參數資料
型號： LTC2259CUJ-14#TRPBF
廠商： Linear Technology
文件頁數： 18/34頁
文件大小： 0K
描述： IC ADC 14BIT 80MSPS 40-QFN
產品培訓模塊： LTC2262 - Ultra Low Power High Speed ADCs
標準包裝： 2,000
位數： 14
采樣率（每秒）： 80M
數據接口： 并聯，串行，SPI
轉換器數目： 1
功率耗散（最大）： 105mW
電壓電源： 單電源
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 40-WFQFN 裸露焊盤
供應商設備封裝： 40-QFN（6x6）
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分
配用： DC890B-ND - BOARD USB DATA COLLECTION
25
226114fc
LTC2261-14
LTC2260-14/LTC2259-14
For more information www.linear.com/LTC2261-14
The digital output is decoded at the receiver by inverting
the odd bits (D1, D3, D5, D7, D9, D11, D13.) The alter-
nate bit polarity mode is independent of the digital output
randomizer—either, both or neither function can be on
at the same time. When alternate bit polarity mode is on,
the data format is offset binary and the 2’s complement
control bit has no effect. The alternate bit polarity mode is
enabledbyseriallyprogrammingmodecontrolregisterA4.
Digital Output Test Patterns
To allow in-circuit testing of the digital interface to the
A/D, there are several test modes that force the A/D data
outputs (OF, D13-D0) to known values:
All 1s: All outputs are 1
All 0s: All outputs are 0
Alternating: Outputs change from all 1s to all 0s on
alternating samples
Checkerboard:Outputschangefrom101010101010101
to 010101010101010 on alternating samples
The digital output test patterns are enabled by serially
programming mode control register A4. When enabled,
the test patterns override all other formatting modes: 2’s
complement, randomizer, alternate-bit-polarity.
Output Disable
The digital outputs may be disabled by serially program-
mingmodecontrolregisterA3.Alldigitaloutputsincluding
OFandCLKOUTaredisabled.Thehighimpedancedisabled
state is intended for long periods of inactivity—it is too
slow to multiplex a data bus between multiple converters
at full speed.
Sleep and Nap Modes
The A/D may be placed in sleep or nap modes to conserve
power. In sleep mode the entire A/D converter is powered
down,resultingin0.5mWpowerconsumption.Sleepmode
is enabled by mode control register A1 (serial program-
ming mode), or by SDI (parallel programming mode).
The amount of time required to recover from sleep mode
depends on the size of the bypass capacitors on VREF,
REFH, and REFL. For the suggested values in Figure 8,
the A/D will stabilize after 2ms.
In nap mode the A/D core is powered down while the
internal reference circuits stay active, allowing faster
wake-up than from sleep mode. Recovering from nap
mode requires at least 100 clock cycles. If the applica-
tion demands very accurate DC settling then an additional
50s should be allowed so the on-chip references can
settle from the slight temperature shift caused by the
change in supply current as the A/D leaves nap mode.
Nap mode is enabled by mode control register A1 in the
serial programming mode.
DEVICE PROGRAMMING MODES
The operating modes of the LTC2261-14 can be pro-
grammed by either a parallel interface or a simple serial
interface. The serial interface has more flexibility and
can program all available modes. The parallel interface
is more limited and can only program some of the more
commonly used modes.
Parallel Programming Mode
To use the parallel programming mode, PAR/SER should
be tied to VDD. The CS, SCK and SDI pins are binary logic
inputs that set certain operating modes. These pins can
be tied to VDD or ground, or driven by 1.8V, 2.5V or 3.3V
CMOS logic. Table 2 shows the modes set by CS, SCK
and SDI.
Table 2. Parallel Programming Mode Control Bits (PAR/SER = VDD)
PIN
DESCRIPTION
CS
Clock Duty Cycle Stabilizer Control Bit
0 = Clock Duty Cycle Stabilizer Off
1 = Clock Duty Cycle Stabilizer On
SCK
Digital Output Mode Control Bit
0 = Full-Rate CMOS Output Mode
1 = Double-Data Rate LVDS Output Mode
(3.5mA LVDS Current, Internal Termination Off)
SDI
Power Down Control Bit
0 = Normal Operation
1 = Sleep Mode
applicaTions inForMaTion
相關PDF資料
PDF描述
VE-B61-MW-F1 CONVERTER MOD DC/DC 12V 100W
MS27473T22F55SA CONN PLUG 55POS STRAIGHT W/SCKT
IDT72V251L20PF8 IC FIFO SYNC 4096X18 20NS 32QFP
D38999/24MA98SE CONN RCPT 3POS JAM NUT W/SCKT
MS3102E22-14SW CONN RCPT 19POS BOX MNT W/SCKT
相關代理商/技術參數
參數描述
LTC2259CUJ-16 制造商:LINER 制造商全稱:Linear Technology 功能描述:16-Bit, 80Msps Ultralow Power 1.8V ADC
LTC2259CUJ-16#PBF 制造商:Linear Technology 功能描述:ADC Single Pipelined 80Msps 16-bit Parallel/LVDS 40-Pin QFN EP 制造商:Linear Technology 功能描述:IC ADC 16BIT 80MSPS 40QFN 制造商:Linear Technology 功能描述:IC ADC 16BIT 80MSPS QFN-40 制造商:Linear Technology 功能描述:IC, ADC, 16BIT, 80MSPS, QFN-40; Resolution (Bits):16bit; Sampling Rate:80MSPS; Supply Voltage Type:Single; Supply Voltage Min:1.7V; Supply Voltage Max:1.9V; Supply Current:49.2mA; Digital IC Case Style:QFN; No. of Pins:40; INL :4LSB;RoHS Compliant: Yes
LTC2259CUJ-16#TRPBF 制造商:Linear Technology 功能描述:ADC Single Pipelined 80Msps 16-bit Parallel/LVDS 40-Pin QFN EP T/R 制造商:Linear Technology 功能描述:IC ADC 16BIT 80MSPS 40QFN
LTC2259CUJ-16PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:16-Bit, 80Msps Ultralow Power 1.8V ADC
LTC2259CUJ-16TRPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:16-Bit, 80Msps Ultralow Power 1.8V ADC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*