- 您現在的位置：買賣IC網 > PDF目錄10694 > LTC2482CDD#PBF (Linear Technology)IC ADC 16BIT 10-DFN PDF資料下載
參數資料
| 型號： | LTC2482CDD#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/32頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT 10-DFN |
| 標準包裝： | 121 |
| 位數： | 16 |
| 采樣率（每秒）： | 6.8 |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 480µW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-DFN（3x3） |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 產品目錄頁面： | 1348 (CN2011-ZH PDF) |
| 配用： | DC941A-ND - BOARD DELTA SIGMA ADC LTC2482 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC2482
15
2482fc
APPLICATIONS INFORMATION
SERIAL INTERFACE TIMING MODES
The LTC2482’s 3-wire interface is SPI and MICROWIRE
compatible. This interface offers several exible modes
of operation. These include internal/external serial clock,
2- or 3-wire I/O, single cycle or continuous conversion. The
following sections describe each of these serial interface
timing modes in detail. In all these cases, the converter
can use the internal oscillator (fO = low or fO = high) or
an external oscillator connected to the fO pin. Refer to
Table 4 for a summary.
External Serial Clock, Single Cycle Operation
(SPI/MICROWIRE Compatible)
This timing mode uses an external serial clock to shift
out the conversion result and a CS signal to monitor and
control the state of the conversion cycle, see Figure 4.
The serial clock mode is selected on the falling edge of CS.
To select the external serial clock mode, the serial clock
pin (SCK) must be low during each CS falling edge.
The serial data output pin (SDO) is Hi-Z as long as CS is
high. At any time during the conversion cycle, CS may be
pulled low in order to monitor the state of the converter.
While CS is pulled low, EOC is output to the SDO pin.
EOC = 1 while a conversion is in progress and EOC = 0
if the device is in the sleep state. Independent of CS, the
device automatically enters the low power sleep state once
the conversion is complete.
When the device is in the sleep state, its conversion re-
sult is held in an internal static shift register. The device
remains in the sleep state until the rst rising edge of SCK
is seen while CS is low. The output data is shifted out of
the SDO pin on each falling edge of SCK. This enables
external circuitry to latch the output on the rising edge of
SCK. EOC can be latched on the rst rising edge of SCK
and the last bit of the conversion result can be latched
on the 24th rising edge of SCK. On the 24th falling edge
of SCK, the device begins a new conversion. SDO goes
high (EOC = 1) indicating a conversion is in progress.
In applications where the processor generates 32 clock
cycles, or to remain compatible with higher resolution
converters, the LTC2482’s digital interface will ignore extra
clock edges seen during the next conversion period after
the 24th and outputs “1” for the extra clock cycles.
At the conclusion of the data cycle, CS may remain low
and EOC monitored as an end-of-conversion interrupt.
Alternatively, CS may be driven high setting SDO to Hi-Z.
As described above, CS may be pulled low at any time in
order to monitor the conversion status.
Typically, CS remains low during the data output state.
However, the data output state may be aborted by pulling
CS high anytime between the rst rising edge and the
24th falling edge of SCK (see Figure 5). On the rising
edge of CS, the device aborts the data output state and
immediately initiates a new conversion. This is useful for
systems not requiring all 24 bits of output data, aborting
an invalid conversion cycle or synchronizing the start of
a conversion.
Table 4. LTC2482 Interface Timing Modes
CONFIGURATION
SCK SOURCE
CONVERSION CYCLE
CONTROL
DATA OUTPUT
CONTROL
CONNECTION and
WAVEFORMS
External SCK, Single Cycle Conversion
External
CS and SCK
Figures 4, 5
External SCK, 2-Wire I/O
External
SCK
Figure 6
Internal SCK, Single Cycle Conversion
Internal
CS↓
Figures 7, 8
Internal SCK, 2-Wire I/O, Continuous Conversion
Internal
Continuous
Internal
Figure 9
相關PDF資料 |
PDF描述 |
|---|---|
| LT1011IS8#TRPBF | IC VOLTAGE COMPARATOR 5V 8-SOIC |
| LT1011IS8#TR | IC COMPARATOR VOLTAGE 5V 8SOIC |
| LTC2365ITS8#TRMPBF | IC ADC 12BIT 1MSPS TSOT23-8 |
| VE-20W-IX-B1 | CONVERTER MOD DC/DC 5.5V 75W |
| LT6700HDCB-1#TRMPBF | IC COMP DUAL 400MV REF 6-DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2482IDD | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP |
| LTC2482IDD#PBF | 功能描述:IC ADC 16BIT 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2482IDD#PBF | 制造商:Linear Technology 功能描述:IC, ADC, 16BIT, DFN-10 |
| LTC2482IDD#TR | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 6.8sps 16-bit Serial 10-Pin DFN EP T/R |
| LTC2482IDD#TRPBF | 功能描述:IC ADC 16BIT 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
發布緊急采購，3分鐘左右您將得到回復。