- 您現在的位置：買賣IC網 > PDF目錄45178 > MAX16998AAUA+ (MAXIM INTEGRATED PRODUCTS INC) 1 TIMER(S), PROGRAMMABLE TIMER, PDSO8 PDF資料下載
參數資料
| 型號： | MAX16998AAUA+ |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 時鐘/數據恢復及定時提取 |
| 英文描述： | 1 TIMER(S), PROGRAMMABLE TIMER, PDSO8 |
| 封裝： | 3 X 3 MM, ROHS COMPLIANT, MO-187-AA, MICRO MAX PACKAGE-8 |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 146K |
| 代理商： | MAX16998AAUA+ |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
RESETIN Input (MAX16998A/B/D)
The MAX16998A/B/D monitor the voltage at RESETIN
using an adjustable reset threshold, set with an external
resistive divider (see Figure 7). RESET asserts when
VRESETIN is below 1.235V.
Use the following equations to calculate the externally
monitored voltage (VCC).
where VTH is the desired reset threshold voltage, and
VPON = 1.235V. To simplify the resistor selection,
choose a value for R2 (< than 1M) and calculate R1.
EN Input
The MAX16997A provides a high-impedance input (EN)
to the enable comparator. Based on the voltage level at
EN, the watchdog timer is turned on or off. The watch-
dog timer starts timing if the voltage level at EN is high-
er than a preset threshold voltage (VPON). Each time
the voltage at EN rises from below to above the preset
threshold voltage, the initial watchdog timeout period is
8 times the normal watchdog timeout period (tWP).
Watchdog Timer
MAX16997A
The watchdog circuit monitors the C’s activity. For the
MAX16997A, the watchdog timer starts timing once the
voltage at EN is higher than a preset threshold voltage.
ENABLE asserts if three consecutive watchdog timeout
periods have elapsed without a falling edge at WDI.
ENABLE remains low until three consecutive WDI falling
edges with periods shorter than the watchdog timeout
period occur.
Each time the voltage at EN rises from below to above
the preset threshold voltage, the first watchdog timeout
period extends by a factor of 8 (8 x tWP). If a WDI falling
edge occurs during that time, then the watchdog time-
out period is immediately switched over to a single tWP.
If no watchdog falling edge occurs during this pro-
longed watchdog timeout period, ENABLE goes low at
the end of this period and stays low. After this, the first
falling edge at WDI switches the watchdog timeout
period to a single tWP. See Figure 1. The MAX16997A
watchdog timeout period (tWP) is adjustable by a single
capacitor at SWT.
MAX16998A
The MAX16998A asserts RESET when two consecutive
WDI falling edges do not occur within the adjusted
watchdog timeout period (tWP). RESET remains assert-
ed for the reset timeout period (tRESET) and then goes
high. This device also asserts ENABLE if three consec-
utive watchdog timeout periods have elapsed without a
falling edge at WDI. ENABLE remains low until three
consecutive WDI falling edges with periods shorter
than the watchdog timeout period occur (see Figure 2).
The internal watchdog timer is cleared by a RESET ris-
ing edge or by a falling edge at WDI. The watchdog
timer remains cleared while RESET is asserted; as soon
as RESET is released, the timer starts counting. WDI
falling edges are ignored when RESET is low. If no WDI
falling edge occurs within the watchdog timeout period,
RESET immediately goes low and stays low for the
adjusted reset timeout period.
MAX16998B/D
The MAX16998B/D have a windowed watchdog timer.
The watchdog timeout period (tWP) is the sum of a
closed window period (tCW) and an open window period
(tOW). If the C issues a WDI falling edge within the open
window period, RESET stays high. Once a WDI falling
edge occurs within the closed window period, RESET
immediately goes low and stays low for the adjusted
reset timeout period (see Figure 3). If no WDI falling
edge occurs within the watchdog timeout period, RESET
immediately goes low and stays low for the adjusted
reset timeout period. The open window size is factory-set
to 50% of the watchdog timeout period for the
MAX16998B and 75% for the MAX16998D.
Figure 8 shows a WDI falling edge identified as a
good or
a
bad WDI signal edge. In case 1, the WDI falling edge
occurs within the closed window period and is considered
a
bad WDI falling edge (early fault); therefore, it asserts
RESET. Case 2 also shows another fault. In this case, no
RR
V
TH
PON
12
1
=
VV
R
TH
PON
=+
1
2
1
MAX16997/MAX16998
High-Voltage Watchdog Timers with
Adjustable Timeout Delay
______________________________________________________________________________________
11
MAX16998A/B/D
RESETIN
VIN
VCC
R1
R2
Figure 7. Setting RESETIN Voltage for the MAX16998A/B/D
相關PDF資料 |
PDF描述 |
|---|---|
| MAX16998AAUA/V+ | 1 TIMER(S), PROGRAMMABLE TIMER, PDSO8 |
| MAX6900EUT-T | 0 TIMER(S), REAL TIME CLOCK, PDSO6 |
| MAX7359EWA+ | SPECIALTY MICROPROCESSOR CIRCUIT, PBGA25 |
| MAX7391ANTP | 8 MHz, OTHER CLOCK GENERATOR, PDSO8 |
| MAX7391ANVB | 12 MHz, OTHER CLOCK GENERATOR, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX16998AAUA/V+ | 功能描述:監控電路 Watchdog Timer w/Adj Timeout Delay RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX16998AAUA/V+T | 功能描述:監控電路 Watchdog Timer w/Adj Timeout Delay RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX16998AAUA+ | 功能描述:監控電路 Watchdog Timer w/Adj Timeout Delay RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX16998AAUA+T | 功能描述:監控電路 Watchdog Timer w/Adj Timeout Delay RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX16998BAUA/V+ | 功能描述:監控電路 Watchdog Timer w/Adj Timeout Delay RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。