- 您現在的位置：買賣IC網 > PDF目錄180125 > M29F400FB5AN6F2 256K X 16 FLASH 5V PROM, 55 ns, PDSO48 PDF資料下載
參數資料
| 型號： | M29F400FB5AN6F2 |
| 元件分類： | PROM |
| 英文描述： | 256K X 16 FLASH 5V PROM, 55 ns, PDSO48 |
| 封裝： | 12 X 20 MM, ROHS COMPLIANT, PLASTIC, TSOP1-48 |
| 文件頁數： | 54/65頁 |
| 文件大小： | 1669K |
| 代理商： | M29F400FB5AN6F2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁
Block protection
M29FxxxFT, M29FxxxFB
58/65
Appendix C
Block protection
Block protection can be used to prevent any operation from modifying the data stored in the
Flash memory. Each Block can be protected individually. Once protected, Program and
Erase operations on the block fail to change the data.
There are three techniques that can be used to control Block Protection, these are the
Programmer technique, the In-System technique and Temporary Unprotection. Temporary
Unprotection is controlled by the Reset/Block Temporary Unprotection pin, RP; this is
described in the Signal Descriptions section.
Unlike the Command Interface of the Program/Erase Controller, the techniques for
protecting and unprotecting blocks could change between different Flash memory suppliers.
9.1
Programmer Technique
The Programmer technique uses high (VID) voltage levels on some of the bus pins. These
cannot be achieved using a standard microprocessor bus, therefore the technique is
recommended only for use in Programming Equipment.
To protect a block follow the flowchart in Figure Figure 25., Programmer Equipment Block
Protect Flowchart. During the Block Protect algorithm, the A19-A12 Address Inputs indicate
the address of the block to be protected. The block will be correctly protected only if A19-
A12 remain valid and stable, and if Chip Enable is kept Low, VIL, all along the Protect and
Verify phases.
The Chip Unprotect algorithm is used to unprotect all the memory blocks at the same time.
This algorithm can only be used if all of the blocks are protected first. To unprotect the chip
follow Figure Figure 26., Programmer Equipment Chip Unprotect Flowchart. Table Table
, Programmer Technique Bus Operations, gives a summary of each operation.
The timing on these flowcharts is critical. Care should be taken to ensure that, where a
pause is specified, it is followed as closely as possible. Do not abort the procedure before
reaching the end. Chip Unprotect can take several seconds and a user message should be
provided to show that the operation is progressing.
9.2
In-System Technique
The In-System technique requires a high voltage level on the Reset/Blocks Temporary
Unprotect pin, RP. This can be achieved without violating the maximum ratings of the
components on the microprocessor bus, therefore this technique is suitable for use after the
Flash memory has been fitted to the system.
To protect a block follow the flowchart in Figure Figure 27., In-System Block Protect
Flowchart. To unprotect the whole chip it is necessary to protect all of the blocks first, then
all the blocks can be unprotected at the same time. To unprotect the chip follow Figure
, In-System Chip Unprotect Flowchart.
The timing on these flowcharts is critical. Care should be taken to ensure that, where a
pause is specified, it is followed as closely as possible. Do not allow the microprocessor to
service interrupts that will upset the timing and do not abort the procedure before reaching
the end. Chip Unprotect can take several seconds and a user message should be provided
to show that the operation is progressing.
相關PDF資料 |
PDF描述 |
|---|---|
| M29W800B-120N5RTR | 1M X 8 FLASH 3V PROM, 120 ns, PDSO48 |
| M29W800T-150M6 | 1M X 8 FLASH 3V PROM, 150 ns, PDSO44 |
| M29W800FB9N3F | 512K X 16 FLASH 3V PROM, 90 ns, PDSO48 |
| M2CT-90A1-24ER | PUSHBUTTON SWITCH, DPST, MOMENTARY, PANEL MOUNT-THREADED |
| M2S56D30AKT-75 | 32M X 8 DDR DRAM, 0.75 ns, PDSO64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M29F400FT55M32 | 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Trays |
| M29F400FT55M3E2 | 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Trays 制造商:Micron Technology Inc 功能描述:IC FLASH 4MBIT 55NS 44SO |
| M29F400FT55M3F2 | 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Trays |
| M29F400FT55M3F2 TR | 制造商:Micron Technology Inc 功能描述:IC FLASH 4MBIT 55NS 44SO |
| M29F400FT55M3T2 | 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Trays |
發布緊急采購，3分鐘左右您將得到回復。