- 您現在的位置：買賣IC網 > PDF目錄2007 > LTM9011CY-14#PBF (Linear Technology)IC ADC 14BIT UMODULE 140BGA PDF資料下載
參數資料
| 型號： | LTM9011CY-14#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 22/40頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 14BIT UMODULE 140BGA |
| 標準包裝： | 210 |
| 系列： | µModule® |
| 位數： | 14 |
| 采樣率（每秒）： | 125M |
| 數據接口： | Serial LVDS |
| 轉換器數目： | 8 |
| 功率耗散（最大）： | 1.33W |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 140-BFBGA |
| 供應商設備封裝： | 140-BGA（11.25x9） |
| 包裝： | 托盤 |
| 輸入數目和類型： | 8 Differential; 8 Single-Ended |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
29
9009101114fa
LTM9011-14/
LTM9010-14/LTM9009-14
applicaTions inForMaTion
Table 4. Serial Programming Mode Register Map (PAR/SER = GND)
REGISTER A0: RESET REGISTER (ADDRESS 00h)
D7
D6
D5
D4
D3
D2
D1
D0
RESET
X
Note That CSA Controls Channels 1, 4, 5 and 8, CSB Controls Channels 2, 3, 6 and 7.
Bit 7
RESET
Software Reset Bit
0 = Not Used
1 = Software Reset. All Mode Control Registers Are Reset to 00h. The ADC Is Momentarily Placed in SLEEP Mode.
After the Reset SPI Write Command Is Complete, Bit D7 Is Automatically Set Back to Zero. The Reset Register Is Write Only.
Bits 6-0
Unused, Don’t Care Bits.
REGISTER A1 (CSA): FORMAT AND POWER-DOWN REGISTER (ADDRESS 01h with CSA = GND)
D7
D6
D5
D4
D3
D2
D1
D0
DCSOFF
RAND
TWOSCOMP
SLEEP
NAP_8
NAP_5
NAP_4
NAP_1
Note That CSA Controls Channels 1, 4, 5 and 8, CSB Controls Channels 2, 3, 6 and 7.
Bit 7
DCSOFF
Clock Duty Cycle Stabilizer Bit
0 = Clock Duty Cycle Stabilizer On
1 = Clock Duty Cycle Stabilizer Off. This Is Not Recommended.
Bit 6
RAND
Data Output Randomizer Mode Control Bit
0 = Data Output Randomizer Mode Off
1 = Data Output Randomizer Mode On
Bit 5
TWOSCOMP Two’s Complement Mode Control Bit
0 = Offset Binary Data Format
1 = Two’s Complement Data Format
Bits 4-0
SLEEP: NAP_X Sleep/Nap Mode Control Bits
00000 = Normal Operation
0XXX1 = Channel 1 in Nap Mode
0XX1X = Channel 4 in Nap Mode
0X1XX = Channel 5 in Nap Mode
01XXX = Channel 8 in Nap Mode
1XXXX = Sleep Mode. Channels 1, 4, 5 and 8 Are Disabled
Note: Any Combination of Channels Can Be Placed in Nap Mode.
are ignored. The data transfer ends when CS is taken
high again.
The first bit of the 16-bit input word is the R/W bit. The
next seven bits are the address of the register (A6:A0).
The final eight bits are the register data (D7:D0).
If the R/W bit is low, the serial data (D7:D0) will be writ-
ten to the register set by the address bits (A6:A0). If the
R/W bit is high, data in the register set by the address
bits (A6:A0) will be read back on the SDO pin (see the
Timing Diagrams section). During a read back command
the register is not updated and data on SDI is ignored.
The SDO pin is an open-drain output that pulls to ground
with a 200 impedance. If register data is read back
through SDO, an external 2k pull-up resistor is required.
If serial data is only written and read back is not needed,
then SDO can be left floating and no pull-up resistor
is needed. Table 4 shows a map of the mode control
registers.
相關PDF資料 |
PDF描述 |
|---|---|
| LV5609LP-E | IC CLOCK DRIVER VERTICAL 24VCT |
| LV5609LP-TE-L-E | IC CLOCK DRIVER VERT VCT24 |
| M-986-2A1PL | IC TRANSCEIVER MF 2CHAN 44-PLCC |
| MAX038CWP+ | IC GEN WAVEFORM HI-FREQ 20-SOIC |
| MAX1002CAX+T | IC ADC 6BIT 60MSPS DUAL 36-SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTM9011IY-14#PBF | 功能描述:IC ADC 14BIT UMODULE 140-BGA RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:µModule® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTM9012 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad 14-Bit, 125Msps ADC with Integrated Drivers |
| LTM9012CY-AB#PBF | 功能描述:IC ADC 14BIT 125MSPS 221-BGA RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:µModule® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTM9012IY-AB#PBF | 功能描述:IC ADC 14BIT 125MSPS 221-BGA RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:µModule® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:250 系列:- 位數:12 采樣率（每秒）:1.8M 數據接口:并聯 轉換器數目:1 功率耗散（最大）:1.82W 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-LQFP 供應商設備封裝:48-LQFP（7x7） 包裝:管件 輸入數目和類型:2 個單端，單極 |
| LTM9013 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:300MHz Digital Predistortion Receiver |
發布緊急采購，3分鐘左右您將得到回復。