參數(shù)資料
型號: M30240M5-XXXFP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
封裝: 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數(shù): 83/139頁
文件大?。?/td> 1453K
代理商: M30240M5-XXXFP
48
Mitsubishi microcomputers
M30240 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Specifications REV. G
Specifications in this manual are tentative and subject to change
Universal Serial Bus
1.2.18.4.4 USB Power Management Register
The USB Power Management Register, shown in Figure 1.33, is used for power management in the USB
FCU.
SUSPEND Detection Flag:
When the USB FCU does not detect any bus activity on D+/D- for at least 3ms (and D+/D- are in the J-state),
it sets the Suspend Detection Flag and generates an interrupt. This bit is cleared when signaling from the host
is detected on D+/D- (which sets the Resume Detection Flag and generates an interrupt), or the Remote
Wake-up Bit is set and then cleared by the CPU. If the USB clock was disabled during the suspend state, the
SUSPEND Detection Flag is not cleared until after the USB clock is re-enabled.
RESUME Detection Flag:
When the USB FCU is in the suspend state and detects activity on D+/D- from the host, it sets the Resume
Detection Flag and generates an interrupt. The CPU writes a “1” to INTST14 (bit 6 of USB Interrupt Status
Register 2) to clear this flag.
WAKEUP Control Bit:
The CPU writes a “1” to the WAKEUP Control Bit for remote wake-up. While this bit is set and the USB FCU
is in suspend mode, resume signaling is sent to the host. The CPU must keep this bit set for a minimum of
10ms and a maximum of 15ms before writing a “0” to this bit.
Figure 1.33: USB Power Management Register
USB Power Management Register
Symbol
Address
When reset
USBPM
030116
0016
Bit name
Bit symbol
b7
b6
b5
b4
b3
b2
b1
b0
Function
W
R
Reserved
Must always be set to "0"
SUSPEND
RESUME
WAKEUP
USB Suspend Detection Flag
USB Resume Detection Flag
USB Remote Wakeup Bit
0 : No USB suspend signal detected
1 : USB suspend signal detected
0 : No USB resume signal detected
1 : USB resume signal detected
0 : End remote resume signaling
1 : Remote resume signaling (Note 2)
Note 1: Write "0" only or Read
Note 2: If SUSPEND = "1"
Note 1
0 0 0 0 0
相關PDF資料
PDF描述
M30240M6-XXXXFP 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M30240ECFP 16-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PQFP80
M30240M5-XXXXFP 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M30240M6-XXXXFP 16-BIT, OTPROM, MICROCONTROLLER, PQFP80
M30240ECFP 16-BIT, OTPROM, MICROCONTROLLER, PQFP80
相關代理商/技術參數(shù)
參數(shù)描述
M30240M6 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30240M6-XXXFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30240M7 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30240M7-XXXFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30240M8 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER