common mode r" />
參數資料
型號: LTC2481CDD#TRPBF
廠商: Linear Technology
文件頁數: 15/40頁
文件大小: 0K
描述: IC ADC 16BIT I2C 10-DFN
標準包裝: 2,500
位數: 16
采樣率(每秒): 7.5
數據接口: I²C,串行,SPI?
轉換器數目: 1
功率耗散(最大): 480µW
電壓電源: 單電源
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 10-WFDFN 裸露焊盤
供應商設備封裝: 10-DFN(3x3)
包裝: 帶卷 (TR)
輸入數目和類型: 2 個單端,雙極;1 個差分,雙極
配用: DC951A-ND - BOARD DELTA SIGMA ADC LTC2481
LTC2481
22
2481fc
APPLICATIONS INFORMATION
Input Voltage Range
The analog input is truly differential with an absolute/
common mode range for the IN+ and INinput pins
extending from GND – 0.3V to VCC + 0.3V. Outside these
limits, the ESD protection devices begin to turn on and the
errors due to input leakage current increase rapidly. Within
these limits, the LTC2481 converts the bipolar differential
input signal, VIN = IN+ – IN, from –FS to +FS where FS = 0.5
VREF/GAIN. Beyond this range, the converter indicates the
overrange or the underrange condition using distinct output
codes. Since the differential input current cancellation does
not rely on an on-chip buffer, current cancellation as well
as DC performance is maintained rail-to-rail.
Input signals applied to IN+ and INpins may extend by
300mV below ground and above VCC. In order to limit any
fault current, resistors of up to 5k may be added in series
with the IN+ and INpins without affecting the performance
of the devices. The effect of the series resistance on the
converter accuracy can be evaluated from the curves
presented in the Input Current/Reference Current sections.
In addition, series resistors will introduce a temperature
dependent offset error due to the input leakage current.
A 1nA input leakage current will develop a 1ppm offset
error on a 5k resistor if VREF = 5V. This error has a very
strong temperature dependency.
Driving the Input and Reference
The input and reference pins of the LTC2481 converter
are directly connected to a network of sampling capaci-
tors. Depending upon the relation between the differential
input voltage and the differential reference voltage, these
capacitors are switching between these four pins transfer-
ring small amounts of charge in the process. A simplied
equivalent circuit is shown in Figure 12.
For a simple approximation, the source impedance RS
driving an analog input pin (IN+, IN, REF+ or REF) can be
considered to form, together with RSW and CEQ (see Fig-
ure 12), a rst order passive network with a time constant
τ = (RS + RSW) CEQ. The converter is able to sample the
input signal with better than 1ppm accuracy if the sampling
period is at least 14 times greater than the input circuit time
constant
τ. The sampling process on the four input analog
pins is quasi-independent so each time constant should be
considered by itself and, under worst-case circumstances,
the errors may add.
When using the internal oscillator, the LTC2481’s front-end
switched-capacitor network is clocked at 123kHz corre-
sponding to an 8.1μs sampling period. Thus, for settling
errors of less than 1ppm, the driving source impedance
should be chosen such that
τ≤8.1μs/14=580ns.Whenan
external oscillator of frequency fEOSC is used, the sampling
period is 2.5/fEOSC and, for a settling error of less than
1ppm,
τ ≤ 0.178/fEOSC.
VREF
+
VIN
+
VCC
RSW (TYP)
10k
ILEAK
VCC
ILEAK
VCC
RSW (TYP)
10k
CEQ
12pF
(TYP)
RSW (TYP)
10k
ILEAK
IIN
+
VIN
IIN
IREF
+
IREF
2481 F12
ILEAK
VCC
ILEAK
SWITCHING FREQUENCY
fSW = 123kHz INTERNAL OSCILLATOR
fSW = 0.4 fEOSC EXTERNAL OSCILLATOR
VREF
RSW (TYP)
10k
IIN
I IN
VV
R
I REF
VV
V
R
V
VR
VD
R
VV
V
R
V
VR
where
AVG
IN CM
REF CM
EQ
AVG
REF
INCM
REFCM
EQ
IN
REF
EQ
REF
T
EQ
REF
REF CM
IN CM
EQ
IN
REF
EQ
REF
REF
()
.
.–
.
05
15
05
15
05
2
:
.
V
VIN
IN
V
IN
R
MΩ INTERNAL OSCILLATOR
Hz MODE
REFCM
IN
INCM
EQ
V
, REF
REF
REF
2
271
60
R
2.98MΩ INTERNAL OSCILLATOR 50Hz AND 60Hz MODE
R
0.833 10
/ f
EXTERNAL OSCILLATOR
D IS THE DENSITY OF A DIGITAL TRANSITION AT THE MODULATOR OUTPUT
EQ
12
EOSC
T
WHERE REFIS INTERNALLY TIED TO GND
Figure 12. LTC2481 Equivalent Analog Input Circuit
相關PDF資料
PDF描述
LTC2361IS6#TRPBF IC ADC 12BIT 250KSPS TSOT23-6
VI-2NL-MX-S CONVERTER MOD DC/DC 28V 75W
AD7276AUJZ-REEL7 IC ADC 12BIT 3MSPS 6TSOT
VI-2NK-MX-S CONVERTER MOD DC/DC 40V 75W
MS27467T17B99P CONN PLUG 23POS STRAIGHT W/PINS
相關代理商/技術參數
參數描述
LTC2481HDD#PBF 功能描述:IC ADC 16BIT I2C 7.5SPS 10DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2481HDD#TRPBF 功能描述:IC ADC DELTA SIGMA 16BIT 10DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2481IDD#PBF 功能描述:IC ADC 16BIT I2C 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率(每秒):20M 數據接口:并聯 轉換器數目:2 功率耗散(最大):155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:Digi-Reel® 輸入數目和類型:4 個單端,單極;2 個差分,單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
LTC2481IDD#TRPBF 功能描述:IC ADC 16BIT I2C 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2482CDD 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP