- 您現在的位置：買賣IC網 > PDF目錄69009 > M30240M5-XXXFP 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | M30240M5-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件頁數： | 21/139頁 |
| 文件大?。?/td> | 1453K |
| 代理商： | M30240M5-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁
117
Mitsubishi microcomputers
M30240 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Specifications REV. G
Specifications in this manual are tentative and subject to change
Precautions
1.3 Usage Precautions
1.3.1 Precautions
1.3.1.1 A-D Converter
Connect a capacitor between: the VREF pin and the AVss pin; AVcc pin and AVss pin; and each analog
input pin and AVss pin.
Write to each bit (except bit 6) of A-D control register 0, to each bit of A-D control register 1, and to
bit 0 of A-D control register 2 when A-D conversion is stopped (before a trigger occurs). In particular,
when the VREF connection bit is changed from “0” to “1”, start A-D conversion after a lapse of 1s or
longer.
When changing A-D operation mode, select analog input pin again.
Using one-shot mode or single sweep mode
Read the corresponding A-D register after confirming the A-D conversion is finished. (It is known by A-D con-
version interrupt request bit.)
Using repeat mode, repeat sweep mode 0 or repeat sweep mode 1
Use the undivided main clock as the internal CPU clock.
1.3.1.2 Built-in PROM version
All built-in PROM versions
High voltage is required to program to the built-in PROM. Be careful not to apply excessive voltage. Be espe-
cially careful during power-on.
One Time PROM version
One Time PROM versions shipped in blank, of which built-in PROMs are programmed by users, are also pro-
vided. For these microcomputers, a programming test and screening are not performed in the assembly pro-
cess and the following processes. To improve their reliability after programming, we recommend to program
and test as flow shown in Figure 1.114 before use.
Wiring for the Vpp pin of the One-Time PROM version should be as follows (Vpp pin is also used as the CNVss
pin):
Make the length of wiring between the Vpp pin and Vss pin or Vcc pin the shortest possible.
When the wiring length has to be longer, connect an approximately 5K ohm resistor in series from the Vpp
pin to the Vss pin or Vcc pin with the shortest possible wiring. This is because the Vpp pin is the power
source input pin for the built-in PROM. When programming in the built-in PROM, the impedance of the Vpp
pin is low to allow the electric current for wiring flow into the PROM. Because of this, noise can enter easily.
If noise enters the Vpp pin, abnormal instruction codes or data are read from the built-in PROM which may
cause a program runaway.
Figure 1.114: Programming and test flow for One-time PROM (OTP) version
Programming with PROM programmer
Screening (Note)
(Leave at 150 C for 40 hours)
Verify test PROM programmer
Function check in target device
Note: Never expose to 150 C exceeding 100 hours.
相關PDF資料 |
PDF描述 |
|---|---|
| M30240M6-XXXXFP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240ECFP | 16-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M5-XXXXFP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M6-XXXXFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
| M30240ECFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M30240M6 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M6-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M7 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M7-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M8 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。