- 您現在的位置：買賣IC網 > PDF目錄377766 > LTC1983-3 (Linear Technology Corporation) 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT PDF資料下載
參數資料
| 型號： | LTC1983-3 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT |
| 中文描述： | 100mA的穩壓電荷泵采用ThinSOT逆變器中 |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 188K |
| 代理商： | LTC1983-3 |
LTC1983-3/LTC1983-5
7
sn1983 1983fs
There are many aspects of the capacitors that must be
taken into account. First, the temperature stability of the
dielectric is a main concern. For ceramic capacitors, a
three character code specifies the temperature stability
(e.g. X7R, Y5V, etc.). The first two characters represent
the temperature range that the capacitor is specified and
the third represents the absolute tolerance that the ca-
pacitor is specified to over that temperature range.
The
ceramic capacitor used for the flying and output capaci-
tors should be X5R or better
. Second, the voltage coef-
ficient of capacitance for the capacitor must be checked
and the actual value usually needs to be derated for the
operating voltage (the actual value has to be larger than
the value needed to take into account the loss of capaci-
tance due to voltage bias across the capacitor). Third, the
frequency characteristics need to be taken into account
because capacitance goes down as the frequency of
oscillation goes up. Typically, the manufacturers have
capacitance vs frequency curves for their products. This
curve must be referenced to be sure the capacitance will
not be too small for the application. Finally, the capacitor
ESR and ESL must be low for reasons mentioned in the
following section.
Output Ripple
Normal LTC1983 operation produces voltage ripple on the
V
OUT
pin. Output voltage ripple is required for the LTC1983
to regulate. Low frequency ripple exists due to the hyster-
esis in the sense comparator and propagation delays in the
charge pump enable/disable circuits. High frequency ripple
is also present mainly due to ESR of the output capacitor.
Typical output ripple under maximum load is 60mV
P-P
with a low ESR 10
μ
F output capacitor. The magnitude of
the ripple voltage depends on several factors. High input
voltage to negative output voltage differentials [(V
IN
+
V
OUT
) >1V] increase the output ripple since more charge
is delivered to C
OUT
per clock cycle. A large flying capacitor
(>1
μ
F) also increases ripple for the same reason. Large
output current load and/or a small output capacitor (<10
μ
F)
results in higher ripple due to higher output voltage dV/dt.
High ESR capacitors (ESR > 0.1
) on the output pin cause
high frequency voltage spikes on V
OUT
with every clock
cycle.
There are several ways to reduce the output voltage ripple.
A larger C
OUT
capacitor (22
μ
F or greater) will reduce both
the low and high frequency ripple due to the lower C
OUT
charging and discharging dV/dt and the lower ESR typi-
cally found with higher value (larger case size) capacitors.
A low ESR ceramic output capacitor will minimize the high
frequency ripple, but will not reduce the low frequency
ripple unless a high capacitance value is chosen. A reason-
able compromise is to use a 10
μ
F to 22
μ
F tantalum
capacitor in parallel with a 1
μ
F to 4.7
μ
F ceramic capacitor
on V
OUT
to reduce both the low and high frequency ripple.
However, the best solution is to use 10
μ
F to 22
μ
F, X5R
ceramic capacitors which are available in 1206 package
sizes. An RC filter may also be used to reduce high
frequency voltage spikes (see Figure 1).
In low load or high V
IN
applications, smaller values for
C
FLY
may be used to reduce output ripple. A smaller flying
capacitor (0.01
μ
F to 0.047
μ
F) delivers less charge per
clock cycle to the output capacitor resulting in lower
output ripple. However, the smaller value flying caps also
reduce the maximum I
OUT
capability as well as efficiency.
Figure 1. Output Ripple Reduction Techniques
V
OUT
V
OUT
LTC1983-X
10
μ
F
TANTALUM
10
μ
F
TANTALUM
V
OUT
V
OUT
LTC1983-X
15
μ
F
TANTALUM
1
μ
F
CERAMIC
3.9
1983 F01
OPERATIOU
(Refer to Block Diagram)
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1983ES6-3 | 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT |
| LTC1983ES6-5 | 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT |
| LTPC | 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT |
| LTYB | 100mA REGULATED CHARGE-PUMP INVERTERS IN THINSOT |
| LTC1985-1.8 | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1983ES6-3 | 制造商:Linear Technology 功能描述:Charge Pump INV -3V/-2.3V to -5.5V 100mA 6-Pin TSOT-23 |
| LTC1983ES6-3#PBF | 制造商:Linear Technology 功能描述:Charge Pump INV -3V/-2.3V to -5.5V 100mA 6-Pin TSOT-23 制造商:Linear Technology 功能描述:IC INVERTING CHARGE PUMP CNV 6SOT23 制造商:Linear Technology 功能描述:IC, INVERTING CHARGE PUMP CNV, 6SOT23 制造商:Linear Technology 功能描述:IC, INVERTING CHARGE PUMP CONV, 6-SOT-23, Primary Input Voltage:5V, No. of Outputs:1, Output Voltage:-3V, Output Current:100mA, No. of Pins:6, Operating Temperature Min:-40C, Operating Temperature Max:85C, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-Charge Pump/General Purpose, CUT TAPE 100mA Inverting Charge Pump in ThinSOT |
| LTC1983ES6-3#TR | 功能描述:IC REG SWITCHD CAP INV -3V SOT23 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器（充電泵），反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR |
| LTC1983ES6-3#TRM | 功能描述:IC REG SWITCHD CAP INV -3V SOT23 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1983ES6-3#TRMPBF | 功能描述:IC REG SWITCHD CAP INV -3V SOT23 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色產品:BD91x Series Step-Down Regulators 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:兩者兼有 輸出數:2 輸出電壓:3.3V，0.8 V ~ 2.5 V 輸入電壓:4.5 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:1MHz 電流 - 輸出:1.5A 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:VQFN020V4040 產品目錄頁面:1373 (CN2011-ZH PDF) 其它名稱:BD9152MUV-E2TR |
發布緊急采購，3分鐘左右您將得到回復。