- 您現在的位置：買賣IC網 > PDF目錄69010 > M34506E4FP 4-BIT, OTPROM, MICROCONTROLLER, PDSO20 PDF資料下載
參數資料
| 型號： | M34506E4FP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, OTPROM, MICROCONTROLLER, PDSO20 |
| 封裝： | 5.30 X 12.60 MM, 1.27 MM PITCH, PLASTIC, SOP-20 |
| 文件頁數： | 52/114頁 |
| 文件大?。?/td> | 937K |
| 代理商： | M34506E4FP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁當前第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
Rev.2.00
Aug 28, 2006
page 38 of 119
7643 Group
REJ03B0054-0200
(1) Cycle Steal Transfer Mode
When the DMAC Channel x (x = 0, 1) Transfer Mode Selection Bit
(DxTMS) is set to “0”, the respective DMAC Channel x operates in
the cycle steal transfer mode.
When a request of the specified transfer factor is generated, the
selected channel transfers one byte of data from the address indi-
cated by the Source Register into the address indicated by the
Destination Register.
There are two kinds of DMA transfer triggers supported: hardware
transfer factor and software trigger. Hardware transfer factors can
be selected by the DMACx (x = 0, 1) Hardware Transfer Request
source Bit (DxHR). To only use the Interrupt Request Bit, the inter-
rupt can be disabled by setting its Interrupt Enable Bit of Interrupt
Control Register to “0”.
The DMA transfer request as a software trigger can be generated
by setting the DMA Channel x (x = 0, 1) Software Transfer Trigger
Bit (DxSWT) to “1”.
The Source Registers and Transfer Destination Registers can be
either decreased or increased by 1 after transfer completion by
setting bits 0 to 3 in the DMAC Channel x (x = 0, 1) Mode Regis-
ter. When the Transfer Count Register underflows, the Source
Registers and Destination Registers are reloaded from their
latches if the DMAC Register Reload Disable Bit (DRLDD) is “0”.
The Transfer Count Register value is reloaded after an underflow
regardless of DRLDD setting. At the same time, the DMAC Inter-
rupt Request Bit and the DMA Channel x (x = 0, 1) Count Register
Underflow Flag are set to “1”.
The DMAC Channel x Disable After Count Register Underflow En-
able Bit (DxDAUE) is “1”, the DMAC Channel x Enable Bit
(DxCEN) goes to “0” at an under flows of Transfer Count Register.
By setting the DMAC Channel x (x = 0, 1) Register Reload Bit
(DxRLD) to “1”, the Source Registers, Destination Registers, and
Transfer Count Registers can be updated to the values in their re-
spective latches.
相關PDF資料 |
PDF描述 |
|---|---|
| M34508G4HFP | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO20 |
| M34508G4GP | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO20 |
| M34508G4H-XXXFP | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO20 |
| M34508G4-XXXFP | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO20 |
| M34508G4FP | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34506M2 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34506M2-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:4-BIT CISC SINGLE-CHIP MICROCOMPUTER 4500 SERIES |
| M34506M4 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34506M4-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:4-BIT CISC SINGLE-CHIP MICROCOMPUTER 4500 SERIES |
| M34507E4FP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。