- 您現在的位置：買賣IC網 > PDF目錄359036 > M29W004BT55N6T (意法半導體) 4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory PDF資料下載
參數資料
| 型號： | M29W004BT55N6T |
| 廠商： | 意法半導體 |
| 英文描述： | 4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory |
| 中文描述： | 4兆位512KB的× 8，啟動塊低壓單電源閃存 |
| 文件頁數： | 18/30頁 |
| 文件大?。?/td> | 222K |
| 代理商： | M29W004BT55N6T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
AI02095
E
G
W
A0-A18
DQ0-DQ7
VALID
VALID
VCC
tVCHEL
tWHEH
tWHWL
tELWL
tAVWL
tWHGL
tWLAX
tWHDX
tAVAV
tDVWH
tWLWH
tGHWL
RB
tWHRL
Figure 7. Write AC Waveforms, W Controlled
Note:
Address are latched on the falling edge of W, Data is latched on the rising edge of W.
stop when erase is completed. After completion the
Status Register bit DQ5 returns ’1’ if there has been
an Erase Failure.
Erase Suspend (ES) Instruction.
The Block
Erase operation may be suspended by this instruc-
tion which consists of writing the command B0h
without any specific address. No Coded cycles are
required. It permits reading of data from another
block and programming in another block while an
erase operation is in progress. Erase suspend is
accepted only during the Block Erase instruction
execution. Writing this command during Erase
timeout will, in addition to suspending the erase,
terminate the timeout. The Toggle bit DQ6 stops
toggling when the P/E.C. is suspended. The Toggle
bits will stop toggling between 0.1
μ
s and 15
μ
s after
the Erase Suspend (ES) command has been writ-
ten. The device will then automatically be set to
Read Memory Array mode. When erase is sus-
pended, a Read from blocks being erased will
output DQ2 toggling and DQ6 at ’1’. A Read from
a block not being erased returns valid data. During
suspension the memory will respond only to the
Erase Resume ER and the Program PG instruc-
tions. A Program operation can be initiated during
erase suspend in one of the blocks not being
erased. It will result in both DQ2 and DQ6 toggling
when the data is being programmed. A Read/Reset
command will definitively abort erasure and result
in invalid data in the blocks being erased.
18/30
M29W004T, M29W004B
相關PDF資料 |
PDF描述 |
|---|---|
| M29W004BT55N1T | 4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory |
| M29W004BT120N6T | Dual High-Speed JFET-Input Operational Amplifier 8-SOIC |
| M29W004BT120N1T | 4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory |
| M29W004BT | Dual High-Speed JFET-Input Operational Amplifier 8-PDIP |
| M29W004BB90N6T | 4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M29W004BT70N1 | 功能描述:閃存 4M (512Kx8) 70ns RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| M29W004BT70N1T | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory |
| M29W004BT70N6T | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory |
| M29W004BT90N1T | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4 Mbit 512Kb x8, Boot Block Low Voltage Single Supply Flash Memory |
| M29W004BT90N6 | 功能描述:閃存 4M (512Kx8) 90ns RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。