- 您現在的位置：買賣IC網 > PDF目錄39424 > LTC3445EUF#TRPBF (LINEAR TECHNOLOGY CORP) 0.8 A SWITCHING REGULATOR, 1800 kHz SWITCHING FREQ-MAX, PQCC24 PDF資料下載
參數資料
| 型號： | LTC3445EUF#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.8 A SWITCHING REGULATOR, 1800 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 4 X 4 MM, LEAD FREE, PLASTIC, MO-220-WGGD, QFN-24 |
| 文件頁數： | 4/24頁 |
| 文件大?。?/td> | 470K |
| 代理商： | LTC3445EUF#TRPBF |
12
LTC3445
3445fa
OPERATIO
U
Burst Mode Operation
The LTC3445 is capable of Burst Mode operation, in which
the internal power MOSFETs operate intermittently based
on load demand.
In Burst Mode operation, the peak current of the inductor
is set to approximately 200mA regardless of the output load.
Each burst event can last from a few cycles at light loads
to almost continuous cycling with short sleep intervals at
moderate loads. In between these burst events, the power
MOSFETs and any nonessential circuitry are turned off, re-
ducing the buck regulator’s quiescent current to 6
A.Inthis
sleep state, the load current is being supplied solely from
the output capacitor. As the output voltage droops, the EA’s
output rises above the sleep threshold, signaling the BURST
comparator to trip and turn the top MOSFET on. This pro-
cess repeats at a rate that is dependent on the load demand.
Short-Circuit Protection
When the output is shorted to ground, the frequency of the
oscillator is reduced to about 300kHz. This frequency
foldback ensures that the inductor current has more time
to decay, thereby preventing current runaway. The
oscillator’s frequency will progressively increase to 1.5MHz
when VOUT rises above 0V.
Low Supply Operation
The LTC3445 will operate with input supply voltages as
low as 2.5V, but the maximum allowable output current is
reduced at this low voltage. Figure 3 shows the reduction
in the typical maximum output current as a function of
input voltage for various output voltages.
Slope Compensation and Inductor Peak Current
Slope compensation provides stability in constant fre-
quency architectures by preventing subharmonic oscilla-
tions at high duty cycles. It is accomplished internally by
adding a compensating ramp to the inductor current sig-
nal at duty cycles in excess of 40%. Normally, this results
in a reduction of maximum inductor peak current for duty
cycles >40%. However, the LTC3445 uses a patent-pend-
ing scheme that counteracts this compensating ramp,
which allows the maximum inductor peak current to re-
main unaffected throughout all duty cycles.
(refer to Figure 1)
VCC1 (V)
2.5
400
MAXIMUM
LOAD
CURRENT
(mA)
600
800
1000
3.5
4.5
3
4
5
3445 F03
1200
1400
500
700
900
1100
1300
5.5
DAC (MIN)
DAC (MAX)
Figure 3. Buck Maximum Peak Current vs VCC1
Spread Spectrum
The LTC3445 has a spread spectrum mode that can be
enabled via two register bits. In the spread spectrum
mode, the switching frequency is dithered about a center
frequency of 1.5MHz. Spread spectrum lowers noise at the
regulated output and at the input.
Figure 4 shows the noise reduction capabilities of the
LTC3445 in spread spectrum mode. The percent spread of
the frequency is controlled by two bits in register 5.
00 = 0% Spread
01 = 7.4% Spread
10 = 14.8% Spread
11 = 22.4% Spread
DAC
The buck output voltage is controlled by programming a
6-bit DAC register (REG0[5:0]) and GO bit (REG2[0]). The
output voltage range is 0.85V to 1.55V in ~15mV steps.
The DAC setting range is from 0 to 48. Any settings above
48 will default to the 48 settings value. When the desired
DAC setting is loaded, the GO bit needs to be changed from
0 to 1. Once the GO bit transition occurs, VOUT will begin
to change to the DAC setting loaded at that instant.
Slew Rate
A 2-bit register is used to control the rate of change of
VOUT between DAC settings. The slew rate is controlled
by stepping VOUT to its new setting using a series of
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3525ESC6-3#TR | 0.45 A SWITCHING REGULATOR, PDSO6 |
| LTC3525ESC6-3 | 0.45 A SWITCHING REGULATOR, PDSO6 |
| LTC3525ESC6-3#TRM | 0.45 A SWITCHING REGULATOR, PDSO6 |
| LTC3547EDDB | 0.7 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3547EDDB-1#PBF | 0.7 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3446 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic Buck Regulator with Dual VLDO Regulators |
| LTC3446EDE | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic Buck Regulator with Dual VLDO Regulators |
| LTC3446EDE#PBF | 功能描述:IC REG TRPL BCK/LINEAR 14-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LTC3446EDE#TRPBF | 功能描述:IC REG TRPL BCK/LINEAR 14-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LTC3446EDE-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic Buck Regulator with Dual VLDO Regulators |
發布緊急采購，3分鐘左右您將得到回復。