- 您現在的位置：買賣IC網 > PDF目錄10090 > LTC2370CDE-16#PBF (Linear Technology)IC ADC 16BIT SRL/SPI 2M 16-DFN PDF資料下載
參數資料
| 型號： | LTC2370CDE-16#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 6/24頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT SRL/SPI 2M 16-DFN |
| 產品培訓模塊： | LTC2369- 18-/16-bit Pseudo-Differential SAR ADC Family Overview |
| 標準包裝： | 91 |
| 位數： | 16 |
| 采樣率（每秒）： | 2M |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 22mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 16-DFN（4x3） |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個偽差分，單極 |
| 配用： | DC1813A-A-ND - BOARD SAR ADC LTC2370-16 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
LTC2370-16
14
237016fa
APPLICATIONS INFORMATION
Power Supply Sequencing
The LTC2370-16 does not have any specific power supply
sequencing requirements. Care should be taken to adhere
to the maximum voltage relationships described in the
Absolute Maximum Ratings section. The LTC2370-16
has a power-on-reset (POR) circuit that will reset the
LTC2370-16 at initial power-up or whenever the power
supply voltage drops below 1V. Once the supply voltage
re-enters the nominal supply voltage range, the POR will
reinitialize the ADC. No conversions should be initiated
until 20s after a POR event to ensure the reinitialization
period has ended. Any conversions initiated before this
time will produce invalid results.
TIMING AND CONTROL
CNV Timing
The LTC2370-16 conversion is controlled by CNV. A ris-
ing edge on CNV will start a conversion and power up the
LTC2370-16.Onceaconversionhasbeeninitiated,itcannot
berestarteduntiltheconversioniscomplete.Foroptimum
performance, CNV should be driven by a clean low jitter
signal. Converter status is indicated by the BUSY output
which remains high while the conversion is in progress.
To ensure that no errors occur in the digitized results, any
additional transitions on CNV should occur within 40ns
from the start of the conversion or after the conversion
has been completed. Once the conversion has completed,
the LTC2370-16 powers down and begins acquiring the
input signal.
Internal Conversion Clock
The LTC2370-16 has an internal clock that is trimmed to
achieveamaximumconversiontimeof322ns.Withamin-
imum acquisition time of 165ns, throughput performance
of 2Msps is guaranteed without any external adjustments.
Auto Power-Down
The LTC2370-16 automatically powers down after a
conversion has been completed and powers up once a
new conversion is initiated on the rising edge of CNV.
During power down, data from the last conversion can
be clocked out. To minimize power dissipation during
power down, disable SDO and turn off SCK. The auto
power-down feature will reduce the power dissipation of
the LTC2370-16 as the sampling frequency is reduced.
Since power is consumed only during a conversion, the
LTC2370-16remainspowereddownforalargerfractionof
the conversion cycle (tCYC) at lower sample rates, thereby
reducing the average power dissipation which scales with
the sampling rate as shown in Figure 9.
DIGITAL INTERFACE
The LTC2370-16 has a serial digital interface. The flexible
OVDD supply allows the LTC2370-16 to communicate with
any digital logic operating between 1.8V and 5V, including
2.5V and 3.3V systems.
The serial output data is clocked out on the SDO pin when
anexternalclockisappliedtotheSCKpinifSDOisenabled.
Clocking out the data after the conversion will yield the
best performance. With a shift clock frequency of at least
100MHz, a 2Msps throughput is still achieved. The serial
output data changes state on the rising edge of SCK and
can be captured on the falling edge or next rising edge of
SCK. D15 remains valid till the first rising edge of SCK.
The serial interface on the LTC2370-16 is simple and
straightforwardtouse.Thefollowingsectionsdescribethe
operation of the LTC2370-16. Several modes are provided
depending on whether a single or multiple ADCs share the
SPI bus or are daisy chained.
Figure 9. Power Supply Current of the LTC2370-16
Versus Sampling Rate
SAMPLING RATE (kHz)
0
POWER
SUPPLY
CURRENT
(mA)
4
6
2000
1600
237016 F09
2
0
400
800
1200
8
3
5
1
7
IVDD
IREF
IOVDD
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1386IS | IC TXRX 3.3V EIA/TIA-562 16-SOIC |
| LTC1383IS | IC TXRX 5V RS232 LOW PWR 16-SOIC |
| MS27466T13F98P | CONN RCPT 10POS WALL MT W/PINS |
| LTC2378CMS-18#PBF | IC ADC 18BIT 1MSPS 16-MSOP |
| LTC1383IN | IC TXRX 5V RS232 LOW PWR 16-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2370CMS-16 | 制造商:Linear Technology 功能描述:ADC 16BIT SRL/SPI 2M 16MSOP 制造商:Linear Technology 功能描述:ADC, 16BIT, SRL/SPI, 2M, 16MSOP |
| LTC2370CMS-16#PBF | 功能描述:IC ADC 16BIT SRL/SPI 2M 16-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC2370CMS-16#TRPBF | 功能描述:IC ADC 16BIT SRL/SPI 2M 16-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC2370HMS-16#PBF | 功能描述:IC ADC 16BIT SRL/SPI 2M 16-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2370HMS-16#TRPBF | 功能描述:IC ADC 16BIT SRL/SPI 2M 16-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。