500KSPS 24SOIC |
| MS3101R14S-2P | CONN RCPT 4POS PANEL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1749IFW | 功能描述:IC ADC 12BIT 80MSPS SMPL 48TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1749IFW#PBF | 功能描述:IC ADC 12BIT 80MSPS SMPL 48TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC1749IFW#TR | 功能描述:IC ADC 12BIT 80MSPS SMPL 48TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1749IFW#TRPBF | 功能描述:IC ADC 12BIT 80MSPS SMPL 48TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC1750CFW | 功能描述:IC ADC 14BIT 80MSPS SMPL 48TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。