- 您現在的位置：買賣IC網 > PDF目錄10353 > LTC2481IDD#TRPBF (Linear Technology)IC ADC 16BIT I2C 10-DFN PDF資料下載
參數資料
| 型號： | LTC2481IDD#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 14/40頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT I2C 10-DFN |
| 標準包裝： | 2,500 |
| 位數： | 16 |
| 采樣率（每秒）： | 7.5 |
| 數據接口： | I²C，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 480µW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-DFN（3x3） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
| 配用： | DC951A-ND - BOARD DELTA SIGMA ADC LTC2481 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
LTC2481
21
2481fc
APPLICATIONS INFORMATION
conversion result following POR is accurate within the
specications of the device if the power supply voltage is
restored within the operating range (2.7V to 5.5V) before
the end of the POR time interval.
On-Chip Temperature Sensor
The LTC2481 contains an on-chip PTAT (proportional to
absolute temperature) signal that can be used as a tempera-
ture sensor. The internal PTAT has a typical value of 420mV
at 27°C and is proportional to the absolute temperature
value with a temperature coefcient of 420/(27 + 273) =
1.40mV/°C (SLOPE), as shown in Figure 11. The internal
PTAT signal is used in a single-ended mode referenced to
device ground internally. The GAIN is automatically set to
one (independent of the values of GS0, GS1, GS2) in order
to preserve the PTAT property at the ADC output code
and avoid an out of range error. The 1x speed mode with
automatic offset calibration is automatically selected for
the internal PTAT signal measurement as well.
When using the internal temperature sensor, if the output
code is normalized to RSDA = VPTAT/VREF, the temperature
is calculated using the following formula:
TK =
RSDA VREF
SLOPE
in Kelvin
and
TC =
RSDA VREF
SLOPE
– 273 in
° C
where SLOPE is nominally 1.4mV/°C.
Since the PTAT signal can have an initial value variation
which results in errors in SLOPE, to achieve absolute
temperature measurements, a one-time calibration is
needed to adjust the SLOPE value. The converter output of
the PTAT signal, R0SDA,ismeasuredataknowntemperature
T0 (in °C) and the SLOPE is calculated as:
SLOPE
=
R0SDA VREF
T0
+ 273
This calibrated SLOPE can be used to calculate the tem-
perature.
If the same VREF source is used during calibration and
temperature measurement, the actual value of the VREF
is not needed to measure the temperature as shown in
the calculation below:
TC =
RSDA VREF
SLOPE
– 273
=
RSDA
R0SDA
T0
+ 273
(
)–273
Reference Voltage Range
The LTC2481 external reference voltage range is 0.1V
to VCC. The converter output noise is determined by
the thermal noise of the front-end circuits, and as such,
its value in nanovolts is nearly constant with reference
voltage. Since the transition noise (600nV) is much less
than the quantization noise (VREF/217), a decrease in the
reference voltage will increase the converter resolution. A
reduced reference voltage will also improve the converter
performance when operated with an external conversion
clock (external fO signal) at substantially higher output
data rates (see the Output Data Rate section). VREF must
be ≥1.1V to use the internal temperature sensor.
The reference input is differential. The differential reference
input range (VREF = REF+ – REF–) is 100mV to VCC and the
common mode reference input range is 0V to VCC.
Figure 11. Internal PTAT Signal vs Temperature
TEMPERATURE (°C)
–60
V
PTAT
(mV)
500
600
120
2481 F11
400
200
30
090
–30
60
300
VCC = 5V
IM = 1
SLOPE = 1.40mV/°C
相關PDF資料 |
PDF描述 |
|---|---|
| MAX98300ETA+T | IC AMP MONO CLASS D 2A 8TDFN |
| D38999/20JB98SALC | CONN HSG RCPT 6POS WALL MT SCKT |
| MAX9700CETB+T | IC AMP AUDIO 1.6W MONO D 10TDFN |
| D38999/20WH21SNLC | CONN HSG RCPT 21POS WALL MT SCKT |
| VE-JTR-MX | CONVERTER MOD DC/DC 7.5V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2482CDD | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP |
| LTC2482CDD#PBF | 功能描述:IC ADC 16BIT 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2482CDD#TR | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP T/R |
| LTC2482CDD#TRPBF | 功能描述:IC ADC 16BIT 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2482IDD | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP |
發布緊急采購，3分鐘左右您將得到回復。