參數資料
型號: M38073M4-XXXFP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
封裝: 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數: 32/74頁
文件大小: 1182K
代理商: M38073M4-XXXFP
38
MITSUBISHI MICROCOMPUTERS
3807 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
(2) Asynchronous Serial I/O (UART) Mode
Asynchronous serial I/O1 mode (UART) can be selected by clear-
ing the Serial I/O1 mode selection bit (b6) of the Serial I/O1 control
register to "0." Eight serial data transfer formats can be selected
and the transfer formats used by a transmitter and receiver must
be identical.
The transmit and receive shift registers each have a buffer (the two
buffers have the same address in memory). Since the shift register
cannot be written to or read from directly, transmit data is written to
the transmit buffer, and receive data is read from the receive buffer.
The transmit buffer can also hold the next data to be transmitted,
and the receive buffer can hold a character while the next charac-
ter is being received.
f(XIN)
1/4
OE
PE FE
1/16
Data bus
Receive buffer register
Address 001816
Receive shift register
Receive buffer full flag (RBF)
Receive interrupt request (RI)
Baud rate generator
Division ratio 1/(n+1)
Address 001C16
ST/SP/PA generator
Transmit buffer register
Data bus
Transmit shift register
Address 001816
Transmit shift register shift
completion flag (TSC)
Transmit buffer empty flag (TBE)
Transmit interrupt request (TI)
Address 001916
STdetector
SP detector
UART control register
Address 001B16
Character length selection bit
Address 001A16
BRG count source selection bit
Transmit interrupt source selection bit
Serial I/O1 synchronous clock
selection bit
Clock control circuit
Character length selection bit
7 bit
8 bit
(f(XCIN) in low-speed mode)
Serial I/O1 control register
P46/SCLK1
Serial I/O1 status register
P44/RXD
P45/TXD
Fig. 35. Block diagram of UART serial I/O1
TSC=0
TBE=1
RBF=0
TBE=0
RBF=1
ST
D0
D1
SP
D0
D1
ST
SP
TBE=1
TSC=1*
ST
D0
D1
SP
D0
D1
ST
SP
Transmit or receive clock
Write-in signal to
transmit buffer register
Serial output TXD
Read-out signal from
receive buffer register
Serial input RXD
* Generated at 2nd bit in 2-stop bit mode
1 start bit
7 or 8 data bit
1 or 0 parity bit
1 or 2 stop bit
1: Error flag detection occurs at the same time that the RBF flag becomes "1" (at 1st stop bit, during reception).
2: The transmit interrupt (TI) can be selected to occur when either the TBE or TSC flag becomes "1", depending on the setting of the transmit interrupt
source selection bit (TIC) of the serial I/O1 control register.
3: The receive interrupt (RI) is set when the RBF flag becomes "1".
4: After data is written to the transmit buffer register when TSC=1, 0.5 to 1,5 cycles of the data shift cycle is necessary until changing to TSC=0.
Notes
Fig. 36. Operation of UART serial I/O1 function
相關PDF資料
PDF描述
M38073E4-XXXFP 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP80
M38102E5SP 8-BIT, OTPROM, 4.19 MHz, MICROCONTROLLER, PDIP64
M38102E5SS 8-BIT, UVPROM, 4.19 MHz, MICROCONTROLLER, CDIP64
M38102E5-XXXSP 8-BIT, OTPROM, 4.19 MHz, MICROCONTROLLER, PDIP64
M38102E5FP 8-BIT, OTPROM, 4.19 MHz, MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
M38078RFS 制造商:Renesas Electronics Corporation 功能描述:EMULATION MCU/8BIT CMOS EMULATION CHIP - Bulk
M3808 功能描述:電纜固定件和配件 LTRSCG 625 BLACK RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度:
M3808 BK001 制造商:Alpha Wire Company 功能描述:CBL 10COND 18AWG BLK 1000'
M3808 BK002 制造商:Alpha Wire Company 功能描述:CBL 10COND 18AWG BLK 500'
M3808 BK005 制造商:Alpha Wire Company 功能描述:CBL 10COND 18AWG BLK 100'