- 您現在的位置：買賣IC網 > PDF目錄367614 > LUCW3020CCS-DB GSM Multiband RF Transceiver PDF資料下載
參數資料
| 型號： | LUCW3020CCS-DB |
| 英文描述： | GSM Multiband RF Transceiver |
| 中文描述： | 手機多頻段射頻收發器 |
| 文件頁數： | 31/44頁 |
| 文件大?。?/td> | 409K |
| 代理商： | LUCW3020CCS-DB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
Advance Data Sheet
December 1999
W3020 GSM Multiband RF Transceiver
Lucent Technologies Inc.
31
Programming Information
(continued
)
Filter Tune and dc Offset Correction Timing
Low-Pass Filter Tuning
The W3020 has an internal calibration to improve the accuracy of the low-pass filter bandwidth. The filter tune
operation should be performed each time supply voltage is applied to the device and after restart.
The low-pass filter tuning operation is controlled by 3 bits in the control logic:
n
FTR: filter tune request, in the TR register
n
C4: low-pass filter bandwidth, in the CONFIG register
n
C6: filter tune disable, in the CONFIG register
f the filter tune disable bit (C6) is programmed high, the filter bandwidth is set to the programmed (nominal)
value (see Table 35), and any request for filter tuning from the FTR bit is ignored.
The accuracy of the filter bandwidth can be improved by performing a filter tune calibration. A filter tune can be
performed by setting the filter tune request (FTR) bit in the TR register high and the filter tune disable bit (C6) in
the CONFIG register low. This enables a 13/4 MHz (3.25 MHz) clock to the filter tuning state machine, which
then runs until the tuning is complete and the new filter tune values are stored. The filter tune operation itself
takes
16.5 cycles of the 3.25 MHz clock, or 5.1
μ
s.
The filter tune operation should be done in receive mode. The receive mode needs to be held active for at least
20
μ
s to allow for bias start-up.
The dc offset calibration, if requested, is performed after the filter tune is complete. The filter tune operation adds
5.1
μ
s to the total calibration time when requested at the same time as a dc offset calibration. If a filter tune is
requested while the MOD bits are not set to 111, only the receive bias circuitry is turned on; the rest of the
receive channel remains powered down.
相關PDF資料 |
PDF描述 |
|---|---|
| LUCW3030ACA | W3030 3 V Dual-Mode IF Cellular Receiver |
| LUCW3030ACA-DB | W3030 3 V Dual-Mode IF Cellular Receiver |
| LUM-512HMU356 | LEDディスプレイ |
| LV1000NA | Consumer IC |
| LA2746 | Consumer IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LUCW3030ACA | 制造商:AGERE 制造商全稱:AGERE 功能描述:W3030 3 V Dual-Mode IF Cellular Receiver |
| LUCW3030ACA-DB | 制造商:AGERE 制造商全稱:AGERE 功能描述:W3030 3 V Dual-Mode IF Cellular Receiver |
| LUCWCP7P-KYLY-5C8E | 制造商:OLSON 功能描述: |
| LUD-15-31X | 制造商:TDK-Lambda Corporation 功能描述:36/15W AC To DC Switching Power Supply - 85-132V/110-175V in - 12V 3A, 5V 3A out |
| LUD-15-61 | 制造商:TDK-Lambda Corporation 功能描述:48/10W AC To DC Switching Power Supply - 85-132V/110-175V in - 24V 2A, 5V 2A out |
發布緊急采購，3分鐘左右您將得到回復。