The combined effect of the internal sinc" />
參數資料
型號： LTC2413IGN#TRPBF
廠商： Linear Technology
文件頁數： 26/44頁
文件大小： 0K
描述： IC A/D CONV 24BIT MICRPWR 16SSOP
標準包裝： 2,500
位數： 24
采樣率（每秒）： 6.8
數據接口： MICROWIRE?，串行，SPI?
轉換器數目： 2
功率耗散（最大）： 1mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-SSOP（0.154"，3.90mm 寬）
供應商設備封裝： 16-SSOP
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分，雙極
LTC2413
32
sn2413 2413fs
APPLICATIO S I FOR ATIO
WU
U
Input Bandwidth
The combined effect of the internal sinc4 digital filter and
of the analog and digital autocalibration circuits deter-
mines the LTC2413 input bandwidth. When the internal
oscillator is used (FO = LOW), the 3dB input bandwidth is
3.3Hz. If an external conversion clock generator of fre-
quency fEOSC is connected to the FO pin, the 3dB input
bandwidth is 0.236 10–6 fEOSC.
Due to the complex filtering and calibration algorithms
utilized, the converter input bandwidth is not modeled very
accurately by a first order filter with the pole located at the
3dB frequency. When the internal oscillator is used, the
shape of the LTC2413 input bandwidth is shown in
Figure 36. When an external oscillator of frequency fEOSC
is used, the shape of the LTC2413 input bandwidth can be
derived from Figure 36, in which the horizontal axis is
scaled by fEOSC/139800.
The conversion noise (800nVRMS typical for VREF = 5V)
can be modeled as a white noise source connected to a
noise free converter. The noise spectral density is 63nV/
√Hz
for an infinite bandwidth source and 77nV/
√Hz for a single
0.5MHz pole source. From these numbers, it is clear that
particular attention must be given to the design of external
amplification circuits. Such circuits face the simultaneous
requirements of very low bandwidth (just a few Hz) in
order to reduce the output referred noise and relatively
high bandwidth (at least 500kHz) necessary to drive the
input switched-capacitor network. A possible solution is a
Figure 36. Input Signal Bandwidth Using the Internal Oscillator
DIFFERENTIAL INPUT SIGNAL FREQUENCY (Hz)
0
0.5
1
1.5
2
2.5
3
3.5
4
4.5
5
INPUT
SIGNAL
ATTENUATION
(dB)
2413 F36
0.0
–0.5
–1.0
–1.5
–2.0
–2.5
–3.0
–3.5
–4.0
–4.5
–5.0
–5.5
–6.0
high gain, low bandwidth amplifier stage followed by a
high bandwidth unity-gain buffer.
When external amplifiers are driving the LTC2413, the
ADC input referred system noise calculation can be simpli-
fied by Figure 37. The noise of an amplifier driving the
LTC2413 input pin can be modeled as a band limited white
noise source. Its bandwidth can be approximated by the
bandwidth of a single pole lowpass filter with a corner
frequency fi. The amplifier noise spectral density is ni.
From Figure 37, using fi as the x-axis selector, we can find
on the y-axis the noise equivalent bandwidth freqi of the
input driving amplifier. This bandwidth includes the band
limiting effects of the ADC internal calibration and filtering.
The noise of the driving amplifier referred to the converter
input and including all these effects can be calculated as
N = ni √freqi. The total system noise (referred to the
LTC2413 input) can now be obtained by summing as
square root of sum of squares the three ADC input referred
noise sources: the LTC2413 internal noise (800nV), the
noise of the IN+ driving amplifier and the noise of the IN–
driving amplifier.
If the FO pin is driven by an external oscillator of frequency
fEOSC, Figure 37 can still be used for noise calculation if the
x-axis is scaled by fEOSC/139800. For large values of the
ratio fEOSC/139800, the Figure 37 plot accuracy begins to
decrease, but in the same time the LTC2413 noise floor
rises and the noise contribution of the driving amplifiers
lose significance.
1
10
0.1
100
1000
INPUT NOISE SOURCE SINGLE POLE
EQUIVALENT BANDWIDTH (Hz)
INPUT
REFERRED
NOISE
EQUIVALENT
BANDWIDTH
(Hz)
0.1
1
10
100
1k
10k
100k
1M
2413 F37
FO = LOW
Figure 37. Input Referred Noise Equivalent Bandwidth
of an Input Connected White Noise Source
相關PDF資料
PDF描述
LTC2415-1IGN#TRPBF IC ADC 24BIT DIFFINPUT/REF16SSOP
LTC2436-1IGN#TRPBF IC CONV A/D 16B 2CH DIFF 16SSOP
LTC2439-1IGN#TRPBF IC ADC 16BIT 16CH MCRPWR 28SSOP
LTC2440IGN#TRPBF IC ADC DIFFER 24-BIT HS 16-SSOP
LTC2450IDC-1#TRPBF IC ADC 16BIT DELTA SIG 6-DFN
相關代理商/技術參數
參數描述
LTC2414CGN 功能描述:IC ADC 8CH 24BIT DIFFINPUT28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2414CGN#PBF 功能描述:IC ADC 8CH 24BIT DIFFINPUT28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2414CGN#PBF 制造商:Linear Technology 功能描述:IC ADC 24BIT SSOP-28
LTC2414CGN#TR 功能描述:IC ADC 8CH 24BIT DIFFINPUT28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2414CGN#TRPBF 功能描述:IC ADC 8CH 24BIT DIFFINPUT28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*