參數資料
型號: LTC1983-3
廠商: Linear Technology Corporation
英文描述: 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT
中文描述: 100mA的穩壓電荷泵采用ThinSOT逆變器中
文件頁數: 6/12頁
文件大?。?/td> 188K
代理商: LTC1983-3
LTC1983-3/LTC1983-5
6
sn1983 1983fs
OPERATIOU
The LTC1983-3/LTC1983-5 use a switched capacitor
charge pump to invert a positive input voltage to a regu-
lated –3V
±
4% (LTC1983-3) or –5
±
4% (LTC1983-5)
output voltage. Regulation is achieved by sensing the
output voltage through an internal resistor divider and
enabling the charge pump when the output voltage droops
above the upper trip point of COMP1. When the charge
pump is enabled, a 2-phase, nonoverlapping clock con-
trols the charge pump switches. Clock 1 closes the S1
switches which enables the flying capacitor to charge up
to the V
IN
voltage. Clock 2 closes the S2 switches that
invert the V
IN
voltage and connect the bottom plate of C
FLY
to the output capacitor at V
OUT
. This sequence of charging
and discharging continues at a free-running frequency of
900kHz (typ) until the output voltage has been pumped
down to the lower trip point of COMP1 and the charge
pump is disabled. When the charge pump is disabled, the
LTC1983 draws only 25
μ
A (typ) from V
IN
which provides
high efficiency at low load conditions.
In shutdown mode, all circuitry is turned off and the part
draws less than 1
μ
A from the V
IN
supply. V
OUT
is also
disconnected from V
IN
and C
FLY
. The SHDN pin has a
threshold of approximately 0.7V. The part enters shut-
down when a low is applied to the SHDN pin . The SHDN
pin should not be floated; it must be driven with a logic
high or low.
Open-Loop Operation
The LTC1983-3/LTC1983-5 inverting charge pumps regu-
late at –3V/–5V respectively, unless the input voltage is too
low or the output current is too high. The equations for
output voltage regulation are as follows:
V
IN
–5.06V > I
OUT
R
OUT
(LTC1983-5)
V
IN
–3.06V > I
OUT
R
OUT
(LTC1983-3)
If this condition is not met, then the part will run in open
loop mode and act as a low output impedance inverter for
which the output voltage will be:
V
OUT
= –[V
IN
–(I
OUT
R
OUT
)]
For all R
OUT
values, check the corresponding curves in
the Typical Performance Characteristics section (Note:
C
FLY
= 1
μ
F for all R
OUT
curves). The R
OUT
value will be
different for different flying caps, as shown in the follow-
ing equation:
R
R
curve
(
f
C
OUT
OUT
OSC
FLY
=
+
)–1 11
1
Short-Circuit/Thermal Protection
During short-circuit conditions, the LTC1983 will draw
several hundred milliamps from V
IN
causing a rise in the
junction temperature. On-chip thermal shutdown cir-
cuitry disables the charge pump once the junction tem-
perature exceeds
155
°
C, and reenables the charge pump
once the junction temperature falls back to
145
°
C. The
LTC1983 will cycle in and out of thermal shutdown
indefinitely without latchup or damage until the V
OUT
short is removed.
Capacitor Selection
For best performance, it is recommended that low ESR
capacitors be used for both C
IN
and C
OUT
to reduce noise
and ripple. The C
IN
and C
OUT
capacitors should be either
ceramic or tantalum and should be 4.7
μ
F or greater.
Aluminum electrolytic are not recommended because of
their high equivalent series resistance (ESR). If the source
impedance is very low, C
IN
may not be needed. Increasing
the size of C
OUT
to 10
μ
F or greater will reduce output
voltage ripple. The flying capacitor and C
OUT
should also
have low equivalent series inductance (ESL). The board
layout is critical as well for inductance for the same reason
(the suggested board layout should be used).
A ceramic capacitor is recommended for the flying capaci-
tor with a value in the range of 0.1
μ
F to 4.7
μ
F. Note that
a large value flying cap (>1
μ
F) will increase output ripple
unless C
OUT
is also increased. For very low load applica-
tions, C1 may be reduced to 0.01
μ
F to 0.047
μ
F. This will
reduce output ripple at the expense of efficiency and
maximum output current.
(Refer to Block Diagram)
相關PDF資料
PDF描述
LTC1983ES6-3 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT
LTC1983ES6-5 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT
LTPC 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT
LTYB 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT
LTC1985-1.8 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors
相關代理商/技術參數
參數描述
LTC1983ES6-3 制造商:Linear Technology 功能描述:Charge Pump INV -3V/-2.3V to -5.5V 100mA 6-Pin TSOT-23
LTC1983ES6-3#PBF 制造商:Linear Technology 功能描述:Charge Pump INV -3V/-2.3V to -5.5V 100mA 6-Pin TSOT-23 制造商:Linear Technology 功能描述:IC INVERTING CHARGE PUMP CNV 6SOT23 制造商:Linear Technology 功能描述:IC, INVERTING CHARGE PUMP CNV, 6SOT23 制造商:Linear Technology 功能描述:IC, INVERTING CHARGE PUMP CONV, 6-SOT-23, Primary Input Voltage:5V, No. of Outputs:1, Output Voltage:-3V, Output Current:100mA, No. of Pins:6, Operating Temperature Min:-40C, Operating Temperature Max:85C, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-Charge Pump/General Purpose, CUT TAPE 100mA Inverting Charge Pump in ThinSOT
LTC1983ES6-3#TR 功能描述:IC REG SWITCHD CAP INV -3V SOT23 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器(充電泵),反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型,TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR
LTC1983ES6-3#TRM 功能描述:IC REG SWITCHD CAP INV -3V SOT23 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式,混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC
LTC1983ES6-3#TRMPBF 功能描述:IC REG SWITCHD CAP INV -3V SOT23 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色產品:BD91x Series Step-Down Regulators 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:兩者兼有 輸出數:2 輸出電壓:3.3V,0.8 V ~ 2.5 V 輸入電壓:4.5 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:1MHz 電流 - 輸出:1.5A 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:VQFN020V4040 產品目錄頁面:1373 (CN2011-ZH PDF) 其它名稱:BD9152MUV-E2TR