參數資料
型號： LTC2847CUHF#TR
廠商： Linear Technology
文件頁數： 6/20頁
文件大?。?/td> 0K
描述： IC TXRX MULTIPROTOCOL 38-QFN
標準包裝： 2,500
類型： 收發器
驅動器/接收器數： 3/3
規程： 多協議
電源電壓： 5V
安裝類型： 表面貼裝
封裝/外殼： 38-WFQFN 裸露焊盤
供應商設備封裝： 38-QFN（5x7）
包裝： 帶卷 (TR)
14
LTC2847
sn2847 2847fs
Figure 28. Charge Pump
Figure 27. V.35 Receiver Configuration
Figure 26. Typical V.35 Interface
APPLICATIO S I FOR ATIO
WU
UU
In V.28 mode, S3 is closed inside the LTC2847/LTC2845
which connects a 6k (R8) impedance to ground in parallel
with 20k (R5) plus 10k (R6) for a combined impedance of
5k as shown in Figure 25. Proper termination is only pro-
vided when the B input of the receivers is floating, since S1
of the LTC2847’s R2 and R3 receivers remains on in V.28
mode1. The noninverting input is disconnected inside the
LTC2847/LTC2845 receiver and connected to a TTL level
reference voltage to give a 1.4V receiver trip point.
V.35 Interface
A typical V.35 balanced interface is shown in Figure 26. A
V.35 differential generator with outputs A and B and
ground C is connected to a differential receiver with input
A
' connected to A, input B' connected to B, and ground C'
connected via the signal return to ground C. The V.35
interface requires a T or delta network termination at the
receiver end and the generator end. The receiver differen-
tial impedance measured at the connector must be
100
±10, and the impedance between shorted termi-
nals (A
' and B') and ground (C') must be 150
±15.
A
'
B
C
B
'
C
'
GENERATOR
BALANCED
INTERCONNECTING
CABLE
LOAD
CABLE
TERMINATION
RECEIVER
2847 F26
50
125
50
50
125
50
R3
124
R5
20k
LTC2847
RECEIVER
2847 F27
A
'
B
'
C
'
R1
51.5
R8
6k
S2
S3
R2
51.5
R6
10k
R7
10k
GND
R4
20k
S1
In V.35 mode, both switches S1 and S2 inside the LTC2847
are on, connecting a T network impedance as shown in
Figure 27. The 30k input impedance of the receiver is
placed in parallel with the T network termination, but does
not affect the overall input impedance significantly.
The generator differential impedance must be 50
to
150
and the impedance between shorted terminals (A
and B) and ground (C) must be 150
±15.
No-Cable Mode
The no-cable mode (M0 = M1 = M2 = 1) is intended for
the case when the cable is disconnected from the con-
nector. The charge pump, bias circuitry, drivers and
receivers are turned off, the driver outputs are forced into
a high impedance state, and the VCC supply current to the
transceiver drops to less than 300
A while its VIN supply
current drops to less than 10
A. Note that the LTC2847’s
R2 and R3 receivers continue to be terminated by a 103
differential impedance.
Charge Pump
The LTC2847 uses an internal capacitive charge pump to
generate VDD and VEE as shown in Figure 28. A voltage
doubler generates about 8V on VDD and a voltage inverter
generates about – 7.5V on VEE. Four 1F surface mounted
tantalum or ceramic capacitors are required for C1, C2, C3
and C5. The VEE capacitor C4 should be a minimum of
3.3
F.Allcapacitorsare16Vandshouldbeplacedasclose
as possible to the LTC2847 to reduce EMI.
Receiver Fail-Safe
All LTC2847/LTC2845 receivers feature fail-safe opera-
tion in all modes. If the receiver inputs are left floating or
are shorted together by a termination resistor, the receiver
output will always be forced to a logic high.
2847 F28
C3
1
F
C5
1
F
5V
C1
1
F
C2
1
F
C4
3.3
F
LTC2847
VDD
C1+
C1–
VCC
C2+
C2–
VEE
GND
+
相關PDF資料
PDF描述
VI-BNM-MX-B1 CONVERTER MOD DC/DC 10V 75W
VE-2NM-MY CONVERTER MOD DC/DC 10V 50W
XRT83D10IWTR-F IC LIU T1/E1 SGL 28SOJ
VI-BNK-MX-B1 CONVERTER MOD DC/DC 40V 75W
MS3106A20-16S CONN PLUG 9POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
LTC2847IUHF 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
LTC2847IUHF#PBF 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1 系列:- 類型:線路收發器 驅動器/接收器數:5/3 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:Digi-Reel® 產品目錄頁面:918 (CN2011-ZH PDF) 其它名稱:296-25096-6
LTC2847IUHF#TR 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
LTC2847IUHF#TRPBF 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
LTC2850CDD#PBF 功能描述:IC TXRX RS485/RS422 8-DFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*