- 您現在的位置：買賣IC網 > PDF目錄377774 > LTC3409 (Linear Technology Corporation) 64 x 18 3.3-V asynchronous FIFO memory 56-SSOP 0 to 70 PDF資料下載
參數資料
| 型號： | LTC3409 |
| 廠商： | Linear Technology Corporation |
| 元件分類： | DRAM |
| 英文描述： | 64 x 18 3.3-V asynchronous FIFO memory 56-SSOP 0 to 70 |
| 中文描述： | 600mA的低輸入電壓降壓穩壓器x 3mm DFN封裝采用3mm |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 246K |
| 代理商： | LTC3409 |
11
LTC3409
3409f
where f = operating frequency, C
OUT
= output capacitance
and
I
L
= ripple current in the inductor. For a fixed output
voltage, the output ripple is highest at maximum input
voltage since
I
L
increases with input voltage. Aluminum
electrolytic and dry tantalum capacitors are both available
in surface mount configurations. In the case of tantalum,
it is critical that the capacitors are surge tested for use in
switching power supplies. An excellent choice is the AVX
TPS series of surface mount tantalum. These are specially
constructed and tested for low ESR so they give the lowest
ESR for a given volume. Other capacitor types include
Sanyo POSCAP, Kemet T510 and T495 series, and Sprague
593D and 595D series. Consult the manufacturer for other
specific recommendations.
Using Ceramic Input and Output Capacitors
Higher value, lower cost ceramic capacitors are now
available in smaller case sizes. Their high ripple current,
high voltage rating and low ESR make them ideal for
switching regulator applications. Because the LTC3409’s
control loop does not depend on the output capacitor’s
ESR for stable operation, ceramic capacitors can be used
to achieve very low output ripple and small circuit size.
However, care must be taken when these capacitors are
used at the input and the output. When a ceramic capacitor
is used at the input and the power is supplied by a wall
adapter through long wires, a load step at the output can
induce ringing at the input, V
IN
. At best, this ringing can
couple to the output and be mistaken as loop instability. At
worst, a sudden inrush of current through the long wires
can potentially cause a voltage spike at V
IN
, large enough
to damage the part.
When choosing the input and output ceramic capacitors,
choose the X5R or X7R dielectric formulations. These
dielectrics have the best temperature and voltage charac-
teristics of all the ceramics for a given value and size.
Output Voltage Programming
The output voltage is set by a resistive divider according
to the following formula:
V
V
R
R
OUT
=
+
0 613
.
1
1
2
The external resistive divider is connected to the output,
allowing remote voltage sensing as shown in Figure 1.
APPLICATIU
W
U
U
V
FB
V
OUT
R1
R2
3409 F01
GND
LTC3409
Figure 1
Efficiency Considerations
The efficiency of a switching regulator is equal to the
output power divided by the input power times 100%. It is
often useful to analyze individual losses to determine what
is limiting the efficiency and which change would produce
the most improvement. Efficiency can be expressed as:
Efficiency = 100% – (L1 + L2 + L3 + ...)
where L1, L2, etc. are the individual losses as a percentage
of input power.
Although all dissipative elements in the circuit produce
losses, two main sources usually account for most of the
losses in LTC3409 circuits: V
IN
quiescent current and I
2
R
losses. The V
IN
quiescent current loss dominates the
efficiency loss at very low load currents whereas the I
2
R
loss dominates the efficiency loss at medium to high load
currents. In a typical efficiency plot, the efficiency curve at
very low load currents can be misleading since the actual
power lost is of no consequence as illustrated in Figure 2.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3409EDD | 600mA Low Vin Buck Regulator in 3mm x 3mm DFN |
| LTC3411EMS | 1.25A, 4MHz, Synchronous Step-Down DC/DC Converter |
| LTC3411 | 1.25A, 4MHz, Synchronous Step-Down DC/DC Converter |
| LTC3411EDD | 1.25A, 4MHz, Synchronous Step-Down DC/DC Converter |
| LTC3413 | 3A, 2MHz Monolithic Synchronous Regulator for DDR/QDR Memory Termination |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3409A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:600mA Low VIN Buck Regulator in 3mm × 3mm DFN |
| LTC3409AEDD | 制造商:LINER 制造商全稱:Linear Technology 功能描述:600mA Low VIN Buck Regulator in 3mm × 3mm DFN |
| LTC3409AEDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC3409AEDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC3409AIDD | 制造商:LINER 制造商全稱:Linear Technology 功能描述:600mA Low VIN Buck Regulator in 3mm × 3mm DFN |
發布緊急采購，3分鐘左右您將得到回復。