supply, (V+
參數資料
型號: LTC6601IUF-2#PBF
廠商: Linear Technology
文件頁數: 11/40頁
文件大?。?/td> 0K
描述: IC DRVR FILTER/ADC LN 20-QFN
標準包裝: 91
頻率 - 截止或中心: 27MHz
濾波器數: 3
濾波器階數: 2nd
電源電壓: 2.7 V ~ 5.25 V
安裝類型: 表面貼裝
封裝/外殼: 20-WFQFN 裸露焊盤
供應商設備封裝: 20-QFN 裸露焊盤(4x4)
包裝: 管件
產品目錄頁面: 1323 (CN2011-ZH PDF)
LTC6601-2
19
66012f
Likewise, substituting the numbers for a single 5V power
supply, (V+ = 5V, V= 0V) with VOCM = 2.5V, and R1 = R2
= 100Ω, into the above equation, the input common mode
range (VINCMR) is between the two limits:
0V ≤ VINCM ≤ 4.7V
The output common mode voltage is dened as the aver-
age of the two outputs:
VOUTCM = VOCM =
VOUT+ + VOUT–
2
The VOCM pin sets this average by an internal common
mode feedback loop which internally forces VOUT+ =
–VOUT–. The output common mode range extends from
1.1 V above Vto 1V below V+. The VOCM pin sits in the
middle of a voltage divider which sets the default mid-
supply open circuit potential.
In single supply applications, where the LTC6601 is used
to interface to an ADC, the optimal common mode input
to the ADC is often determined by the ADC’s reference. If
the ADC makes a reference available for setting the input
common mode voltage, it can be directly tied to the VOCM
pin, but must be capable of driving the input impedance of
the VOCM pin (RVOCM). This impedance can be assumed
to be connected to a mid-supply potential. If an external
reference drives the VOCM pin, it should still be bypassed
with a high quality 0.01μF or higher capacitor to a low
impedance ground plane to lter any thermal noise and
to prevent common mode signals on this pin from being
inadvertently converted to differential signals.
Noise Considerations
When comparing the LTC6601 noise to other ampliers,
be sure to compare similar specications. Competing
devices often specify noise referred to the inputs of the
amplier. The input referred voltage noise of the LTC6601-2
is 4.7nV/√Hz.
In addition to the noise generated by the amplier, the
surrounding feedback resistors also contribute noise. A
noise model is shown in Figure 5. The output spot noise
generated by both the amplier and the feedback compo-
nents is governed by the equation:
APPLICATIONS INFORMATION
eno = eni 1+
R2
R1
2
+ 2 In2 R22 +R32 1+
R2
R1
2
+ 2 enR1
R2
R1
2
+ 2enR3 1+
R2
R1
2
+ 2enR22
Substituting the equation for Johnson noise of a resistor (enR = 4kTR), and simplifying:
eno = eni 1+
R2
R1
2
+ 2 In2 R22 +R32 1+
R2
R1
2
+ 8k T R2 1+ R2
R1
+R3 1+ R2
R1
2
相關PDF資料
PDF描述
VE-21Y-IW-F4 CONVERTER MOD DC/DC 3.3V 66W
LTC1067CGN#PBF IC FILTR BLDNGBLK R-R DUAL16SSOP
LTC1067CS#PBF IC FILTR BLDNGBLK R-R DUAL16SOIC
VE-21Y-IW-F1 CONVERTER MOD DC/DC 3.3V 66W
DS72612RP100FPV IC SUPERH MPU ROMLESS 176LQFP
相關代理商/技術參數
參數描述
LTC6601IUF-2TRPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:Low Power, Low Distortion, 5MHz to 27MHz, Pin Confi gurable Filter/ADC Driver
LTC6602 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Matched, High Frequency Bandpass/Lowpass Filters
LTC6602CUF#PBF 功能描述:IC FILTER BANDPASS/LOWPASS 24QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC6602CUF#TRPBF 功能描述:IC FILTER BANDPASS/LOWPASS 24QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC6602CUF-PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Matched, High Frequency Bandpass/Lowpass Filters