- 您現在的位置：買賣IC網 > PDF目錄10694 > LTC2482CDD#PBF (Linear Technology)IC ADC 16BIT 10-DFN PDF資料下載
參數資料
| 型號： | LTC2482CDD#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 14/32頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT 10-DFN |
| 標準包裝： | 121 |
| 位數： | 16 |
| 采樣率（每秒）： | 6.8 |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 480µW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-DFN（3x3） |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 產品目錄頁面： | 1348 (CN2011-ZH PDF) |
| 配用： | DC941A-ND - BOARD DELTA SIGMA ADC LTC2482 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC2482
21
2482fc
APPLICATIONS INFORMATION
An alternate solution is to reduce the edge rate of the control
signals. It should be noted that using very slow edges will
increase the converter power supply current during the
transition time. The differential input architecture reduces
the converter’s sensitivity to ground currents.
Particular attention must be given to the connection of
the fO signal when the LTC2482 is used with an external
conversion clock. This clock is active during the conver-
sion time and the normal mode rejection provided by the
internal digital lter is not very high at this frequency. A
normal mode signal of this frequency at the converter
reference terminals can result in DC gain and INL errors.
A normal mode signal of this frequency at the converter
input terminals can result in a DC offset error. Such pertur-
bations can occur due to asymmetric capacitive coupling
between the fO signal trace and the converter input and/or
reference connection traces. An immediate solution is to
maintain maximum possible separation between the fO
signal trace and the input/reference signals. When the fO
signal is parallel terminated near the converter, substantial
AC current is owing in the loop formed by the fO con-
nection trace, the termination and the ground return path.
Thus, perturbation signals may be inductively coupled into
the converter input and/or reference. In this situation, the
user must reduce to a minimum the loop area for the fO
signal as well as the loop area for the differential input
and reference connections. Even when f0 is not driven,
other nearby signals pose similar EMI threats which will
be minimized by following good layout practices.
Driving the Input and Reference
The input and reference pins of the LTC2482 converter
are directly connected to a network of sampling capaci-
tors. Depending upon the relation between the differential
input voltage and the differential reference voltage, these
capacitors are switching between these four pins transfer-
ring small amounts of charge in the process. A simplied
equivalent circuit is shown in Figure 10.
For a simple approximation, the source impedance RS
driving an analog input pin (IN+, IN–, VREF+ or GND) can
be considered to form, together with RSW and CEQ (see
Figure 10), a rst order passive network with a time
constant
τ = (RS + RSW) CEQ. The converter is able to
sample the input signal with better than 1ppm accuracy
if the sampling period is at least 14 times greater than the
input circuit time constant
τ. The sampling process on
the four input analog pins is quasi-independent so each
time constant should be considered by itself and, under
worst-case circumstances, the errors may add.
VREF
+
VIN
+
VCC
RSW (TYP)
10k
ILEAK
VCC
ILEAK
VCC
RSW (TYP)
10k
CEQ
12pF
(TYP)
RSW (TYP)
10k
ILEAK
IIN
+
VIN
–
IIN
–
IREF
+
IREF
–
2482 F10
ILEAK
VCC
ILEAK
SWITCHING FREQUENCY
fSW = 123kHz INTERNAL OSCILLATOR
fSW = 0.4 fEOSC EXTERNAL OSCILLATOR
GND
RSW (TYP)
10k
Figure 10. LTC2482 Equivalent Analog Input Current
相關PDF資料 |
PDF描述 |
|---|---|
| LT1011IS8#TRPBF | IC VOLTAGE COMPARATOR 5V 8-SOIC |
| LT1011IS8#TR | IC COMPARATOR VOLTAGE 5V 8SOIC |
| LTC2365ITS8#TRMPBF | IC ADC 12BIT 1MSPS TSOT23-8 |
| VE-20W-IX-B1 | CONVERTER MOD DC/DC 5.5V 75W |
| LT6700HDCB-1#TRMPBF | IC COMP DUAL 400MV REF 6-DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2482IDD | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP |
| LTC2482IDD#PBF | 功能描述:IC ADC 16BIT 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2482IDD#PBF | 制造商:Linear Technology 功能描述:IC, ADC, 16BIT, DFN-10 |
| LTC2482IDD#TR | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP T/R |
| LTC2482IDD#TRPBF | 功能描述:IC ADC 16BIT 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
發布緊急采購，3分鐘左右您將得到回復。