- 您現在的位置：買賣IC網 > PDF目錄377769 > LTC2408I (Linear Technology Corporation) 20-Bit Universal Bus Driver With 3-State Outputs 56-TVSOP -40 to 85 PDF資料下載
參數資料
| 型號： | LTC2408I |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 20-Bit Universal Bus Driver With 3-State Outputs 56-TVSOP -40 to 85 |
| 中文描述： | 4-/8-Channel 24位ADC的無延遲uPower |
| 文件頁數： | 20/36頁 |
| 文件大?。?/td> | 351K |
| 代理商： | LTC2408I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
20
LTC2404/LTC2408
APPLICATIO
S I
N
FOR
ATIO
U
W
U
SCKCLK
SDO
D
IN
CSADC
CSMUX
t
EOCtest
MSB
SUB
LSB
SUB
LSB
SUB
LSB
SUB
LSB
EXR
SIG
BIT0
LSB
BIT4 BIT3 BIT2 BIT1
BIT27BIT26
BIT28
BIT29
BIT30
BIT31
24048 F10
TEST EOC
DON’T CARE
DON’T CARE
EN
D2
D1
D0
HI-Z
HI-Z
HI-Z
TEST EOC
TEST EOC
V
CC
CS
10k
F
O
V
REF
CSMUX
CSADC
SCK
CLK
MUXOUT
ADCIN
D
IN
SDO
GND
0.1V
TO V
CC
–0.12V
REF
TO 1.12V
REF
CH0
TO CH7
2.7V TO 5.5V
LTC2404/LTC2408
= 50Hz REJECTION
= EXTERNAL OSCILLATOR
= 60Hz REJECTION
V
CC
Figure 10. Internal Serial Clock Timing Diagram
state. The internal serial clock (SCK) generated by the ADC
is applied to the multiplexer clock input (CLK).
In order to select the internal serial clock timing mode, the
serial clock pin (SCK) must be floating (HI-Z) or pulled
HIGH prior to the falling edge of CSADC. The device will not
enter the internal serial clock mode if SCK is driven LOW
on the falling edge of CSADC. An internal weak pull-up
resistor is active on the SCK pin during the falling edge of
CSADC; therefore, the internal serial clock timing mode is
automatically selected if SCK is not externally driven.
The serial data output pin (SDO) is HI-Z as long as CSADC
is HIGH. At any time during the conversion cycle, CSADC
may be pulled LOW in order to monitor the state of the
converter. Once CSADC is pulled LOW, SCK goes LOW
and EOC is output to the SDO pin. EOC = 1 while a
conversion is in progress and EOC = 0 if the device is in the
sleep state.
When testing EOC, if the conversion is complete (EOC = 0),
the device will exit the sleep state and enter the data output
state if CSADC remains LOW. In order to prevent the
device from exiting the low power sleep state, CSADC
must be pulled HIGH before the first rising edge of SCK. In
the internal SCK timing mode, SCK goes HIGH and the
device begins outputting data at time t
EOCtest
after the
falling edge of CSADC (if EOC = 0) or t
EOCtest
after EOC
goes LOW (if CSADC is LOW during the falling edge of
EOC). The value of t
EOCtest
is 23
μ
s if the device is using its
internal oscillator (F
0
= logic LOW or HIGH). If F
O
is driven
by an external oscillator of frequency f
EOSC
, then t
EOCtest
is
3.6/f
EOSC
. If CSADC is pulled HIGH before time t
EOCtest
, the
device remains in the sleep state. The conversion result is
held in the internal static shift register.
If CSADC remains LOW longer than t
EOCtest
, the first rising
edge of SCK will occur and the conversion result is serially
shifted out of the SDO pin. The data output cycle begins on
this first rising edge of SCK and concludes after the 32nd
rising edge. Data is shifted out the SDO pin on each falling
edge of SCK. The internally generated serial clock is output
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2408IG | 4-/8-Channel 24-Bit uPower No Latency ADCs |
| LTC2410CGN | 20-Bit Universal Bus Driver With 3-State Outputs 56-SSOP -40 to 85 |
| LTC2410IGN | 24-Bit No Latency ADC with Differential Input and Differential Reference |
| LTC2410 | 20-Bit Universal Bus Driver With 3-State Outputs 56-SSOP -40 to 85 |
| LTC2410C | 20-Bit Universal Bus Driver With 3-State Outputs 56-TVSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2408IG | 功能描述:IC CONN 24BIT 8CHANNEL 28-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2408IG#PBF | 功能描述:IC A/D CONV 24BIT 8-CHAN 28-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2408IG#TR | 功能描述:IC ADC 24BIT 8CH MICROPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2408IG#TRPBF | 功能描述:IC A/D CONV 24BIT 8-CHAN 28-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2410CGN | 功能描述:IC ADC 24BIT DIFF INP/REF 16SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發布緊急采購，3分鐘左右您將得到回復。